4. Static. Draw FBD for each mass including the scale. 5 kg 30° 5. Block slides up. 50 P 6. Draw FBD for the car which is moving at constant speed 60.0 50,0

Q: The uniform 71-kg slender bar is initially at rest on a smooth horizontal plane when the forces are…

A:

Q: B A 20cm Figure 1. Sketch of the problem. The 20 kg disc A is attached to the 10 kg block B using…

A: To Find : (a) If the disk rolls without slipping, determine its angular acceleration and the…

Q: The free body diagram below shows the forces acting on the bob when it spins at a rate such that it…

A: GivenFS=string force Fe=Elastic force W=weight of the bob

Q: A luggage handler pulls a 20.0 kg suitcase up a amp inclined at 32.0° above the horizontal by a…

A:

Q: A block is being pushed on a flat surface of magnitude 45N. The force of friction on the brick is 13…

A:

Q: AW-16-lb weight block is lifted vertically by a force of F-27 lb. Determine its acceleration. (Hint:…

A:

Q: A block of mass M = 539.0 g sits on a horizontal tabletop. The coefficients of static and kinetic…

A:

Q: Q.1) Draw a Free Body Diagram for each object indicated below. Include values for known forces and…

A: (a) Draw the given diagram.

Q: The internal and external diameter of the impeller of a centrifugal pump are 200 mm and 400 mm…

A: The impeller of a centrifugal pump has initial and exterior diameters of 200 mm and 400 mm,…

Q: FIGURE BELOW shows the car having a mass of 1.40 Mg and a center of mass at Gc pulls a loaded…

A:

Q: # B A 20cm Figure 1. Sketch of the problem. The 20 kg disc A is attached to the 10 kg block B using…

A:

Q: 3. Two masses are attached by a string. Mass M hangs freely while mass m is on an incline of 30°. M…

A:

Q: The diameter of two pulleys are (0.3m)and (0.2m), center distance (1m).if we use open belt drive.…

A: The diagram of the V-belt drive (open belt) is given as, The diameters of two pulleys are given as,…

Q: 2. The cart shown below has a total mass of 134 kg. Its center of gravity is located at Point G.…

A: Total mass = 134 Kg P = 632N

Q: 2. Two men are sliding a 120-Kg crate up an incline. If the lower man pushes horizontally with a…

A:

Q: 1.0m 3.0m 0.5m mi PA N, 5. The drawing above shows two objects on a board supported at two…

A: Given: m1=40kgm2=20kgm3=10kg…

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.