4. During a rainstorm, you measured 3 cm³/hr of water discharging from a 100 cm² cross section at the base of a stream bank. The bank is made of glacial till with a hydraulic conductivity of 3 x 10-4 cm/s. What would the water table elevation (relative to the base of the stream bank) have been 15 m away from the stream bank to the nearest centimeter?

4. During a rainstorm, you measured 3 cm³/hr of water discharging from a 100 cm² cross section at the base of a stream bank. The bank is made of glacial till with a hydraulic conductivity of 3 x 10-4 cm/s. What would the water table elevation (relative to the base of the stream bank) have been 15 m away from the stream bank to the nearest centimeter?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Refer to the cross section of the earth dam shown in the figure. Calculate the rate of seepage through the dam (q in m3/ min / m) using L. Casagrande's method. K 5 m 1V: 2H 30 m 1V: 2H 25 m k = 3 x 10-4 m/min Impermeable layer Select the correct response: 5.91 x 103 m/min/m 2.37 x 103 m3/min/m 11.4x 104 m/min/m 29.5 x 104 m3/min/m
2
Calculate the effective hydraulic conductivity for flow parallel and perpendicular to layering. Please show and explain the difference in values.
Answers: a) 360 cm3/sec b) 1.12 c) 2.8 meters
NW NE 310 210 SW SE 1:10,000 4.5 cm If aquifer hydraulic conductivity and effective porosity are found to be 0.2 m/day and 0.25 respectively, how long (in years) will it take groundwater to travel from well 310 to well 210? 1 year = 365 days Answer: 200- -300
Soil Mechanics
The figure shows the cross section of a levee that is 500 m long and is underlain by a 2-m-thick permeable sand layer. It was observed that the quantity of water flowing through the sand layer into the collection ditch is 250 m³/day. What is the hydraulic conductivity of the sand layer? Elv. 160 m Levee 1 Elv. 150 m 2 m Ditch 125 m I Impervious O Sand
The seepage loss in cm?/sec for a hydraulic structure, if the flow net contains 5 flow lines and 9 equipotential lines and the head causing flow is 20 m, k= 2.6 x 106 cm/sec is:
A well in an unconfined aquifer is pumped at the rate of 50 L/s ( 800 gal/min.). The thickness of the aquifer is 30 m. and the elevation of the phreatic surface is 25 m. above the underlying aquiclude at an observation of well 20 m away from the well and 34.6 m above at a well 50 m. away. What is the value of K for this aquifer?
CALCULATION USING DARCY'S LAW 1) An aquifer has 2 piezometers installed (A and B) and the distance between them is 1km, the hydraulic loads are 850m and 625m respectively. The average hydraulic conductivity of the aquifer is 3.9 x 10-2 m/day and the effective porosity is 25%, calculate how long in years it takes for the water to walk between piezometer A and B.
The section of a concrete gravity dam with its flow net diagram is shown in Pigure 10.38. The coefficient of permeability of the soil (anistropic) in the vertical and horizontal directions are 0.25 m/day and 0.58 m/day, respectively. The length of dam perpendicular to the paper is 120 m. 1. Determine the number of pressure drops 2. Determine the seepage loss 3. Determine the total amount of water percolated in one year.
The soil under a dam consists of five layers as follows: Hydraulic conductivity (cm/hr) Layer Depth (m) 1 5 4.8 2 2 8.0 3 0.6 18.0 4 1.0 3.0 5 3.5 1 Calculate: v What is the average vertical (perpendicular to flow) hydraulic conductivity of the soil? V What is the transmissivity of the soil, given the water table is at the ground surface?