5. The pitot tube shown below is placed at a point where the velocity is 2.0 m/s. The specific gravity of the fluid is 2.0, and the upper portion of the manometer contains air. The reading h (m) on the manometer is most nearly: a. 20.0 c. 0.40 b. 10.0 d. 0.20 2.0 m/s (4=1 AIR

5. The pitot tube shown below is placed at a point where the velocity is 2.0 m/s. The specific gravity of the fluid is 2.0, and the upper portion of the manometer contains air. The reading h (m) on the manometer is most nearly: a. 20.0 c. 0.40 b. 10.0 d. 0.20 2.0 m/s (4=1 AIR

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The velocity field of a fluid v (in meters per second) has divergence div(v)(P) = 3 at the point P =…

A: The divergence of a velocity field is a scalar quantity that measures the net rate of change of the…

Q: Air For the setup shown, a manometer was attached from a tank into a pipe with liquid (SG=0.95).…

A: Given data in question Depths Oil of specific gravity 0.95 To find out Absolute pressure at A Note…

Q: The water in the pipe given in the Figure Flows uniformly in sections I and 2. 1. Pipe diameter in…

A: Given information in question Diameter 1 = 20 cm V1 = 20 m/s Diameter 2 = 4 cm Density of fluid =…

Q: Problem 4 Two tanks are connected using a manometer. Air is trapped in the right tank above the…

A: To find out the difference in Piezometric head of water between left and right tank. Where, H =…

Q: Example Problem: Venturi meter system. The venturi meter shown in figure blow carries water at 60°C.…

A: P1=PA+γWy+1.18PA-PB=γ0.46-1.18+1.25×γw1.18PA-PBγ=-0.72+1.27×1.18PA-PB9.65=-0.72+1.27×1.18PA-PB9.65=0…

Q: 2. Both a gage and a manometer are attached to a gas tank to measure its pressure. If the reading on…

Q: stion 7 enturimeter shown has an pipe diameter of 500mm and narrows to a throat diameter of 200mm.…

Q: The arrangement shown in the figure measures the velocity V of a gas of density 1 kg/m³ flowing…

A: Given data- Density of gas- ρg=1 kg/m3,fluid density ρm=1000 kg/m3,Velocity V=20 m/s, To Find- The…

Q: The pressure drop of water in a pipe is measured by a manometer using a liquid of density 2000…

A: Given data- Density of the liquid- ρm=2000 kg/m3, The difference in height h=10 cm=0.1 m, To Find-…

Q: A cylindrical tank 400 mm in diameter, discharges water through a 30 mm diamater orifice under a…

A: Given, Diameter of the cylindrical tank, D= 400mm Diameter of the orifice, d= 30mm Constant head, H=…

Q: A manometer is used to measure the pressure in a tank filled with air. The fluid has a specific…

A: given atmospheric pressure = 96 kPa S.G= 0.95 ρw=1000 kg /m3 h=65 cm=0.65 m Gauge…

Q: Two pipes namely A and B are connected by a mercury manometer (SHg = 13.6). The fluid in both pipes…

A: SHg=13.6 To find h'

Q: To measure the pressure inside a pipe, a manometer is connected to it as shown in the figure below.…

Q: Calculate the discharge through a venturimeter connected to a differential manometer. The liquid…

A: Introduction- The venturi meter is being used to determine the rate of flow of a fluid passing along…

Q: A manometer is attached to a water tank as shown in the figure. Find the pressure at the interface…

Q: The pressure in a container is 45 kPa. If this pressure is measured using a manometer (U-tube) with…

A: P = 45 kPa or 45000 Pa = 2600 kg/m3

Q: 1. In Figure below, sensor A reads 3.5 kPa (gage). All fluids are at 15°C. Determine the elevations…

A: PA=3.5kPa

Q: r per second through a pipe. A horizontal venturi meter with throat diameter of 150-mm was used to…

A: We know the formulaQ=A1A2A12-A222ghh=x(SmSw-1)h=1.2(1.61-1)=0.72m

Q: Consider a U-tube manometer whose arms are open to the atmosphere as shown in the schematic. There…

A: The pressure head in the manometer is calculated by using the equation, P=ρgh.

Q: Manometer with three liquids as shown. SGs are given. Calculate gauge pressure for oil. 20 KPa Water…

A: Given, to determine, Gauge pressure for oil.

Q: A flow rate measuring device is installed in a horizontal pipe through which water is flowing. A…

A: Given Specific weight of Gage fluid = 112 lb/ft3

Q: A pitot-static tube is used to measure air speeds. With water in the differential manometer and a…

A: It is required to determine the actual air speed. v=Cv2ghmρwρa-1 Here Cv is the coefficient of pitot…

Q: If the pressure (in psi) measured at the center of the pipe (+) is 0.12 psi, what should be the…

Q: In the figure below, a fluid with a specific gravity of 0.77 is flowing. The mass flow rate is…

A: Given data, Specific gravity = 0.77 Mass flow rate = 18.5 kg /s Diameter of nozzle = 4.87 cm θ =…

Q: i) What is the gauge air pressure in the tank at Point 1?

