3. About Transformer efficiency 3.1. Define efficiency 3.2.State the criterion for maximum efficiency 3.3.A 1000 KVA, 110/220 volt, 50 Hz single phase transformer has an efficiency of 98.5% at half load and 0.8 power factor leading. Whereas its efficiency at full load unity power factor is 98.9%. Determine 3.3.1. An expression for iron losses 3.3.2. An expression for copper losses at full load. 3.3.3. Solve the two equations to determine the iron and copper losses at full load.

3. About Transformer efficiency 3.1. Define efficiency 3.2.State the criterion for maximum efficiency 3.3.A 1000 KVA, 110/220 volt, 50 Hz single phase transformer has an efficiency of 98.5% at half load and 0.8 power factor leading. Whereas its efficiency at full load unity power factor is 98.9%. Determine 3.3.1. An expression for iron losses 3.3.2. An expression for copper losses at full load. 3.3.3. Solve the two equations to determine the iron and copper losses at full load.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A single phase 1.1 KVA, 50 Hz, 220/110 transformer has an Iron losses = 80 W and equivalent resistance referred to low voltage side = 0.95 0. Its maximum efficiency at 0.7 :p.f. lagging is
Short discuss about transformer cooling...
??
A 150 kVA, 2500/250 V, 50 Hz, single phase transformer has a no-load current of 0.75 A and a core loss of 850 W, when the high voltage side is energized at rated voltage and a frequency. Determine the following : 1) The core loss component of no-load current 2) The magnetizing component of the no-load current 3)The core loss resistance on the high voltage side in ohm 4)The magnetizing resistance on the high voltage side in ohm
AVcc RA=1kr NES5S Vout Oulput 3 9. .C2 -0.0luf figue 1. Refer to the ligure l: @ Calculate the loaing: O charge period @ discharge period Frequency of oscillation (Time Per Division= looms) the duty cycle ? ) In an astable multivibrator cirait, unhen we change the oscilloscope setting fram lo0 ms to 5ooms, what will happen for the waveform and cuhu2
391. A transformer has maximum efficiency at load copper loss (P.), is of full load. The ratio of its iron loss (P.) and full
Fast do...
Solve for the efficiency at three-eight load at 0.85 power factor of a 10-kVA single phase transformer with the full load copper loss and core losses are 152 and 128 watts, respectively. Determine the secondary terminal voltage when transformer is delivering full load secondary current at 0.95 power factor of a 20-kVA transformer steps down from 6,600 V to 480 v. The resistances of the primary and secondary windings are 12 ohms and 0.08 ohm, respectively.
don't copy
Complete the blank An isolating transformer is a (..........................)ratio transformer with several important applications.
Q2/3-phase.E.W.C. R using center tap transformer supplies highly inductive load, find: 1. The average load voltage with and without FWD and discusses these cases. 2-lf firing angle equal to 45°, the supply voltage is240v, transformer ratio is (2/1). Calculate the DC current& voltage of this case. 3- Draw all waveforms diagram. 4- what are the difference between the type of connection (Delta or Star).
Answer in short please i will like....