37. Eat your kale: Kale is a type of cabbage commonly found insalad and used in cooking in many parts of the world. Sixmeasurements were made of the mineral content (in percent) ofkale, with the following results.26.1 17.5 15.4 16.4 15.1 12.8It turns out that the value 26.1 came from a specimen that theinvestigator forgot to wash before measuring.a. The data contain an outlier that is clearly a mistake.Eliminate the outlier, then construct a 95% confidenceinterval for the mean mineral content from the remainingvalues.b. Leave the outlier in and construct the 95% confidenceinterval. Are the results noticeably different? Explain why itis important to check data for outliers.Source: Journal of Nutrition 66:55–66

Given data: To construct 95% confidence interval 1. By eliminating outliers 2. By considering…

Answered: 37. Eat your kale: Kale is a type of…

MATLAB: An Introduction with Applications

6th Edition

ISBN:9781119256830

Author:Amos Gilat

Publisher:Amos Gilat

Chapter1: Starting With Matlab

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Plot the data on the given graph paper. Consider what should go on the X and Y axes.
c?
Trace metals in drinking water affect the flavor and an unusually high concentration can pose a health hazard. Ten pairs of data were taken measuring zinc concentration in bottom water and surface water. Bottom 0.430 0.266 0.567 0.531 0.707 0.716 0.651 0.589 0.469 0.723 Surface 0.415 0.238 0.390 0.410 0.605 0.609 0.632 0.523 0.411 0.612 With the help of Mathematics and R Studio: Does the data suggest that the true average concentration in the bottom water is different than that of surface water? You can assume that the conditions for inference are met.
- TABLE 6E.2 Bearing Diameter Data Sample Number i Sample Number R 1 34.5 3 13 35.4 8. 2 34.2 4 14 34.0 6 3 31.6 4 15 37.1 5 4 31.5 4 16 34.9 7 5 35.0 5 17 33.5 4 34.1 6. 18 31.7 3 7 32.6 4 19 34.0 8. 8 33.8 3 20 35.1 4. 9. 34.8 7 21 33.7 2 10 33.6 8 22 32.8 1 11 31.9 3 23 33.5 3 12 38.6 9 24 34.2 2 inside diameter of the bearing, with only the last three decimals recorded (i.e., 34.5 should be 0.50345). (a) Set up ī and R charts on this process. Does the process seem to be in statistical control? If nec- essary, revise the trial control limits. (b) If specifications on this diameter are 0.5030 ± 0.0010, find the percentage of nonconforming bearings produced by this process. Assume that diameter is normally distributed.
You have been hired to measure the concentration of ammonia in water from wells at two districts on Long Island. After sampling 10 wells in one of the districts you find the values are, in mg/L: 6.4, 2.1, 1.4, 0.7, 6.8, 3.2, 2.7, 1.6, 4.9, 1.2. Your assistant plots the data from the second set of wells and the histogram of data from that sample looks pretty much the same as for your data set. Which statistical test do you anticipate that you will use? An one-sample t-test An unpaired, two-sample t-test A paired, two-sample t-test A one-way anova A Mann-Whitney U test Main Content
No tortilla chip aficionado likes soggy chips, so it is important to find characteristics of the production process that produce chips with an appealing texture. The following data on x = frying time (sec) and y = moisture content (%) appeared in an article. x 5 10 15 20 25 30 45 60 y 16.4 9.7 8.1 4.2 3.3 2.8 2.0 1.2 (a) Construct a scatter plot of y versus x. y 15 10- 5 y 15 O 10 10 20 30 40 50 5 10 20 10 NE X 50 60 30 60 40 X 15 y 10 O 5 O y 15 10 20 30 40 50 60 10 20 30 Comment. The plot has a curved pattern. A linear model would not be appropriate. O The plot has a curved pattern. A linear model would be appropriate. O The plot does not have a curved pattern. A linear model would be appropriate. O The plot does not have a curved pattern. A linear model would not be appropriate. 40 50 60 X X
1.8 A Canadian manufacturer identified a critical diameter on a crank bore that needed to be maintained within a close tolerance for the product to be successful. Sam- ples of size 4 were taken every hour. The values of the differences (measurement - specification), in ten- thousandths of an inch, are given in Table 1.4. (a) Calculate the central line for an X-bar chart for the 24 hourly sample means. The centerline is x = — . . . (4.25 -3.00 -1.50 +3.25)/24. = (b) Is the average of all the numbers in the table, 4 for each hour, the same as the average of the 24 hourly averages? Should it be? (c) A computer calculation gives the control limits LCL = -4.48 UCL 7.88 = Construct the X-bar chart. Identify hours where the process was out of control.
Systolic coefficients of variation are 14.2% and the Diastolic is 17% The coefficients of variation for each data set are: a. more than 5 percentage points apart b. within 5 percentage points of each other Therefore, the systolic measurements vary a. about the same as b. significantly more than c. significantly less than the diastolic measurements.
Periodically, the county Water Department tests the drinking water of homeowners for contaminants such as lead and copper. The lead and copper levels in water specimens collected in 1998 for a sample of 10 residents of a subdevelopement of the county are shown below. lead (g/L) 2.9 0.2 5.1 4.2 5.5 1.2 0.133 0.774 0.214 0.671 0.444 0.234 0.357 0.761 0.176 0.888 (a) Construct a 99% confidence interval for the mean lead level in water specimans of the subdevelopment. OSMOSO copper (mg/L) 0.3 1.3 4.9 1.7 (b) Construct a 99% confidence interval for the mean copper level in water specimans of the subdevelopment. OSHSO
b?
A?
could you write with a pen and paper?

SEE MORE QUESTIONS

Recommended textbooks for you

MATLAB: An Introduction with Applications

Statistics

ISBN:

9781119256830

Author:

Amos Gilat

Publisher:

John Wiley & Sons Inc

Probability and Statistics for Engineering and th…

Statistics

ISBN:

9781305251809

Author:

Jay L. Devore

Publisher:

Cengage Learning

Statistics for The Behavioral Sciences (MindTap C…

Statistics

ISBN:

9781305504912

Author:

Frederick J Gravetter, Larry B. Wallnau

Publisher:

Cengage Learning

MATLAB: An Introduction with Applications

Statistics

ISBN:

9781119256830

Author:

Amos Gilat

Publisher:

John Wiley & Sons Inc

Probability and Statistics for Engineering and th…

Statistics

ISBN:

9781305251809

Author:

Jay L. Devore

Publisher:

Cengage Learning

Statistics for The Behavioral Sciences (MindTap C…

Statistics

ISBN:

9781305504912

Author:

Frederick J Gravetter, Larry B. Wallnau

Publisher:

Cengage Learning

Elementary Statistics: Picturing the World (7th E…

Statistics

ISBN:

9780134683416

Author:

Ron Larson, Betsy Farber

Publisher:

PEARSON

The Basic Practice of Statistics

Statistics

ISBN:

9781319042578

Author:

David S. Moore, William I. Notz, Michael A. Fligner

Publisher:

W. H. Freeman

Introduction to the Practice of Statistics

Statistics

ISBN:

9781319013387

Author:

David S. Moore, George P. McCabe, Bruce A. Craig

Publisher:

W. H. Freeman

SEE MORE TEXTBOOKS