Q: The static and stagnation pressures of a fluid in a pipe are measured by a Piezometer and a Pitot…

Q: A fluid of specific gravity 0.8 is flowing in a pipe. The pressure drop across a flow secti between…

A: specific gravity of fluid is 0.8

Q: Natural gas FLO 3 14 in 6 in -Mercury SG= 13.6 -Air 2 in 22 in Water

A: Given data:- The local atmospheric pressure is, =14.2 psi The given specific gravity of mercury,…

Q: A two-dimensional flow field for a liquid is defined by V-[(z+2y³)i + (22²-3y)) m/s, where z and y…

A: Flow field, Location, To find: (a) The magnitude of the velocity of a particle.…

Q: Mercury (5.g. = 13.6) 0.4 ft y Oil B (s.g. = 0.91)

Q: A U-tube manometer is used to check the pressure of natural gas entering a furnace. One side of the…

Q: A flow rate measuring device is installed in a horizontal pipe through which water is flowing. A…

Q: Situation 2 An object with a shape of a cube with 280mm on each side, and weighing 425N is lowered…

Q: 5.5 in. Open 1.4 in. Water Unknown fluid Open 4.9 in. 3.3 in.

Q: A tank contains gasoline and glycerine with open piezometer tubes attached as shown. The depths of…

Q: A mercury Manometer is attached to a pipe having suction pressure. The right limb is open to the…

A: Right limb which is open to atmosphere as per given data : For equilibrium condition a) Difference…

Q: Question Air flows through a duct, and the Pitot-static tube measuring the velocity is attached to a…

A: Given data- Density of air ρ1=1.22 kg/m3, Density of water ρ2=1000 kg/m3, Coefficient of tube…

Q: Question 3:-A tank with 100.58 kPa pressure is connected with manometer to measure the pressure. The…

Q: A 300mm by 150mm venturi meter is installed in a vertical pipeline carrying water as shown in the…

A: Our objective in this numerical challenge is to use the provided data to calculate the discharge…

Q: (5) As shown in the image, an air space above a long tube is pressurized to 50 kPa vacuum. Water…

A: Given Initial Pressure in air space=50 kpa Final Pressure in air space=25 kpa Assume Atmospheric…

Q: -oil(sg.30.85) 680 mm 1700mm water

Q: Question 3:- A tank with 100.58 kPa pressure is connected with manometer to measure the pressure.…

Concept explainers

Pressure and Stress

Question

5. The pitot tube shown below is placed at a point where
the velocity is 2.0 m/s. The specific gravity of the fluid is
2.0, and the upper portion of the manometer contains air.
The reading h (m) on the manometer is most nearly:
a. 20.0
C. 0.40
b. 10.0
d. 0.20
2.0 m/s
AIR

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the reading of the pressure gage is 260 kPa, determine the gage pressure of the gasoline line. Assume the density of air to be 1.225 kg/m3
Fluid 9
For a U type manometer, a special manometer fluid with a density of 700 ∓ 1 kg/m3 is used. One end of the manometer is open to the local atmospheric pressure of 744 mm-Hg. When the other end of the manometer is connected to the compressed air source, the level difference read from the manometer is 20 cm ± 1 mm. Calculate the pressure of the air source and the uncertainty in the measurement in Pascals. If a manometer with a forty-five degree inclination is used, what will be the height of the liquid read under the same pressure effect? The uncertainty in the reading will remain constant at ±1 mm. In this case, calculate the uncertainty in the pressure measurement.g=9.807 m/s^2rho_air=1.225 kg/m^3
Need answer only
A closed pressurized tank shown below is filled with oil and mercury. Mercury is confined in an internal reservoir inside the closed tank, the height of mercury is 450mm. An open manometer is placed on the bottom left part of the tank with liquid “X” as its gage liquid , the deflection from the gage liquid shows 800mm. Determine the following:a) Height of the oil from point A up to point c if height A to C is 5 times the height of y. b) Pressure @ point B in kPa. c) Pressure @ point C in psi.
Subject: Fluid Mechanics Up to three decimal places Show solution and diagram Thank you
I need the answer as soon as possible
Fluid
A fluid of specific gravity 0.8 is flowing in a pipe. The pressure drop across a flow secti between 1 and 2 is measured by a differential manometer as shown in the figure below The manometric fluid is mercury (S = 13.6). The pressure drop is Fluid (5-0.8) 2 m 0.5 m He Assume density of water is 1000 kg/m³ and g = 9.81 m/s².
Q1 A U-tube manometer is used to measure the pressure of oil of specific gravity 0.85 flowing in a pipe line. Its left end is connected to the pipe and the right-limb is open to the atmosphere. The centre of the pipe is 100 mm below the level of mercury (specific gravity- 13.6) in the right limb. If the difference of mercury level in the two limbs is 160 mm, determine the absolute pressure of the oil in the pipe. Liquid (5,-ERS) Pips
DYNAMICS OF RIGID BODIES
A docs.google.com/forms/d/e/1FAlpQLSetk8UE/ PROBLEM 6: A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the reading of the pressure gage is 260 kPa, determine the gage pressure of the gasoline line. Assume the density of air to be 1.225 kg/m3 * Oil SG = 0.79 P gage = 260 kPa Gasoline SG= 0.70 Pipe Air 45 cm 50 cm 22 cm 10 cm Mercury SG= 13.6 Water Your answer