300 Ib/ft 3. Six nails are used to hold the hanger at A against the column. Determine the minimum required diameter of each nail to the nearest 1/16 in. if it is made of material having 7fail = 16 ksi. Apply a factor of safety of F.S. = 2 against shear failure. IB -9 ft

Q: If load P = 20.1 kips, determine the normal force in bar (1). A 6 ft 46.6 kips 39.5 kips 33.5 kips…

A:

Q: Member B is subjected to a compressive force of 800 lb. If A and B are both made of wood and are 1.8…

A: Given Data: The compressive load to member B is, P=800 lb. The thickness of materials is, t=1.8 in.…

Q: The way to the column where the loading status is seen determine the P load required for the 5 mm…

A: Given that,

Q: A-2 Determine the vertical displacement of joint C.Assume e members are pin connected at their end…

A: A = 200 mm²   E = 200 Gpa

Q: The pin is made of a material having a failure shear stress of tfail = 100 MPa. Determine the…

A: Given: The allowable shear strength of the pin, τ = 100 Mpa The factor of safety, F.S. = 2.5 The…

Q: Q2// The control arm is subjected to the loading shown in Fig.2. Determine the required diameter of…

A:

Q: Q2/ Determine the maximum allowable load P that can be safely suppom 1.5 in. and b-4 in. The wood…

A: t=1.5inb=4inσfail=2ksiζfail=2ksiFOS=1.5   To-Find:- P=?

Q: The five-bolt connection must support an applied load of P = 1500 lb. If the average shear stress in…

A:

Q: The boom is supported by the winch cable that has an allowable normal stress of allow = 24 ksi. It…

A:

Q: how can we determine these values if not given in the problem?

A:

Q: arked a---a. Just at this si

A: given:

Q: A link in a mechanism is made from round bar. Due to the loading condition, the link is subject to a…

A: Maximum stress is 68 MPa Minimum stress is -27 MPa Required: Alternating stress

Q: sectional area of Arod = 0.75 in². If a load of P = 24 kip is applied to the end of rod, determine…

A:

Q: diameter brass rod. In order to reduce the weight of the member by 25%, the solid rod is replaced by…

A:

Q: As a machinist presses the handles of the compound action bolt cutters, link AB carries a 7.2 kN…

A:

Q: The linkage is made using two A-36 steel rods, each having a circular cross section. Determine the…

A: Consider the FBD of the system at joint B given which shows the angle between the rods and the rope.

Q: 1,200 N-m 4,500 N-m 2,800 N-m 500 N-m (3) B 0.70 m 1.80 m 0.70 m Complete the torsion diagram of rod…

A: