the specific3.2.5 Calculate the precipitable water (mm) in a 10-km-high saturated atmospheric20°C,pressure101.3 kPa,column if the surface conditions are temperatureand the lapse rate is 6.5°C/km.ten of D-10www.comm20 30 and 40°C and plot a

Answered: Image /qna-images/answer/f3d99598-ba9d-437f-b540-79488b0cf464.jpg

Answered: 3.2.5 Calculate the precipitable water…

3.2.5 Calculate the precipitable water (mm) in a 10-km-high saturated atmospheric column if the surface conditions are temperature = 20°C, pressure 101.3 kPa, and the lapse rate is 6.5°C/km. 1080

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: To solve the question use table and equation on the photo. (Answers: 2.035*10^6 m^3 , 2.169*10^6…

A: At first we have to calculate delta of the different crops. Then we will calculated the consumptive…

Q: An experiment is conducted for infiltration rate under the ponding condition in a soil field and it…

Q: The hydraulic residence time of the conservative PFR shown below is 72 minutes. At time te0, the…

Q: Q1-4/ Weight of collected salts by evaporation from 50 (m³) of seawater 2.5 (Ton). Calculate value…

A: Weight of salt collected W=2.5x1000=2500 kgVolume V=50 x 1000 =50000kg

Q: 1. A permeable soil layer is underlain by an impervious layer, as shown in the figure below. With…

A: Step 1

Q: Estimate the capillary soil suction using the Green-Ampt equation

A: Given, t = 3.5 hrs L = 40 cm or 0.4 m η = 0.20 i = 2.5 cm/hr

Q: Saturated Surface Dry Weight = 3650.3 g Oven Dry Weight = 3625.5 g Submerged Weight = 2293.0…

Q: Calculate the settling velocities for particles with the following dimensions: a. Diameter=500 μm,…

A: Solution: 1: 2:

Q: Calculate the value of pressure ∆p onside the rain water droplet , if we know the radius R=0.2mm and…

A: GIVEN- r=0.2mm δ=0.074N/m=7.4×10-5N/mm2∆P=?

Q: A canal and a stream run parallel to each other at a separation distance of (500 + 50f) m. Both of…

A: Solution Given data Thickness of sand layer=6' Permeability of sand=2*10−3ftsec

Q: 1. In undisturbed air stream, where the pressure is 14.7 psi and density is 101325Pa, where the…

Q: An experiment is conducted for infiltration rate under the ponding condition in a soil field and it…

Q: Q1)) The reservoir has the following data: Evaporation by mass transfer = 4.5 mm/day Emitted solar…

A: Given- Evaporation by mass transfer = 4.5 mm/day Emitted solar radiation = 7.25 MJ/m2.day…

Q: Pressure in a pipe carrying oil (Specific Gravity 0.92) is 20 kN/m². A piezometer is connected to…

A: Given data : Pressure (P)=20 KN/m2Specific gravity (S.G)=0.92Density of water (ρWater)=1000 kg/m3

Q: A closed container contains 1.8m of oil (SG = 0.8) and above the oil, the absolute air pressure is…

Q: Solve the infiltration loss bounded at t1 = 15 min to t2 = 25 min for exponential function and t1 =…

Q: The average weather conditions are; Net radiation Air Temperature Relative Humidity Wind speed…

A: Net radiation = 100 W/m2 Temperature = 25°C Relative humidity = 55% Wind speed = 2.7 m/s Height = 2…

Q: A tank of surface area 22m² contains water up to a depth of 5.8m. What will be : i) Weight of water…

A: Area =22m2 depth =5.8m

Q: Q2// oil formation volume factor 1.25, reservoir bulk volume 180000 acre.ft Calculate; Water Depth…

Q: Using Energy Balance Method

A: As Energy balance method is highlighted hence solving for that only.assuming sensible heat flux Hs…

Q: for the constant hea permeability test set-u shown in the following figure, the followin…

A: L =30 mArea if specimen = 175 sq. cm.Constant head difference = 50 cmVolume of water collected in 5…

Q: .4: The water table is 15 m below the surface of a clay layer (Gs = 2.6), and the position of the…

A: Given:- Gs=2.6 evaporation rate =0.7 x 10 -4 m/day e=2.36 unit weight of water = 1000 kg/m To find:-…

Q: At 100°C of temperature, 3.5 atm vapour pressure of water is equivalent to: 1. 350.0000 kPa 2.…

A: Given data- Temperature T=100oCVapour pressure VP=3.5 atmTo Find-Vapour pressure of water Equivalent…

Q: If raw water having dynamic viscosity μ=0.001519N⋅s/m2 flows at rate of 30,000 m3/d into a rapid…

A: Rapid Mix Tank: A rapid mixing tank is used to treat the water by removing impurities in it. The raw…

Q: A permeable soil lay 6*10 cm/sec for the Calculate the rate of

Q: At a given location the ground level temperature is (a) 60°F and (b) 57°F while the normal maximum…

Q: A monomedia filter 0.75 m deep contains sand with an effective size of 0.55 mm. The sand has a…

A: Given, Thickness of sand (L) = 0.75m Effective diameter (d) = 0.55 mm or 0.00055m To Find: Head…

Q: The average weather conditions are; = 100 W/square meter = 25 deg. C = 55% Net radiation Air…

Q: Question 12 Calculate in centimeters per second the settling velocity for a spherical particle with…

Q: In Horton's infiltration equation fitted to data from a soil, the initial infiltration capacity is…

Q: 6- data? What is the precipitable water in mm in the given atmospheric profile - P = 600mb, z = 4068…

A: P = 600mb, z= 4068 m, p=0.0003 kg/m³P = 700mb, z = 2888 m, p=0.0017 kg/m³P =…

Q: 4. During a rainstorm, you measured 3 cm³/hr of water discharging from a 100 cm² cross section at…

A: Given Data : Discharge (Q)= 3 cm3/hr Area (A)=100 cm2 Hydraulic conductivity (K)=3×10-4 cm/s Length…

Q: vertical 150 mm pipe leaves a water tank of surface elevation 24. Between the tank and elevation 12,…

A: Fluid flow rate measurements are a related application of Bernoulli's principle. The Venturi effect…

Q: The initial infiltration capacity of the soil is 0.0386cm per min. the time constant as 10.18 per…

Q: answer the question from the image

A: I'll guide you through calculating the infiltration capacity for each time interval, plotting the…

Concept explainers

Evaporation

This topic is majorly taught in various undergraduate and postgraduate degree courses of:

Question

the specific
3.2.5 Calculate the precipitable water (mm) in a 10-km-high saturated atmospheric
20°C,
pressure
101.3 kPa,
column if the surface conditions are temperature
and the lapse rate is 6.5°C/km.
ten of D
-
10
www.comm
20 30 and 40°C and plot a

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 : Data

Step 2

Step 3

Step 4

Step 5

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

If at 20°C, a droplet of water has pressure difference of 5 kPa, then at same temperature, a cylindrical jet of water having diameter twice as diameter of spherical droplet, will have pressure difference equal to КРа.
Q2) For a small area: F,=6 cm/hr Fc=1.2 cm/hr (at end of 8 hours) Total of infiltrated water during the (8) hrs. period was (15) cm. Estimate the value of (K).
Find the number of degrees in the angle formed by the two parts of thisA-type evaporator coil.
Use three decimal places when rounding off.
As the depth chnges negatively means decreasing , can you please explain what are some measures to reduce the evaporation as to reduce the decreasing depth
Q1) The reservoir has the following data: Evaporation by mass transfer = 4.5 mm/day Emitted solar radiation 7.25 MJ/m2.day Shortwave radiation reflection from water body 5.2 MJ/m2.day - Albedo = 0.723 Longwave radiation backed to the atmosphere 1.65 MJ/m2.day Air temperature 25 °C Water temperature 10 °C %3D %3D Bown's ratio = 0.7 y = 0.066 kPa/°C Calculate the evaporation by using Penman's equation?
8- A permeable soil layer is underlain by an impervious layer, as shown in Figure7.28. With k= 5.2 x 104 cm/sec for the permeable layer, calculate the rate of seepage through it in m³/hr/m length if //= 3.8 m and a= 8º, 72 Groundwater table (free surface) Impervious layer Ground surface Direction of seepage
The wind speed over a Lake was estimated to be 9 m/s , the saturation vapor pressure was estimated 1.5 kPa. and the vapor pressure in overlying air, 0.6 kPa. The monthly evaporation is a. 24.5 cm b. 39.6 сm с. 29.6сm d. 19.6 cm
A soil has an EC of 4 dS/m. At field capacity the total water potential at reference level will be. .bar O a. -1.74 O b. 1.74 O c. 1.14 O d. -11.4 O e. -14.7
instantaneous infiltration rate can be estimated by the equation, f= 0.5(a / +0.5) + b, where 'a' and 'b' are constants and 't' is the time elapsed from the beginning of the storm. find total infiltration during 10 hours if a=5 mm/hº.5 and b = 10 mm/h.
Calculate the monthly average evaporation from the open water surface using the Penman method according to the following July (31 days) Oh Latitude monthly average temperature Actual daylight hours (n) Sunny hours of the day, E (July, 25 Degrees North Wind speed Reflection coefficient of the water surface Relative gender (%) RA (July, 25 Degrees North O psychrometer constant Saturated vapor pressure at 22 degrees Saturated vapor pressure at 22.1 degrees 25 Degrees North at 22 degrees. 115 sec 13.5 sec 1.8 m/sn 0.07 70 920 gr*cal/cm²/gun 117.74*10-9 (gr*cal/cm²/gun) 0.66 mb/C° 19.82 mmHg 19.94 mmHg Translated with Google Lens
A pump can lift water at a discharge of 0.15 m³/s to a head of 25 m. The critical cavitation number (o) for the pump is found to be 0.144. The pump is to be installed at a location where the barometric pressure is 9.8 m of water and the vapour pressure of water is 0.30 m of water. The intake pipe friction loss is 0.40 m. Using the minimum value of NPSH (Net Positive Suction Head), the maximum allowable elevation above the sump water surface at which the pump can be located is