5. Much of the points for this assignment will be awarded for the following: ° Appropriate placement of the datum coordinate system • Correct part orientation as shown in the assignment attached graphic • Correct geometry and sizes • Fully constrained sketches • Model follows design intent ⚫ All features named If you have questions about this assignment, please contact your instructor. 50 28 74 28

Q: Dimension is 3/4” scale is 2”=1” what is the distance?

A:

Q: 3

A: intro- defects on any material is cause of failure of material.

Q: What are 1-, 2-, and 3-point perspectives? Draw cubes of different sizes using 1-, 2-, and 3-point…

A: Approach to solving the question: drawing, constructing of answer Detailed explanation: Examples:Key…

Q: When does the reduction in the dimensions occur?

A: Reducing of dimensions is done in the following conditions. Reducing of dimensions of a workpiece…

Q: Need auxiliary views of this drawing

A: This question is based on the concept of engineering drawing.

Q: What is the maximum thickness dimension allowed on the part?

A:

Q: If the part was cut by this plane, what would the resulting remaining face look like?

A: Section planes in SketchUp cut a model along a plane so you may look within it without altering…

Q: On a technical drawing, what is the difference in the application of the "cutting plane line" and…

A:

Q: pr... below. 5) Sketch the appropriate sectional view on the front view of the part

A: Given:To find:Sectional view on the front view.

Q: what does an example of a 3 view drawing of a wheel look like, including the rear, front and side.…

A:

Q: In the moment calculation, why did you take away the h* from 8?

A:

Q: What is the key information that needs to be incuded in a section view on an assembly drawing.…

A: The Answer is below

Q: What type of lines can be used in a drawing to show that part of an object has been removed ?

A: Solution : There are two types of line which are used to show the removed part of an object : Break…

Q: 9. The top view shows a bend radius of the thin metal. Would a bend radius of 1/8" meet the…

A: If the bend radius lies with in the given range then it will meet the requirements. 18"=0.125" The…

Q: Describe the method of sections?

A: Method of section In this method we deal with the non-concurrent forces. Here, we get three…

Q: OK, so the EA = 108 N, Length (L) = 13 m, and the angle is 22.6. What now?

A: Here you are asking about what to do if the EA = 108 N, Length (L) = 13 m, and the angle is 22.6…

Q: Name, draw a neat sketch and explain why each of the following designs of rolling mill are used…

A: rolling mill are used instead of a basic two high rolling mill.i) A mill consisting of four…

Q: Hello, I was just wondering how you find hte angle of the blocks to 45 degrees? Thank you!

A: