5. Consider a point-to-point communication link operating at 38 GHz, using 35-dB dish antennas at each end. The radome loss is 2 dB at each end, and a 10-dB fade margin is required to allow for rain fades. If the transmit power is –10 dBm, the receiver noise figure is 7dB, the bandwidth is 50 MHz, and the link distance is 1.2 km, what is the signal-to-noise ratio at the receiver in dB? Assume that free-space loss applies.
Q: 1. (a) Two microwave frequencies are authorized for use in microwave ovens: f1 = 898 MHz and f2 =…
A:
Q: Q2: the modulating signal was transmitted with amplitude of A volts and modulating frequency of 1400…
A: From the concept of amplitude modulation, we know that If the modulating signal is given as: m(t) =…
Q: l-aperture imaging radar in the a ambda is 3cm, 0 is 20° and heigh
A: Given as, Length, L= 10 m, Lambda, λ=3cm=3×10-2m, Angle, θ=20°, Height, h=800km=800×103m.
Q: a) Show that the effective length of a lincarly-polarized antenna is related to its effecetive…
A: To show: The effective length of a linearly-polarized antenna is related to its effective aperture…
Q: Q2) Determine the peak frequency deviation and the modulation index for an FM modulator with a…
A: Given, K=5 kHz/V em(t)=2 cos2π2000tk=5 kHz/VFm modulator deviation sensitivity em(t)=2…
Q: 6. What is the ratio of impedance when Z1 = 3.2 x 103 and Z2 = 1.45 x 102 ? 7a. The ratio of…
A: Given that Z1 = 3.2×103And Z2 = 1.45 × 102
Q: If the largest dimension of the receiving antenna operating at a frequency of 9.5 GHz is 10 cm, then…
A:
Q: If a radio transmitter has a vertical antenna, should areceiver’s antenna (rod type) be vertical or…
A: Given: The position of the antenna of the radio transmitter.
Q: 3. The dimension of a rectangular metallic waveguide is 1.5 cm by 0.75 cm. Please write down the…
A: Given that, The dimension of a rectangular metallic waveguide is 1.5 cm by 0.75 cm. So, a=1.5…
Q: Consider two AM radio towers operating at 1200 kHz. The towers are separated by 3 km. In between the…
A: Write a given values of this question. f=1200kHz=12×105Hzd=3km=3×103m Velocity of light. c=3×108m/s
Q: Explain the receiver sensitivity of the radar system. (Five lines maximum accepted for the right…
A: The minimum signal strength that a receiver can detect is measured as receiver sensitivity. It tells…
Q: A 16384-point discrete fourier transform is used to evaluate the power spectral density of a signal…
A: The frequency resolution is defined as Fs/N in FFT, Where Fs is sample frequency, N is number of…
Q: What is the longest wavelength that can be detected in the third order with an 8205 slits/cm…
A: Answer Given In normal rate of occurrence Angle θ = 90° Order m = 3 Distance between slits 1d=…
Q: Q4 Calculate the minimum value of the transmitted power of a pulsed radar signal to detect a 10² m…
A: Given The cross-sectional area of the antenna σ = 10 m2 Distance D…
Q: (SNR = 6 dB)
A: Given as,
Q: The CT signal x(t)=6cos (800πt) + 8cos2 (mπt) is critically sampled (Nyquist rate) by fs=8000 Hz.…
A: Given:- The CT signal xt = 6 cos 800πt +8 cos 2fs = 8000 Hz
Q: Name the type of waves which are used for line of sight (LOS) communication. What is the range of…
A: For communication purposes, radio waves are employed. Line of sight communication means that the…
Q: Discuss, with the help of equation(s), the effect of parabolic antenna size on the radar angular…
A: A parabolic antenna directs radio waves using a parabolic reflector, which is a curved surface…
Q: A naval radar system operates at a wavelength of 1.3 cm, transmitted from a circular antenna of…
A:
Q: Calculate the wavelength of an emission band observed at 19.91 cm when I = 40.0 cm and the grating…
A: Given,y=19.91cml=40cmd=1085nm
Q: i) The measure of how fast data can be transmitted in a given bandwidth is referred to as____ .…
A: The answer to the above questions let us understand the terms given in the question
Q: When aligning one of the antennas, it was found that the standing wave ratio is 1.2 VSWR, which…
A:
Q: 3. The radar in which both transmission and reception is done using the same antenna are called: a)…
A: The radar in which both transmission and reception is done using the same antenna are called: a)…
Q: Given: - cellular phone with 0.6W transmit power - unity gain antenna, 900 MHz carrier frequency -…
A: To calculate the maximum distance, we need to consider the power received at the receiver and…
Q: People used to check if train was coming by putting their ear on the railway. Why do they use this…
A:
Q: Calculate the wavelength of an emission band observed at 18.31 cm when l = 40.0 cm and the grating…
A:
