5. A contractor has decided to use a hydraulic backhoe to excavate a 24-inch wide trench for the construction of a water line. The backhoe has a general purpose bucket with a rated heaped capacity of 19 cubic feet. The average depth of the 400-foot trench is about 6 feet. The soil to be excavated is tough clay with a swell of 33%. Operational efficiency is estimated at 45 minutes per hour. 1. What is the estimated productivity of the backhoe in bank cubic yards per hour, if job conditions are considered average? 2. How long will it take to excavate the trench?

5. A contractor has decided to use a hydraulic backhoe to excavate a 24-inch wide trench for the construction of a water line. The backhoe has a general purpose bucket with a rated heaped capacity of 19 cubic feet. The average depth of the 400-foot trench is about 6 feet. The soil to be excavated is tough clay with a swell of 33%. Operational efficiency is estimated at 45 minutes per hour. 1. What is the estimated productivity of the backhoe in bank cubic yards per hour, if job conditions are considered average? 2. How long will it take to excavate the trench?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The daily arit removed from a plant is 350gallons If the plant flow is 13MGD how

A: Given- Grit Removed =350 gallonsGrit Removed =350×0.13 CFDGrit Removed =45.5 CFDPlant flow=13MGD

Q: H= Co settlement occurred in the first of 5 minutes, for the same consolidation of drainage, how…

A: H = 2.4 cm or 0.024 mt50 = 5 min

Q: If you’re required to excavate and remove 2200m³ of soil with a swell of 10% from site, your crew…

A: Given data, Volume of excavation soil = 2200 m3 Swelling in soil = 10% Crew can remove the…

Q: The coefficient of permeability of soil around a sheet pile is 10-5 m/s. The flow net of this sheet…

A: Given: The coefficient of permeability is 10-6 m/sec. The number of flow lines is 6. The number of…

Q: 10. If a project site is 50% Troop sand and 50% Dothan loamy sand, explain (but do not solve) how…

A: Infiltration: Infiltration is defined as the maximum rate at which water can enter through the soil…

Q: A contractor is to excavate an area of 350′ × 150′ to a depth of 9′ and haul it by dump truck to a…

A: Following are the given information. Excavation area =350′ × 150′ Excavation depth =9' Swell factor…

Q: construction firm is putting up a dam in your area. Being curious, you decided to un avail yourself…

A: Soil compression is the method of lowering the amount of air inside a mass of soil to increase its…

Q: Estimate the lea<hing requirement when electrical <onductivity (EC) valve of a saturated extract of…

Q: The hydraulic conductivity, k of the clay for the loading range is 2.0 x 10^-4 ft^2/day. a) Find the…

Q: 4. Estimate the production in compacted cubic yards per hour of a tamping foot, wheel-tractor-towed,…

A: This question is related to the Geotechnical Engineering.

Q: Estimate

Q: How would you check that the design compaction is achieved in the field

A: The compaction is defined as "the expulsion of air from the soil pores by means of mechanical…

Q: 9.5 Following is the variation of Ngo with depth in a granular soil deposit. A concrete pile 9 m…

Q: for Shovel Excavator Soil Type = dry clay -Rotation angle…

A: for Shovel Excavator -Soil Type = dry clay -Rotation…

Q: Construction of an embankment needs 400,000 yd3 of fill. The fill should be compacted to at least…

Q: 16. If the production of a dozer is 111 lcy/hr is moving a soil with swell factor of 0.89 and has a…

Q: 4. A power shift tractor is excavating tough clay and pushing it a distance of 95 feet. Maximum…

A: Distance = 95 ft Speed: First range=3 mph Second range = 5 mph Third range = 8 mph Blade capacity =…

Q: If the production of a dozer is 111 lcy/hr is moving a soil with swell factor of 0.89 and has a…

Q: An embankment will be constructed on very soft soil as shown in Figure Q1(b). The details pertaining…

A: Prefabricated Vertical Drains (PVD) : Prefabricated vertical drains act as a drainage paths which…

Q: Given year of fill sediment =50 yr, Increment volume = 7000 acre-ft, trap efficiency = 90% and 91% ,…

Q: Please round to the nearest One (i.e., 1). Calculate the compacted cubic yards per hour if a…

Q: Calculate 5 & 6 : @A (The midpoint of the layor) loose send 8 = 108pcf Clay 8 = 94 pcf Dense Sand…

A: Data is given

Q: 100 units of prefabricated blocks with dimensions of 2.00 m x 0.9 m x 0.2 m will be stored on a…

Q: 2: Děšign and Analysis - make sure to show all calculations, correct units and box answers for all…

A: Compaction Compaction is the mechanical process of raising soil density while removing air. The…

Q: A retaining wall with a vertical back is 8 m high. The volumetric weight of the 3 m ill surfaces is…

Q: Provide your own perspective as to why soil volatilization calculations are prone to error and/or…

A: methods adopted to solve the problems of land degradation Afforestation. Proper management &…

Q: Explain the most important characteristics in the design of a sedimentation tank?

