phy 3.2 A lossless 25- transmission line 2/8 in length is terminated in an unknown impedance. If the inputimpedance is Zin = +j759,(a) Use the Smith chart to find Z₁.(b) What fraction of wavelength for a short-circuit line could be used to replace Z₁?

Given: Zin = +j75 ohmsZo = 25 ohms (line impedance)To Find:(a) ZL (b) Fraction of wavelength for…

Answered: 3.2 A lossless 25- transmission line…

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter13: Transmission Lines: Transient Operation

Section: Chapter Questions

Problem 13.14P

See similar textbooks

Similar questions

A loss-less transmission line with characteristics impedance of 600 ohms is terminated in a purely resistive load of 900 ohms. The reflection coefficient is?
A 702 high-frequency lossless line is used at a frequency where 2 = 80cm with a load of 140+j91 2 a. Calculate the reflection coefficient and the SWR b. Determine the distance to the first voltage minimum from the load c. Determine the distance to the first voltage maximum from the load d. Calculate the impedance at the point where maximum voltages occur
How does inductance impact the performance of a transmission line in terms of signal integrity and power losses?
Q5:A terminated transmission line with ZO = 60 has a reflection coefficient at the load of I = 0.4 60° by using SMITH chart.a)What is the load impedance? (b) What is the reflection coefficient 0.3 away from the load? (c) What is the input impedance at this point, clarify your procedures in the SMITH chart?
5-A lossless T.L. has Zo = 100 Q and is loaded by ZL. The VSWR = 2. The first two voltage minima are located at z= -10 and -35 Cm from the load where z = 0. Determine ZL.
A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.9 Farad/meter, and 8 Henry/m inductance per meter. The diameter of the inner conductor as 0.8m, and the dielectric constant of the insulation as 4. Find the diameter of the outer conductor in cm. Assume the line is a lossless line?
Find the characteristic impedance and signal velocity for a transmission line consisting of two parallel strips with a width ω and a separation d. You can ignore fringing fields by assuming that they are sections of concuctors infinitely wide.
A lossless transmission line has Z₁ = 100 Q, terminated by an unknown impedance. The termination is found to be at a maximum of the voltage standing wave, and the Voltage Standing Wave Ratio (VSWR) is 5. The value of the terminating impedance is
A lossless T.L of 10.25m long with Z-50 2. The line is terminated in Zr=75+j7592. If the operating frequency is 150MHz and=10 volts, use Smith chart or equations to find: VS 1. The Vmax and V min. 2. The standing wave ratio (S). 3. The sending end impedance (Zs). 4. The sending end voltage and current. 5. The distance to the first maximum Zmax from the load.
A system has a forward power of 60 W, reflected power of 3 W, and transmission line loss of –3 dB. What will be the observed loss on the ground? A system has a forward power of 200 W and a reflected power of 15 W, what is the return loss?
5. Two cascaded lossless transmission lines are terminated by Z₁-2502, as shown below.. a) Calculate the reflection coefficient and the standing wave ratio at the load, i.e., the CC' terminal. b) Determine the characteristic impedance of the quarter-wavelength transformer, Zol, to match the cascaded line to a 6492 generator. B A- A'. Zol 11= 2/4 B' Zo2=75 92 12=32/4 C C ZL=2592
Why the Capacitance effect is neglected in Short Transmission Line.

SEE MORE QUESTIONS

Recommended textbooks for you

Power System Analysis and Design (MindTap Course …

Electrical Engineering

ISBN:

9781305632134

Author:

J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:

Cengage Learning