Q3/ Determine the state of flow in a rectangular channel of (3m) width and depth of flow is (1m) and the bed slope is (1 in 2500 ) for the following two cases: k 2- Kuttur constant is (0.013). 1- friction factor is (0.038). L نوع الي

Q3/ Determine the state of flow in a rectangular channel of (3m) width and depth of flow is (1m) and the bed slope is (1 in 2500 ) for the following two cases: k 2- Kuttur constant is (0.013). 1- friction factor is (0.038). L نوع الي

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: View Policies Current Attempt in Progress Water flows over the spillway shown in the figure below.…

Q: A circular conduit is to satisfy the following conditions: Capacity when flowing full is 0.13…

A: Given data,capacity when flowing full is 0.13m3/secvelocity when the depth is one quarter of the…

Q: 4 For a rectangular channel, if the Froude number = 1.5 and the initial depth=0.8 m, the depth after…

Q: Q3: A. Derive the relation between the head losses and flow (hL=kQ) which is assumed in the hardy…

Q: A hydraulic jump occurs in a 4 m wide rectangular channel carrying a discharge of 5 cumec at a slope…

A: A hydraulic jump occurs in, 4 m wide rectangular channel, B = 4 m Discharge, Q = 5 cumec Slope, S =…

Q: What does a negative flow rate mean? A. This value is incorrect and shall be indicative of wrong…

A: The negative flow rate means that it is backflow. The negative flow rate indicates the direction of…

Q: A bar screen is used to treat 10 MGD of menicipal wastewater. The vertical bars are 1.27 cm wide and…

Q: A right-angled triangular channel carries a flow of 16,000 l/s. The Manning's n = 0.020 and the…

Q: Calculate the discharge in the concrete trapezoidal channel if the slope is 0.0002, the side slope…

Q: 11. Estimate the type of flow in a channel having cross sectional area of 50m² and top

A: To find : Type of flow in channel.

Q: A rectangular channel discharges 0.5m/s per metre width. Determine the critical depth and the step…

A: Given data: q=0.5 m3/s/m E1=1 m

Q: Design a coarse screen for a flow 0.45 m3/sec. The screen is placed in a canal 0.9 m in width and…

A: Given data Discharge Width Height of screen Bars dimensions

Q: Question 48 A circular pipe has a diameter of 1m, bed slope of 1 in 1000, and Manning's roughness…

A: Given- Bed slope- s=1 in 1000, n=0.01, Dia D=1m, Depth of flow y=0.5 m,

Q: depth of water = 10 cm velocity of water = 6 meters/sec *The water flows in a rectangular-shaped…

A: Given rectangular channel Depth of water y1 = 0.1 m Velocity of water V1 = 6 m/sec Whether it is…

Q: a rectangular concrete channel, the equilibrium depth is 3.2 m. The channel is 2 m wide and the bed…

A: Gievn data,y = Uniform equilibrium flow depth =3.2 mb = Channel width = 2 mS = Bed slope = 0.0006n =…

Q: solve it please

A: Step 1: Step 2:There is Lil change in numbers like there is 26 instead of 20 and so on Hope you got…

Q: Uniform flow (15.0 m³/s) occurs in a rectangular channel of width 3.50m at a normal depth of 3.80m.…

A: Given Width 3.5 mNormal depth before gate 3.8 mDepth at gate 0.5 mDischarge 15 m3/sTo find out Depth…

Q: Variation of water depth (y) in a gradually varied open channel flow is given by the first order…

Q: When the channel of triangular cross section shown in the figure below was new, a flowrate of Q…

A: Given data:- The value of flowrate of Q caused the water to reach, L1=1.9 m Use formula:- Q=AV…

Q: Analyze and sketch the water-surface profile in a long rectangular channel with concrete lining, n =…

Q: EXAMPLE 1: Determine the normal discharge for the channel shown in Fig 2.7a. The water surface in…

A: Discharge is the volumetric flow rate of water that is transported through a given cross-sectional…

Q: Variation of water depth (y) in a gradually varied open channel flow is given by the first order…

Q: des with 12 m fl. is 2.m from tis 1.8/ blade revaluation - 3 Nis/m² 2

Q: A circalar sewer pipe 1.6 m in diameter is Taid on a slope of 2 m per kilometer. The pipe is made of…

Q: ● Design a regime channel to carry a discharge of 40 cumecs by Lacey's Theory. Assume side slopes to…

Q: Q5) Calculate the (i) water discharge (m'/sec)and (2) Manning's constant for the flow through an…

A: We have above given data we have to find discharge and Manning's constant

Q: Question- OCF A rectangular channel carrying a super critical flow is to be provided with a…

A: A rectangular channel carrying a supercritical flow- The energy loss required in the hydraulic jump…

Q: Question: Open channel test is performed and according to the following; (t=14.35 s)(1kg = 0.01m3)…

