3. A resistance of R ohms and an inductance of 0.5 henry are connected in series with an emf of 40 volts. If the current is initially zero and is equal to 2 amperes after 0.5 second, find R.

Q: voltmeter

A: Resistance in parallel- 1Req=1R1+1R2+1R3+........... Resistance in series- Req=R1+R2+R3+...........

Q: j202 Select one: O a. None of these O b. Is 100 <-90° mA O c. Is = 5.0<.90° A 90° me ell

A:

Q: Given the zener voltage at 9V and the zener power at 1W, what is the range of allowable values of Iz…

A: Given data, Zener voltage VZ=9 V Zener power Pz=1 W

Q: Problem 15. A source of e.m.f. of 15 V supplies a current of 2 A for six minutes. How much energy is…

A: Given data, Voltage V = 15 V Current i = 2 A Time t=6 minute = 6×60 =360 sec

Q: Estimate voltage E2 when E1=90sin2400t V, R1=R2=20 ohms, L1= L2=3mH and M=0.15mH

A: RMS value of E1, E1RMS=902=63.63 Volt, Frequency ω=2400 rad/s. Inductive reactances:…

Q: a p.d. of 500 V is applied across the winding of an electric motor and the resistance of the winding…

A: Given the winding of an electric motor having, Potential difference across the winding, V = 500 V…

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,251 ohms R2 =…

A:

Q: Match each type of transducer with the corresponding physical phenomenon, law, or property where it…

A: We are given with the following choices: Lorentz law Charge Faraday's law Ohm's law Capacitance…

Q: In volt ampere characteristics the current increases with voltage a. Equally b. Sinusoidal c.…

A: The volt ampere characteristics is the characteristics between voltage and current of a diode.

Q: Problem 452 16V for circuit shown in figure, find the o current in each resister. the ce

A:

Q: A Certain winding made up of copper has a resistance of 100 2 at room temperature. If resistance…

A:

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,677 ohms R2 =…

A: Given the following resistances and inductors are in series with a voltage source, R1=1677 ΩR2=1966…

Q: When a voltage of 100V at 50Hz is applied to a choking a coil A, the current taken is 8A and the…

A:

Q: Determine the DC currents (Ig, Ic and lĘ) and dc junction voltages (VBE, VCE and VCB) IB=Blank 1 mA,…

A:

Q: 330Ω 6802 2202 4702 100mA 20V

A: Referring to the circuit, the bottom of the circuit is attached to the ground then all the grounded…

Q: 6 0 Tsa _VS 10v LED1 Jsb да b m 11 R1 •1K22 12 R2 3.3k 113 R3 22.2k2

A: LED stands for Light-Emitting Diode. It is a semiconductor device that emits light when an electric…

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 14 ohms R2 = 20…

A:

Q: calculate the Load current and Load voltage of the given figure

A:

Q: The resistance R and a 2 μF capacitor are connected in series          across 200-V dc supply.…

A: From the given information a series RC circuit can be drawn as, we need to calculate the value of R…

Q: direct current of 12.5 A flows in a 25-ohm resistance. Determine the maximum value of an alternating…

A:

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 - 40 ohms R2 = 61…

A: we need to determine amplitude of the voltage across R1.

Q: Determine: the current and voltage across each load. Μ 35 V Μ 14 Ω 10 Ω 12 Ω < 18 Ω

A:

Q: In the circuit in the figure, the primary current is read as 3.603mA. Two windings were used as…

A: The transformer has a primary and a secondary side. It converts electrical power to electrical power…

Q: How much resistance must be inserted in series with a 0.96-H inductance to limit the current to 0.25…

A: To solve above problem, one should have basic idea about working of AC circuits. Above given circuit…

Q: Determine the currents I, and I, in the circuit below 6 mA 1.51 1 mA

A: Nodal analysis is an important method to solve big and complex circuits. It is based on Kirchoff's…

Q: There is 50 mA of current through a coil with 250 turns. The flux is 150 µWb. What is the mmf? What…

A: Given data, Current (I)=50 mA Number of turns of coil N = 250 turns Flux ϕ=150 μwb

Q: In order to prevent the reactive current drawn by the load in the circuit in the figure, it is…

A: To solve above problem, one should have basic idea about working of AC circuits. Above given circuit…

Q: 1-14 How many independent equations can be obtained from the following circuit with Kirchhoff's…

A:

Q: If a circuit has a resistance of 3002 and a series inductance of 5002, what is the relationship…

A: The solution is given below

Q: A dc generator and a battery are connected to a resistive load RL in the figure below. For each,…

A: (a) (i) Consider first a dc generator circuit. To get the maximum output power load resistance and…

Q: Three 4 – ohm resistors are connected in parallel from a 24 – volt source. Find the current flowing…

A: In this question we will find current flowing resistors...

Q: what is kvl and kcl in circuit theory ?

A: The electrical circuit consists of various active and passive elements and The circuit calculations…

Q: 2. A certain full-wave rectifier has a peak output voltage of 30 V. A 50 F capacitor-input filter is…

A:

Types of Thyristors

With four layers of alternating P- and N- materials, a thyristor is a solid-state semiconductor device. It acts as a type of bi-stable switch and it conducts when the gate receives a current trigger and continues to conduct until the voltage is reverse biased across the device or by some means until the voltage is removed. The silicon-controlled rectifier is considered synonymous with thyristors by some sources. Thyristors are defined as more complex by other sources as it contains at least four-layer of alternating N-type and P-type substrate. They find large applications in the control of electrical power supplies, electric motor speed control, and ranging of light dimmers because thyristors can control large amounts of power supplies and voltage with a small device. The circuit symbol of the thyristor is given below.