5. A rectangular channel 4 m wide is narrowed to 2m widthInmnto cause critical flow the contracted section. If the depththis section is I'm, calculate the flow and depth4m section, neglecting energy lossesenergyAine and the water surfacem. thein the transition, sketch the

Given a rectangular channel 4m wide which is narrowed down to 2m wide so as to cause critical flow.…

5. A rectangular channel to cause critical plan this section is Im, 4 m wide. narrowed to 2m width 25 in the contracted section. If the depth mn m is I'm, calculate the flow and depth in the losses In 4m section, neglecting energy energy line and the water surface the transition, sketch the

5. A rectangular channel to cause critical plan this section is Im, 4 m wide. narrowed to 2m width 25 in the contracted section. If the depth mn m is I'm, calculate the flow and depth in the losses In 4m section, neglecting energy energy line and the water surface the transition, sketch the

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

1. Water is flowing with velocity 2.8 m/s in an 80 mm diameter half opened gate valve. Determine the head loss through this valve. (Ans.: 2.398 m)
Please correct answer otherwise down vote
Water discharges in too wide rectangular channel slope =0.01 Just apstream the weir where the water depth is 2.5m the flow rate is 5m ^ 3/s As per meter width as shown below Assume n = 0.015 and neglected losses. 1. Find the normal depth, the critical depth and the critical slope? 2. Use the specific energy equation to find the weir height such that the flow over the wer is critical? 3. What water surface profile exists upstream the weir and locate the distance upstream the weit where the water depth equals the normal depth ?
(Single pipe - determine pipe diameter) Water is to flow at a rate of 1.0 m³/s through a rough concrete pipe (ε = 5 mm) that connects two ponds. Determine the pipe diameter if the elevation difference between the two ponds is 10 m and the pipe length is 1000 m. Neglect minor losses. D= 0.783 m
A trapezoidal channel with a bottom width of 5m and side slope of 1V:2H is constructed to convey a steady discharge to a hydropower installation. This is made up of concrete with a Manning's n = 0.016 and bed slope of 3V:2000H. a. Determine the discharge and velocity if the discharge has a 2m-depth of water? b. Calculate the depth if discharge is 35m³/s? c. As shown below, when flooded, the flow goes over the top of the channel. If the flood channels are 10 m. wide and with side slopes of 1V:3H, and roughness is n=0.035, what is the discharge for a flood level of 4m? 14.5 15.0 14.5 region 2 region 1 region 3 4 10 10 5 2.
4.7. Water flows at a depth of 2.20 m in a trapezoidal, concrete-lined section (ks of 3.6 m and side slopes of 2:1 (H:V). The longitudinal slope of the channel is 0.0006 and the water temperature is 20°C. Assuming uniform-flow conditions, estimate the average velocity and flow rate in the channel. Use : 2 mm) with a bottom width Manning equations
Water is flowing under the sluice gate in a horizontal rectangular channel that is 3 m wide. The depths y and y2 are 2 m and 15 cm, respectively. The horizontal distances between locations 1, 2, and 3 are sufficiently short that rapidly varied flow conditions can be assumed to occur. Determine the a) discharge; b) depth downstream of the jump at location 3; ( c) power (kW) lost in the jump. 1 2 3 Q
Design a composite pipe drain of parallel grid system to be installed, the lateral is joints the collector from both sides. The laterals are of 300 m length on one side and 200 m on the other side and will installed at depth of 2 m below soil surface with slope of 0.05%. The ground water table was found at depth 1.5 m and the impermeable layer at depth 5 m below soil surface. The hydraulic conductivity is 0.75m/day. If the amount of irrigation water that must be drained 20% of the irrigated water and the infiltration water which escape is 11% of irrigated water the area must be irrigated by 30 cm per 3 days. The collector diameter is 50 cm with slope of 1%, and the number of laterals in one side is 1
B7
Subject : Fluid mechanics Give me all answers.. Urgent
A flow of water of 100 lt/sec flowing through rectangular tube of width 600 mm and having adjustable bottom slope with C = 56. Find the bottom slope required for uniform flow of depth 300 mm. Also, determine the convience of fume.