6. Refer to the circuit shown in Figure 14-6. Do the green indicator lamps indicate that the motor is actually running? If not, why? 7. If the green indicator lamps in question 6 do not indicate that the pump is actually running, how can the circuit be modified to indicate that the pump is actually running?

Q: State the correct terminology used to describe each of the following 1.the current drawn by a motor…

A: For the following statements, we need to provide terminology of the given statement.

Q: NO AI PLZ

A: 1. Direction of the current in paper clips and armature:  - The positive terminal is connected to…

Q: B-3–1. Obtain the equivalent viscous-friction coefficient beg of the system shown in Figure 3–30.

A:

Q: #4. ANSWER 4 AND 5 ONLY. NO ROUNDING OFF. STRICTLY HANDWRITTEN THEN BOX THE FINAL ANSWERS. RUSH PLS

A: Turn per coil = 1Conductor per slot = 2Commutator segments = 25To create a winding table for a…

Q: An engine cranks slowly. Technician A says a possible cause of the problem is low resistance in the…

A: Technician B is correct.

Q: Estimate the number of resistance of each section of a starter of 10 kW; 450 volts D.C. series…

A: We have an D.C series motor with,  KW rating = 10 KW Voltage (V) = 450 V Efficiency of motor= 78 %…

Q: What is the function of an arc chute

A: function of an arc chute

Q: 4. Referring to Figure 12-14, assume that the normally open 2M contact located between wire numbers…

A: What would happen if normally open contact 2M between 23 and 29 is welded closed and  a) The number…

Q: uestion 2 of 9 AC motor overloadding causes high current and high temperature, which causes the…

A: Overloading of an AC motor

Q: type of resistance device that can be placed in a DC motor circuit and varied to limit the speed of…

A: A variable resistor is placed i  dc circuit motor to vary and limit the speed of dc motor. This is…

Q: Question 1 A very common form of latch circuit is the simple "start-stop" relay circuit used for…

A: In control circuit ( Left diagram). When the push button start, the current from L1 going to stop…

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.