3.0 A uniform horizontal 300.0 N beam, 5.00 m long, is attached to a wall by a pin connection that allows the beam to rotate. Its far end is supported by a cable that makes an angle of 53.0 with the horizontal. If a 600.0 N person stands 1.50 m from the wall, find the tension in the cable and the force exerted by the wall on the beam. R 53.0° 300.0 N 600.0 N

3.0 A uniform horizontal 300.0 N beam, 5.00 m long, is attached to a wall by a pin connection that allows the beam to rotate. Its far end is supported by a cable that makes an angle of 53.0 with the horizontal. If a 600.0 N person stands 1.50 m from the wall, find the tension in the cable and the force exerted by the wall on the beam. R 53.0° 300.0 N 600.0 N

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

asap 5 mins
It is required to calculate the moment about point A for the following structure. A 120mm Moment about point A due to vertical component of 1.5kN force is 224.9 kN-mm CW 165 kN-mm CCVW 165 kN-mm CW 224.9 kN-mm CCW 200 mm
The 5 kg block A travels to the right at v, = 0.61 m/sec at the instant shown in the figure. If the coefficient of kinetic friction is f = 0.2 between the surface and A, determine the following: a. the velocity of block A when it has moved 1.2 m. Answer in m/sec. b. Acceleration of block A and B. Answer in m/sec2. c. Magnitude of the force in the cable connected at block A. Answer in Newton. Block B has a weight of 9 kg. B
Q3. A beam is supported by a pin support and a cable. The cable runs continuously through a pulley. Determine the manitude of the horizontal and vertical reactions at the pin support and the magnitude of the tension force in the cable. ///// \\ \ \ \\ 3 m 20° 20° 3 m 3 m 250 N
If the pulley can only carry a resultant force of 8kN acting 45 degrees below the x-axis. Determine the magnitudes of the belt forces, P and Q.
Determine the magnitude of the vertical force C, for the simply supported beam, where = 8 kips/ft, = 230 kip-ft, 4₁ = 11 ft, 4₂ = 4 ft, and 4₁ = 6 ft. 83.5kips 141.7kips 130.1kips 102.3kips 93.4kips W B L₂ L3 D
3. SOLVE AND DRAW THE SHEAR AND MOMENT DIAGRAM
The tower is held in place by three cables AB, AC, and AD. Another force of 440 lb is applied at A parallel to the X-axis. The force acting in each cable is shown. Determine the magnitude of the resultant force and its coordinate direction angles with respect to +Y and +X axes.
5. Answer the problem with a detailed solution
Question 3 in image
A winch at point B is used to slide a box up a chute CD in a warehouse. If the component of the force from cable AB in the direction of the chute must be 410 lb, determine the force in the cable for the position of the box given below. The chute is parallel to the xz 1 the distance up the chute plane. Neglect the size of the box and the winch. The box is from point C. 105in. Z B (-45, 0, 130) in. 135in. 40 in y FAB = lb