4000 Fig 1 shows a reinforced concrete slab 7mx 4.5m & 220mm thick, supported by two steel beams (Beam A). The Beams span 7 metres, and are supported on steel columns as shown in fig1. Assume a live load of 4 kPa Calculate. (a) The design load carried by the slab in kN/m² www (b) Design load carried by the beam in kN/m and draw a loading diagram for the beam. Draw SFD and BMD for the beam (c) Design axial load carried by each column in KN. wivin Beam A(360UB57) Beam A(360UB57) 8000 Fig 1 4000 Section A-A 200

Q: For the beam shown in Figure (2), given INA = 1.25 106mm, calculate the following: 1) Flexural…

A: Determine  1. Flexural stress at point-A on the section at midspan of the beam.  2. Maximum absolute…

Q: We constructed a half bridge with two strain gauges in order to capture the effect of maximum normal…

A:

Q: The steel beam has the cross section shown. The beam length is L = 6.7 m, and the cross-sectional…

A: L = 6.7 m d = 355 mm bf = 205 mm tf = 13 mm tw = 9 mm

Q: A beam has a cross-section that is 11inches tall and 4inches wide. If the max shear in the beam is…

A: Given Load 8 kipsDepth 11 inWidth 4 inTo find out Maximum shear stress

Q: FIGURE 3 shows the cross-section of a reinforced concrete column. The column is 4.8m high, is…

A: Given Length of column , L=4.8m Diameter of reinforcement, d=32mm Axial load ,P=2.4MN Side length of…

Q: Q1) A cantilever reinforced concrete beam with rectangular section (as shown in Fig. 1) carries a…

A: P = 30KN W = 20KN/m For finding moment capacity in cracked section we have to remove steel and…

Q: g stress (in MPa, numerical value only) of the beam shown below with the given cross section. For…

A: Maximum moment :Mmax=-F1a+b+F2bMmax=-1.231.2+2.2+6.392.2=9.876 kN-m

Q: 2) A simply supported timber beam with a rectangular cross-section has been loaded perpendicular to…

A: The loading will produce bending moment and shear force in the beam. The bottom of the beam will be…

Q: Determine the maximum tensile and compressive bending stress developed in the beam.

A: ##Calculation  Maximum Tensile and Compressive Bending stress ####

Q: A homogenous rigid block subjected to the loading shown in figure is supported by three steel rod…

A: Given:Diameter of three rod is 25 mm To find:- Stress in each rod

Design criteria for structural loading

The different loads such as loads due to self-weight (dead load) and external loads such as live load, wind loads, seismic load, snow load, and other loads and load combinations that influence the design of a building are called structural loading. The nature of the applied load differs from changes in the location, design, and type of materials used. The design criteria require that structures must be designed and constructed to be able to withstand all load types that are expected to act upon the structure and render its usage for the designated purpose. The structural members such as beams, slabs, columns, and foundations help the structure to withstand the applied load. There are different institutes such as ASCE and ACI that provide building design codes to assure minimum safety requirements and quality of the structures.