Answered: 5. A circuit has a resistance of 20 ohm…

5. A circuit has a resistance of 20 ohm and a reactance of 30 ohm. What is the power factor of the circuit? а. 0 b. 0.55 c. 0.832 d. 0.99

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.8P: Consider the circuit shown in Figure 2.23 in time domain. Convert the entire circuit into phasor...

See similar textbooks

Related questions

Q: Figure 2 shows three "LC" circuits, two of them with capacitors of capacitance "C" and the three…

Q: Problem 15. A source of e.m.f. of 15 V supplies a current of 2A for six minutes. How much energy is…

A: In this question we will find energy provided by source ...

Q: 7. In a pure inductive circuit, the phase angle between the voltage waveform and current waveform…

A: In an inductor voltage leads the current And in capacitor current leads voltage. The pahsor diagram…

Q: What are the things common in direct current and alternating current. And also its Difference

A: The explanation is as follows.

Q: An inductive reactance of 6 ohm is connected in series with a parallel combination of a variable…

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: For the given data to limit 20Vrm

Q: Determine the maximum peak-to-peak ripple current of previous problem by using the next equations,…

A: To determine the maximum peak-to-peak ripple current ((Imax)), we can use the given equations.…

Q: Draw the waveform of voltage and current under the following conditions: A current which lags the…

A: In this question, We need to Draw the waveform of voltage and current under the following…

Q: The pu impedance of a circuit element is 0.15. If the base kV and base MVA are halved. Then the new…

A: Given, Per unit impedance of a circuit element, Zpuold=0.15. New kV values, KVnew=12KVold. New MVA,…

Q: A 25ohm resistor is connected in series with a %0 mH inductor. This circuit is connected to a 120V,…

A: The solution can be achieved as follows.

Q: An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is…

A: (a) Write the given values. Vrms=22.2 VL=0.29 mHf=1 kHz

Q: 9) Find the reactance and the impedance of the circuit. Calculate the current and the resonance…

Q: A resistor of 5 ohms is connected in parallel with an inductive reactance of 10 ohms, then connected…

Q: If there is reactive power associated with a circuit element we can say a) That said element is…

A: Real Power: The power dissipated from the supply is utilized by the resistive nature of the circuit.…

Q: Use 3 decimal places and box the final answer. A 4-ohm resistor is in series with a 7.96-mH…

A: In this question series RL circuit is given... We have to find impedance , input current and volgage…

Q: A star connected reflector supplies a delta connected load. The impedance of the load branch is (8 +…

Q: A 25-ohm resistor connected in series with a coil of 50-ohm resistance and 150-mH inductance. What…

Q: If an electrical circuit draws 100W + J100VAR from a sinusoidal source, then what would the circuit…

Q: 9. A noninductive load with a resistance of 30 Q2 is connected in series with a capacitor. The…

Q: Quistion.4. a) A sinusoidal voltage is applied to the resistive circuit in figure.Q.4. a. Determine…

Q: In a series circuit with the following devices to a 230volts 60Hz supply with a resistor in the…

A: Given data Supply voltage, Vs=230 V Supply frequency, f=60 Hz Resistor range; R=300 Ω to 990 Ω We…

Q: Determine the value that the unknown emf (E) must have so that the potential V12 = 9v

A: Please refer the Attached images for the complete answer..

Q: The voltage applied to the metal grid of CRO is negative with respect to cathode. Select one: O True…

A: Due to guidelines we can solve one question at a time.