A: Sedimentation is the process of removal of fine suspended particles which cannot be removed in…

Q: Estimate the hourly production in bank measures of a hydraulic shovel loading sand and gravel into…

A: Answer We are given Sand and gravel load Front dump bucket Heaped bucket capacity = 5.2 LCM Average…

Concept explainers

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.

Question

5. A contractor has decided to use a hydraulic backhoe to excavate a 24-inch wide trench for the
construction of a water line. The backhoe has a general purpose bucket with a rated heaped capacity of
19 cubic feet. The average depth of the 400-foot trench is about 6 feet. The soil to be excavated is
tough clay with a swell of 33%. Operational efficiency is estimated at 45 minutes per hour.
1. What is the estimated productivity of the backhoe in bank cubic yards per hour, if job conditions are
considered average?
2. How long will it take to excavate the trench?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Trending now

This is a popular solution!

Step by step

Solved in 5 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Measuring sitework, excavation and piling

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

i need the answer quickly
22. Calculate the compacted cubic yards per hour if a com- pactor with a 5-ft drum width travels at 3 miles per hour over a 10-in. lift of aggregate base course with 4 passes required to meet density specifications under average operating conditions.
A surcharge and sand drain installation is proposed for an airport project to accelerate the consolidation of a thick deposit of fine-grained soil underlying the construction area. The plan is to install sand drains 1.5 ft in diameter at a staggered spacing so that each sand drain will handle a plan area 15 ft in diameter. Laboratory tests indicate that the coefficient of consolidation for horizontal drainage of the soil is 0.5 ft2/day. Computations indicate that the surcharge load will cause an eventual settlement of 12 in. How long a period will be required for 90 percent of this settlement to take place?
A rectangular settling tank is to treat 3.6MLD of raw water. The sedimentation period is to be 3 hours; the velocity of flow is 10 cm/min. The cross sectional area of the basin (in m², round off to the nearest integer) is
Two scrapers will deliver to the project 650 LCM per hour of fill material. The rolling width of the roller is 1.2m. 6 passes at 4 km/hr are required to obtain the required density. The fill material will be placed in 0.3m compacted lifts. Load factor (LF) = 0.8 and shrinkage factor = 0.85. Assume a 50-min job efficiency, determine the number of rollers required to support the scraper operation.
After the heavy rain brought by Irene passed over Vermont, the Winnooski River has raised to over 5 feet above its flood elevation. The flood crest is expected to arrive to Montpelier, state capital, in 48 hours. You are an engineer in charge ofcalculating the flood defense by increasing the levee top elevation. Your estimate calls for 5000 CY of compacted material needed before the flood crest arrives. You have two borrow pit options: borrow pit A is located 1 hour away and has 7 Caterpillar 69C trucks with 30.9 CY capacity available. Borrow pit B is located 30 minutes away but has only 3 Caterpillar trucks with the same capacity. Assuming arround the clock work in the next 48 hours calculate which option will allow for completion of the work within the time constraint given. Records on file show the following soil properties at locations A and B: A: Y= 120 pcf, w = 18% B: Y= 125 pcf, w = 12% In order to assure adequate stability of the levee slopes, it will be required to compact…
What is the approximate optimum hourly production rate for a wheeled backhoe filling hauling units? Struck capacity for the bucket is 6 loose cubic feet and the bucket fill factor is 110%,. The cycle time is 2 minutes, the soil type is moist loam with a 25% swell factor.
Please do fast with explanation don't waste time & don't copy
i need the answer quickly
A rectangular settling tank is to treat 3.6MLD of raw water. The sedimentation period is to be 3 hours; the velocity of flow is 10 cm/min. The cross sectional area of the basin is
(2003 The loading period for a new building extended from July 2005 to July 2007. In July 2010, the average measured settlement was found to be 163 mm. It is known that the ultimate settlement will be about 410 mm. Estimate the settlement in July 2015. Assume double drainage to occur.