3. for drift current to pass through the semiconductor specimen a) the applied electric field above zero c) the carrier density gradient above zero b) the applied electric field equal to zero d) the carrier density gradient equal to zero

3. for drift current to pass through the semiconductor specimen a) the applied electric field above zero c) the carrier density gradient above zero b) the applied electric field equal to zero d) the carrier density gradient equal to zero

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter20: Electric Current, Resistance, And Ohm's Law

Section: Chapter Questions

Problem 9CQ: In which of the three semiconducting materials listed in Table 20.1 do impurities supply free...

See similar textbooks

Similar questions

Check Your Understanding Copper wires use routinely used for extension cords and house wiring for several reasons. Copper has the highest electrical conductivity rating, and therefore the lowest resistivity rating, of all nonprecious metals. Also important is the tensile strength, where the tensile strength is a measure of the force required to pull an object to the point where it breaks. The tensile strength of a material is the maximumamount of tensile stress it can take before breaking. Copper has a high tensile strength, 2108Nm2 A thirdimportant characteristic is ductility. Ductility is a measure of a material’s ability to be drawn into wires and a measure of the flexibility of the material, and copper has a high ductility. Summarizing, for a conductor to be a suitable candidate for making wire, there are at least three important characteristics: low resistivity, high tensile strength, and high ductility. What other materials are used for wiring and what are the advantages and disadvantages?
If two different wires having identical cross-sectional areas carry the same current, will the drift velocity be higher or lower in the better conductor? Explain in terms of the equation vd=1nqA by considering how the density of charge carriers n srelates to whether or not a material is a good conductor.
1- A current of 2 ụA is discharged on a capacitor with a plate area of 100 cm² and a capacitance of 1x10-7F at t=0. At what rate does the voltage between the plates change at t=0?A) 5V/sB) 20V/sC) 10 V/sD) 15V/sE) 25V/s
D.02)
If the current in a wire is doubled,
In a superconductor ( and sometimes on Star Trek) it is said “Resistance is Futile “. Interpret and apply this in terms of electrical properties of materials. What is a kilowatt-hour? When is it used of Joules? If an electrical circuit has junctions, do you have to use Kirchhoff’s rules to analyze it? Explain.
1. Calculate the potential due to a dipole as shown in the figure at positions A and B in millivolts. 2. What would be the potential at Bif the distance from the dipole center to B is doubled,. 3. What would be the potential at A if the intensity of the current source is doubled. +2mA B =12em F 10mm 20 degree 90 degree r95 cm A. Resistivity = 75 Ohm-cm -2mA Dipole
If the current in conductor is halved, what happens to?: electron drift velocity? current density average time interval between collisions? charge carrier density (Choose for each case) a. unchanged b. tripled c. halved d. doubled
Q3: 42. Find and graph the charge q(t) and the current i(t) in the LC-circuit in Fig. 151, assuming L 1 H, C = 1 F, v(t) = 1 - e-t if 0 T, and zero initial current and charge. v(t) Fig. 151. LC-circuit
2€0) defined by –1
Major Concepts - An object moving at a constant [Select] - A 10-kg object at rest that is 5 m above the ground will have a [Select] [Select] - equal to 0 J. will have a(n) [Select] - In projectile motion situations where air resistance is ignored, the The current through a [Select] [Select] of 0 m/s². equal to 500 J and a Electromagnetic radiation: Longer EM waves such as microwaves, radio, and infrared waves [Select] velocity (vx=Vox) is constant. circuit loop is the same everywhere and it doesn't get split at any junction. - Katie and Hasan have the same weight (60 N) and they run up the same flight of stairs that is 3 m high. Katie does it faster, though. Hasan used [Select] Katie because he took longer. shorter EM waves such as UV, x-rays, and gamma rays. - Freefall: If they are dropped from the same height and ignoring air resistance, a heavy object (such as a 350 kg piano) will fall to the ground [Select] a lighter object (such as a 15 kg television). - A 200 kg motorcycle moving…
3. Consider the case where the capacitor remains connected to the EMF while the dielectric is inserted. Note that the result that C² = *Coac is true in general. A parallel plate capacitor with an air filled gap is connected to an EMF and charged to Q, and voltage difference AV. With the EMF still connected, a ceramic with x = 3 is placed into the gap. 1. What is true of the voltage difference AV' after the dielectric is inserted? • AV' = 3AV, • AV' = AV, AV/3 2. What is true of the charge on the capacitor Q' after the dielectric is inserted? • Q' = 3Q • Q' = Q 푸루 K = 3 ● AV' = • Q' = Qo/3