Q: 1. To eliminate reflections of normally incident plane waves, a dielectric slab of thickness d and…
A: Given, εr1=1 and εr3=16 f=3 According to quarter wave transformation technique, the thickness is…
Q: A cectangular air-filled copper waveguide with dimenssion 2.28 cm x 1.01cm cross section 30.48 cm…
A: the first three has been answered. a) cut off frequency is, fc=c2a=3×108 m/s22.28×10-2 m=6.6×109…
Q: (a) Find the size (in mm) of the smallest detail observable in human tissue with 19.5 MHz…
A: Given data: The size of the smallest detail observable in human tissue with ultrasound is: λ The…
Q: Q2: the modulating signal was transmitted with amplitude of A volts and modulating frequency of 1400…
A: In the given question, first of all, we just list down the given terms here in tabular format ,…
Q: A fighter jet has a circular radar antenna in the nose of the aircraft that operates at 10 GHz. (a)…
A: Given: The diameter of the antenna is, d = 1 m. The operating frequency is, f1 = 10 GHz. And the…
Q: Q2/If the beamwidth at which a particular antenna operates is 21.39, since the lowest frequency…
A: If the lower frequency is f1 and the upper cutoff frequency is f2 then, a) center frequency=f1f2 if…
Q: The width of the elements of a linear phased array are usually to the wavelength.
A:
Q: How interference makes it possible to measure extremely small distances?
A:
Q: A ship generating a sell noise of 65dB. The sonar signal is receiving signals over frequency bands…
A: The relationship between the sonar pulse length and receiver bandwidth is roughly given by:…
Q: A transmitting antenna at the top of a tower has a height of 36 m and the height of the receiving…
A: Given: The height of the tower is 36 m. The height of the receiving antenna is 49 m. The radius of…
Q: Jusco Melaka is linked with the Head Quarter in Klang Valley using 140 km single mode optical fiber…
A: Given: Jusco Meleka is linked with the head Quarter in Klang Valley using 140 km single mode optical…
Q: Q2. Compute the smallest radius of a circular antenna (with constant excitation current) in terms of…
A: To find the smallest radius a of a circular antenna in terms of the wavelength λ where the…
Q: QI- The wave impedance of the TE10 mode of an air-filled rectangular waveguide at a frequency of 15…
A: The question comprises of 4 sub-parts. As per our policy, we can answer the first three. Kindly…
Q: (a) Two microwave frequencies are authorized for use in microwave ovens, 875 and 2530 MHz. Calculate…
A:
Q: 3. The radar in which both transmission and reception is done using the same antenna are called: a)…
A:
Q: Q3. a) Show that the effective length of a lincarly-polarized antenna is related to its effective…
A: Let us take a Hertzian dipole antenna. The Hertzian dipole is a theoretical dipole antenna made up…
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 2 images
- (1) A 1024 Hz tuning fork is placed at the source position in the figure shown. What must be the smallest radius r such that a minimum will be heard at the detector? [Hint: Usound = 343 m/s.] (2) If the radius is kept fixed, what other frequencies would lead to a minima? source detectorIt is desired to have a circular-aperture antenna with a gain of 30 dB operating at a fre- quency of 1.5 GHz. The aperture efficiency is 75%. What should the diameter be? What is the 3 dB beamwidth?18. Solve the Network Circuit by finding the Following: R= 60sz R3= Iy=6f www %3D VT = 120v %3D Ry=1152 Is= I6= %3D R5= 22 R= 3352
- Q5) Bandwidth: An LED circuit has an optical 3 dB bandwidth of 551.33 MHz. Calculate the modulation frequency at which the LED optical power output is reduced to 30% of its low-frequency value. Express your answer in units of GHz.iscuss how you can make the filter gives ideal response. - Discuss the disadvantages of increasing the order of the filter1.
- A communication system has two identical antennas operated at 6 GHz and aligned for maximum reception to each other. To allow the receiver antenna to detect the transmitted signal of 25 W over a distance of 40 km, the receivied signal power must be greater than or equal to -25 dBm. Calculate the required receiving antenna gain to detect the signal efficintly.3. How deep does a radar wave in millimeter band of 100 GHz travel into seawater before its amplitude is reduced to 10-3 of its amplitude just below the surface (assuming the seawater has µ = µo, ɛ = 24 ɛo, and o = 4 S/m)?A 12 GHz down link of a GEO satellite at a height of 36000 km above earth surface has an antenna with a diameter of 1 meter and 0.65efficiency. Find the gain in dB, the beamwidth in degrees, and the diameter of the circular coverage area on earth surface assuming flat earth