47. See Multiple-Concept Ex- ample 12 to review some of the Pulley concepts that come into play here. The crane shown in the drawing is lifting a 180-kg crate upward with an acceleration of 1.2 m/s?. The cable from the Drum Вoom crate passes over a solid cylindri- cal pulley at the top of the boom. The pulley has a mass of 130 kg. The cable is then wound onto a hollow cylindrical drum that is mounted on the deck of the crane. The mass of the drum is 150 kg, and its radius is 0.76 m. The engine applies a counterclockwise torque to the drum in order to wind up the cable. What is the magnitude of this torque? Ignore the mass of the cable.

47. See Multiple-Concept Ex- ample 12 to review some of the Pulley concepts that come into play here. The crane shown in the drawing is lifting a 180-kg crate upward with an acceleration of 1.2 m/s?. The cable from the Drum Вoom crate passes over a solid cylindri- cal pulley at the top of the boom. The pulley has a mass of 130 kg. The cable is then wound onto a hollow cylindrical drum that is mounted on the deck of the crane. The mass of the drum is 150 kg, and its radius is 0.76 m. The engine applies a counterclockwise torque to the drum in order to wind up the cable. What is the magnitude of this torque? Ignore the mass of the cable.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Item 11 The pulley in (Figure 1) has radius 0.160 m and moment of inertia 0.380 kg - m². The rope does not slip on the pulley rim. Figure 4.00 kg 5.00 m 2.00 kg 1 of 1 Part A V = Use energy methods to calculate the speed of the 4.00 kg block just before it strikes the floor. Express your answer with the appropriate units. μÀ Value Submit Request Answer
A uniform drawbridge must be held at a 37° angle abovethe horizontal to allow ships to pass underneath. The drawbridge weighs45,000 N and is 14.0 m long. A cable is connected 3.5 m from thehinge where the bridge pivots (measured along the bridge) and pullshorizontally on the bridge to hold it in place. What is the angular speed of the drawbridge as it becomes horizontal?
9. A horizontal 800-N merry-go-round of radius 1.50 m is started from rest by a constant horizontal force of 50.0 N applied tangentially to the merry-go-round. Find the kinetic energy of the merry-go-round after 3.00 s. (Consider the merry-go-round to be a solid cylinder in determining its moment of inertia). Answer: 276 J
An engineer trying to determine whether her crane will tip over when attempting to lift a 19K load. Her crane has a 15K chassis and 45K counterweight. Assume all 5ft other parts of the crane have negligible weight. Answer all questions relative to the rotation point. XXX XXX How much torque is caused by the load? unit How much torque is caused by the chassis? unit v How much torque is caused by the counterweight? unit BARNHART weight What is the normal force on the rear (right) outriggers? unit v What is the normal force on the front (left) outriggers? unit v finalize check answers cannot be determine (after completing ALL problems) 15: torque, challenge nos Scientific Online Calculator Chp
Computation. Consider a frictionless flywheel in the shape of a uniform solid disk of radius 1.8 m. Calculate its mass if it takes 7.3 kJ of work to spin up the flywheel from rest to 548 rpm. [Tip: Be careful with units.] M = kg O Search Record your numerical answer below, assuming three significant figures. Remember to include a "-" as necessary. Ca 4 @
2.0 kg 4.0 kg d 2.0 m The wooden beam has a mass of 20 kg. What is the distance d that balances the seesaw? 2.0 m 5.0 kg
A stone is suspended from the free end of a wire that is wrapped aroundthe outer of a pulley as shown. The pulley is a solid cylinder with mass 10.0 kgand radius 30.0 cm. You measure that the stone travels 12.6 m in the first 3.00s starting from rest. What is (a) the tension in the wire and (b) the mass of thestone?
I am not sure how to solve this
(a) Calculate the force (in N) the woman in the figure below exerts to do a push-up at constant speed, taking all data to be known to three digits. (You may need to use torque methods from a later chapter.) N 0.88 m m = 56 kg CG W 1.46 m W Freaction (b) How much work (in J) does she do if her center of mass rises 0.180 m? (c) What is her useful power output (in W) if she does 24 push-ups in 1 min? (Should work done lowering her body be included? See the discussion of useful work in Work, Energy, and Power in Humans.)
A simple pendulum consists of a small object of mass 3.0 kg hanging at the end of a 2.0-m-long light string that is connected to a pivot point. (a) Calculate the magnitude of the torque (due to the force of gravity) about this pivot point when the string makes a 8.0° angle with the vertical. N.m (b) Does the torque increase or decrease as the angle increase? increase O decrease Explain.
Arithmetic question. Write only the final value of the answer. Suppose you did the rotational dynamics labs with a 200g solid sphere. The sphere was placed at rest at the 100cm mark on the track which is inclined at 150 angle with the table. What is the translational kinetic energy in (J) of the sphere as it leaves 0 mark of the track? Write your answer with TWO decimal places.
26. A yo-yo can be thought of a solid cylinder of mass m and radius r that has a light string wrapped around its circumference (see below). One end of the string is held fixed in space. If the cylinder falls as the string unwinds without slipping, what is the acceleration of the cylinder? AT mg