Q: 2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b)…

A: Given

Q: Determine ZT for the circuit if inductive reactive is 10220 and resistance is 9850. Answer:

A: Given: A circuit is having Inductive reactance, XL=1022 Ω Resistance, R=985 Ω

Q: You are working in an industrial plant. A bank of capacitors is to be used to correct the power…

A: From the above question Given data is as follows;Three capacitor rate rated at 25 μF and 600…

Q: The voltage applied to the metal grid of CRO is negative with respect to cathode. Select one: O True…

A: Concept of CRO CRO is called as Cathode Ray Oscilloscope. The main component of CRO is Cathode Ray…

Q: A generator rated at 30MVA, 11kV has a reactance of 40%. Calculate its p.u. reactances for a base of…

A: Per unit values will be found by using 1. Base and actual values 2.old and new base values if old…

Q: Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a…

A: In this question, We need to choose the correct options What is power factor of the circuit. We…

Q: In the figure: R1 = 1439.170, R2 = R1 and R3 =2R2, then determine the value of the voltage source E.…

Q: pure resistance of 50 ohms is in series with a pure capacitance of 100 microfarads. The series…

A: In this question , we have given series RC circuit...We have to find out impedance , phase angle…

Q: 1) Two identical voltage waveforms of difference phase angles are shown in Figure B. Write down the…

Q: An emergency power supply is required to provide a three-phase sinusoi- dal voltage source of 208 V…

A: The voltage of the inverter (DC link voltage) that is required to produce a sinusoidal three-phase…

Q: An inductor and a 470 ohm resistor are connected in series with a function generator. The current is…

A: Given, Resistor and inductor are connected in series. Resistance (R)= 470 ohm Current flows…

Q: Computed Rms value (V) 100. E1:A to B E2:A to C 150 E3:A to D 220 E4:A to F 220 Vac E5:A to G 330…

A: In this question, We need to calculate the voltage across the different different points. We know…

Question

5. A circuit has a resistance of 20 ohm and a reactance of 30 ohm. What is the power factor of the
circuit?
а. 0
b. 0.55
c. 0.832
d. 0.99

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A generator rated at 30MVA, 11kV has a reactance of 40%. Calculate its p.u. reactances for a base of 50MVA and 10kV. O 0.606 p.u. O 0.506 p.u. O 0.806 p.u. O 0.706 p.u.
Please answer question in image with details on how to do it. Thank you.
In the circuit in Figure 2, the capacitor andThe circuit of resistance is defined as a load circuit.a) Find the average power dissipated by the load circuit?b) How much of the average power calculated in a) by the resistance in the load circuit and how muchspent by the capacitor? Interpreting the results obtained?c) In the circuit in Figure 2, with a resistance of 80 ohms 23?A coil of is connected in series. In this case,calculating transformer ratio () to optimize power delivery to the load? Obtainedinterpreting the result?d) Calculate the distributed load complex power and reactive power in the newly learned circuit?
A FET has a gm = 6000 mS. Determine the rms drain current for each of the following rms values of Vgs. (a) 10 mV (b) 150 mV
In a series circuit with the following devices to a 230volts 60Hz supply with a resistor in the range of 300 ohms and 990 ohms. What are the steps in calculating the impedance ...
Question -thyristor,
Find the Current in the Circuit in Miliampares
A 25-ohm resistor connected in series with a coil of 50-ohm resistance and 150-mH inductance. What is the power factor of the circuit? The standard frequency is 60 Hz. Show complete solution.
The voltage applied to the metal grid of CRO is negative with respect to cathode. Select one: O True O False The sinusoidal current waveform having the maximum value of 30 A. then the R.M.S value is Three coils each having resistance of 29 0 are connected in star across 436 V. 50 Hz supply. Then the total power consumed is O 19665.10 W O 3784.66 W O 755.20 W O 226.05 W
A resistor of 5 ohms is connected in parallel with an inductive reactance of 10 ohms, then connected in series with a capacitive reactance of 5 ohms. If the entire combination is connected across a 100 V, 60 Hz ac source, find the voltage across the resistor.
AC xuf lac V ac 21. The simple AC powered circuit above is being measured for AC current and voltage across a 1uF capacitor. The measured current is 200mA and the measured voltage is 40V. (note: 2 separate questions follow) a. Calculate the capacitive reactance, Xc. b. Calculate the voltage frequency.
Variation of which of the following parameter is not consider as power quality problem for industry?VoltageCurrentPowerFrequency