5-17. A homogeneous block 1 ft square by 3 ft tall weighs 100 lb. The block is supported by an inclined plane and the horizontal force P as indicated in Fig. P 5-17. The coefficient of friction between the block and the plane is 0.50. Determine the maximum value of P that can act on the block and still maintain equilibrium.

5-17. A homogeneous block 1 ft square by 3 ft tall weighs 100 lb. The block is supported by an inclined plane and the horizontal force P as indicated in Fig. P 5-17. The coefficient of friction between the block and the plane is 0.50. Determine the maximum value of P that can act on the block and still maintain equilibrium.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.23P: The 40-lb spool is suspended from the hanger GA and rests against a vertical wall. The center of...

See similar textbooks

Similar questions

The coeffient of static friction between the uniform bar AB of weight W and the ground is 0.45. Find the smallest angle and the corresponding force P that would initiate simultaneous tipping and sliding of the bar.
The leather rein used to fasten the horse to the hitching rail weighs 3.5 oz per foot. The coefficient of static friction between the rail and the rein is 0.6. If a 34-lb force acting on the bridle is sufficient to restrain the horse, determine the smallest safe length L for the free end of the rein.
The screw of the clamp has a square thread of pitch 0.16 in. and a mean diameter of 0.6 in. The coefficient of static friction between the threads is 0.4. Determine (a) the torque C0 that must be applied to the screw in order to produce a 28-lb clamping force at A; and (b) the torque required to loosen the clamp.
Two identical chairs, each weighing 14 lb, are stacked as shown. The center of gravity of each chair is denoted by G. The coefficient of static friction is 0.2 at B (the contact point between the chairs) and 0.35 at A, C, and D. Determine the smallest force P that would cause sliding.
The 40-lb spool is suspended from the hanger GA and rests against a vertical wall. The center of gravity of the spool is at G and the weight of the hanger is negligible. The wire wound around the hub of the spool is extracted by pulling its end with the force P. If the coefficient of static friction between the spool and the wall is 0.25, determine the smallest P that will extract the wire.
The square-threaded screw 0f the C-clamp has a mean diameter of 8 mm and a pitch of 1.6 mm. The coefficient of static friction between the threads is 0.2. If the torque C=1.50Nm is used to tighten the clamp, determine (a) the clamping force; and (b) the torque required to loosen the clamp.
A homogeneous block of weight W rests upon the incline shown in the figure. If the coefficient of friction is o.30, determine the greatest height h at which a force P parallel to the incline may be applied so that the block will slide up the incline without tipping over. 40 cm 80 cm
The crate has a weight of 490 lb and a center of gravity at G rests on the floor for which the coefficient of static friction is equal to 0.3. If the force P = 200 lb is applied as shown in the figure below. The force of friction developed between the crate and the ground is. -2 ft --2 ft- 4 ft 3 ft A. Figure 1 Select one: a. 601 lb b. 610 lb
The crate has a weight of 490 lb and a center of gravity at G rests on the floor for which the coefficient of static friction is equal to 0.35. If the force P = 300 lb is applied as shown in the figure below. The static friction force developed between the crate and the ground is. -2 ft. 2 ft -2 ft- 2 ft 4 ft 3 ft A Figure 1 Select one: O a. 234.5-Ib O b. 300-lb O c. 240-lb O d. 610 lb 3.
A vertical force P exerted on a lever AB holds a 20 kg mass M from falling, as shown in Fig 9-42. The coefficient of friction between the lever and the 300 mm drum is 1/4. Neglect the mass of the drum and lever, and determine the force P to hold the mass. Give soulution. (ans. P = 327 N)
The crate, which has a mass of 140 kg, is subjected to the action of the three forces shown in the figure. If it is originally at rest, determine the friction force when P1 = 750 N, P, = 900 N, P3 = 500 N and 0 = %3D %3D 25°. Assume the coefficient of kinetic friction between the crate and the surface is Hk = 0.40. P2 P1 P3 Select one: a. 260.15 N b. 161.84 N c. 315.34 N d. 457.76 N
QUESTION 1 The centre of gravity for the ladder (mass = 10 kg) acts at point G as shown in the figure. Given the B 0.4 m coefficient of statics friction between the floor and the ladder is HA = 0.3 and between the wall and the ladder is Hg = 0.2. Find the mass of the ball, m if the ladder set-up is just about to slide. 0.8 m G SOALAN 1 Pusat graviti bagi tangga (mass = 10 kg) bertindak pada titik G seperti yang ditunjukkan di dalam m gambarajah. Diberi angkali geseran statik di antara lantai dan tangga adalah Ha = 0.3 dan di antara 70° A dinding dan tangga adalah ug = 0.2. Cari jisim bagi D bola, m sekiranya tangga dalam keadaan untuk mula menggelongsor.