A: t=1 kg =y=B=To find- a) Flow calculationb) Energy from the flow ratec) Energy by point velocities

Q: 500 mm diameter pipe is laid on a slope of 0.002 and is to carry 40 liters/sec. Using n = 0.013,…

Q: The hydraulic radius (m)

A: Given: Diameter of circular pipe=D To find: Hydraulic radius (m)

Q: The following twenty problems refer to a transition in a rectangular channel with a bottom elevation…

Q: Q (5-2)/ Water flows uniformly in an earth rectangular cross section open channel. Data available…

Q: CRITICAL FLOW Water flows at a rate of 50 m/ s in a rectangular channel having a base of 10 m. If…

A: Note- Since we only answer up to 3 sub-parts, we’ll answer the first3. Please resubmit the question…

Q: A flow of water of 0.1 m³/sec flowing through rectangular tube of width 550 mm and having adjustable…

A: Given: Discharge, Q = 0.1 m3/s Width, W = 550 mm Depth, H = 250 mm C = 55

Q: Q2) A flocculation basin has dimensions of 17.4m length, 11.4m width, and 5.8m depth, with three…

Q: In gradually varied flow, the channel bottom, water surface, and EGL are parallel. Select one: O…

A: Given Channel bottomWater surfaceEGLTo find out TRue or false

Q: The bottom width and bed slope of a long rectangular channel are 4.0 m and 0.0008, respectively. The…

A: Bottom width of rectangular channel, B=4 m Bed slope of channel, So=0.0008 Steady state discharge,…

Q: B/ In the pipe systems show, find the distribution of flow, with a friction factor of 0.0165. Assume…

Q: Q (5-8)/ Water flows uniformly in an earth Trapezoidal cross section open channel. Data available…

Q: vhich is running full is 8m. Determine the discharge through the channel section if the

A: To find : Discharge through channel.

Q: Consider a concrete (n-0.013) wide rectangular 3 per channel that discharges 2.0 m /s flow. The…

A: Given: The value of n is 0.013. The discharge of the rectangular channel is 2.0 m3/sec per unit…

Q: A. Design a trapezoidal channel to carry a discharge of 10.5 m^3/s. The bottom slop of the channel…

Q: Water Resources Engineering: Open Channel Flow A 3.7 meter wide rectangular channel with with a bed…

A: Given data: a) No flow is not fully turbulent due to nature of channel inside in earthen channels…

Q: 5. The diameter of a circular channel section which is running full is 8m. Determine the discharge…

Question

Q3/ Determine the state of flow in a rectangular channel of (3m) width
and depth of flow is (1m) and the bed slope is (1 in 2500 ) for the
following two cases:
*
1- friction factor is (0.038).
2- Kuttur constant is (0.013).
f
نوع الي

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Compute for the Froude number when the velocity of flow is 2m/sec in a rectangular channel measuring 3 meters wide and 2 meters deep
please help with hydrology problem. make sure it is correct, will thumbs up if correct.
Assume uniform flow through a half-full circular channel. a. hydraulic radius (m) b. Reynolds number c. hydraulic depth (m) d. Froude number
PROBLEM 1 A rectangular channel 12 in wide and 30 ft long yielded the following test results: with still water, Z₁ - Z2 = 0.010 ft; with a measured flow of 0.20 cfs, y₁ = 0.40 ft, y2 = 0.405 ft. Determine the following: (a) V₁ (ft/s), (b) V₂ (ft/s), (c) head loss, hu(1-2), (ft), (d) slope of EGL, S, and (e) roughness factor "n".
o T ☺ ť An open channel has a rectangular section 3 m wide. The flow rate is 1.4 m/s and the depth is 0.8 m. Calculate the slope of the channel using the Manning formula for steady flow. Take the constant n = 0.02 m* / مر ر ل لأعلى لاستعراض الفلاتر إضافة شرح. . . mum <
A 450 mm Ductile sewer pipe (n=0.012) has been installed with an invert slope of 0.0015. Determine the capacity of flow when this pipe is flowing full. Assume the flow is uniform a. 0.12 m³/s O b. 0.75 m³/s O c. 1.01 m³/s O d. 0.05 m³/s
Sol?
Fluid mechanics Help me urgenttttttttt
Q-
I need answer fast please.
You must determine the normal depth for a flow in a rectangular canal. Presume flow to be uniform, the base of the canal to be 8m wide and the slope to be critical. The flow is 10 m3/s and the Manning coefficient is 0.012.
6. A 3.6 m wide rectangular channel carries water to a depth of 1.8 m. In order to measure the discharge, the channel width is reduces to 2.4 m and a hump of 0.30 m height is provided in the bottom. Calculate the discharge if water surface in the contracted section IQ-6.418 m/s] drops by 0.15 m. Assume no losses.