Solve show work 6.A tank has the shape of a right circular cylinder whose base is on the ground. The tank'sheight is 5 meters. The tank's radius is 4 meters. The tank has some water in it. Thedepth of the water in the tank is 3 meters. Assume that the force of gravity on one cubicmeter of water is 9800 newtons. How much work (in joules) is required to pump all thewater in the tank to its top?

Approach to solving the question:Please see attached photos for detailed solutions. Thank you,…

Answered: 6. A tank has the shape of a right…

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter15: Fluid Mechanics

Section: Chapter Questions

Problem 17CQ

See similar textbooks

Similar questions

A sump pump (used to drain water from be basement of houses built below the water table) is draining a flooded basement at rate of 0.750 L/S, with an output pressure of 3.00105N/m2 . (a) The water enters a hose with a 3.00-cm inside diameter and rises 2.50 m above the pump. What is its pressure at this point? (b) The hose goes over the foundation wall, losing 0.500 m in height and widens to 4.00 cm in diameter. What is the pressure now? You may neglect frictional losses both parts of the problem.
A garden hose with a diameter of 2.0 cm is used to fill a bucket, which has a volume of 0.10 cubic meters. It takes 1.2 minutes to fill. An adjustable nozzle is attached to the hose to decrease the diameter of the opening, which increases the speed of the water. The hose is held level to the ground at a height of 1.0 meters and the diameter is decreased until a flower bed 3.0 meters away is reached. (a) What is the volume flow rate of the through the nozzle when the diameter 2.0 cm? (b) What does is the speed of coming out of the hose? (c) What does the speed of the water coming out of the hose need to be to reach the flower bed 3.0 meters away? (d) What is be diameter of nozzle needed to reach be flower bed?
(a) Estimate the time it would take to a private swimming pool with a capacity of 80,000 L using a garden hose delivering 60 L/min. (b) How long would it take if you could divert a moderate size river, flowing at 5000 m3/s into pool?
Verigy that the SI of hpg is N/m2.
The Huka Falls on the Waikato River is one of New Zealand's most visited natural tourist attractions. On average, the river has a flow rate of about 300,000 L/s. At be gorge, the river narrows to 20-m wide and averages 20-m deep. (a) What be average speed of the river in the gorge? (b) What is the average speed of the water in the river downstream of the falls when it widens to 60 m and its depth increases to an average of 40 m?
7. A hemispherical tank of radius 6 feet is positioned so that its base is circular. How much work is required to pump water out of a tank, that is 2 feet in depth, over the top of the tank.
A tank has the shape of an inverted circular cone with height 7 m and base radius 3 m. It filled w water. Set up the integral form, don't evaluate it, for the work required to empty the tank by pumping all of the water to the top of a tank. (The density of water is 1000 kg/m³ and the acceleration due to gravity is 9.8 m/s²). 9800 7 S 9800 9800 49 9 - 49 * (7 — x)² dx 9 (7-2)²dx 49 (7 — x)² dx 7 9 [²3/10 S 49 -(7 — x)³ dx 7 9 √2/2 49 -(7 — x)² dx
3. For the hydraulic lift shown; A, Az The small piston area is 5 cm? and the large piston area is 50 cm?. The system is used to lift up a block of mass m = 300 Kg. Find the magnitude of the force F sufficient to do the work and find the work done on the block when it is lifted 120 cm.
A fuel oil tank is an upright cylinder, buried so that its circular top is 10 feet beneath ground level. The tank has a radius of 8 feet and is 24 feet high, although the current oil level is only 16 feet deep. Calculate the work required to pump all of the oil to the surface. Oil weighs 50lb/ft^3 I got the answer Work= 1331200pi lb-ft My answer is wrong including the units. I don’t know what they want.
I need help with this question.
A rectangular aquarium having a length of 3meters, a width of 1 meter, and a height of 2meters is filled to the top with water. Giventhat water has a density of 1000 kg per ?^3,find the work required to pump all of thewater over the top edge of the tank.
A tank is full of water. Find the work W required to pump the water out of the spout. (Use 9.8 m/s2 for g. Use 1000 kg/m3 as the weight density of water.) -4m | W = 1m 4m 12 m

SEE MORE QUESTIONS

Recommended textbooks for you

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

University Physics Volume 1

Physics

ISBN:

9781938168277

Author:

William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:

OpenStax - Rice University

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

University Physics Volume 1

Physics

ISBN:

9781938168277

Author:

William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:

OpenStax - Rice University

SEE MORE TEXTBOOKS