4) Calculate the voltage Vx and the current through the coil in the circuit below. (For t=0, it is known as i=2 A.) 2H ww 10 +Vx. 20 2 Vx 60 ww

Q: Determine the values of resistance R and inductance L

A: We need to determine the values of R and L.

Q: Connecting an ammeter and voltmeter to a series Resistive Capacitive circuit powered by a 60 Hz line…

A: Resistance and capacitor circuit Connecting an ammeter and voltmeter powered by a 60 Hz line…

Q: Three 47.1 ohm resistors and three 17.1 H inductors are all in series with a 37 volt battery and a…

A:

Q: 4. Draw the ouput voltage waveforms.

A:

Q: The voltage and current at the terminals of the circuit element in (Figure 1) are zero for t 0 they…

A: For an element, the voltage and current equation for time t≥0 are given byv(t)=80te−500t…

Q: ure below, the voltage reading of the multimeter (Pr simulation VO 11 R2 =8 mA R=3 k Ol

A:

Q: current of 1 = -6 + 8 12 sin (wt + 30) is passed through a cen I

A: I= -6+82sinωt+30°A PMMC meter reading=? moving iron meter reading=?

Q: Calculate the power and voltage of the dependent source in the circuit below. 150 6 A 0.9 4 A ww

A:

Q: A coil is wound with 500 turns. When a current of 4 A flows the total flux threading the coil is…

A:

Q: 2000 2000 200 Vs Figure Q3(a)

A: Given:  Brief description: In the above given system they want to know the transfer function of the…

Q: Three coils each having resistance of 29 N are connected in star across 400 V, 50 Hz supply. Then…

A: In this question we need to find a total power loss of a coil when it is connected in star .

Q: use the kvl formula and draw its schematic diagram

A:

Q: A voltage v = 100.sin (180t-30 °) was applied to a coil of L = 300mH. What is the equation for the…

A: In this answer we will find the current flowing through the inductor as shown below.

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.