If the circuit is moved to position 2, find the current after 2 seconds. The circuit before disconnecting the RL circuit from the battery is 20 A. The resistance is equal to 5 ohms while the inductance is equal to 2 Henries. A. 19.865 A                           B. 0.135 A C. 11.013 A                           D. 8.987

Q: A. B. potentiometer Choose. eddy current sensors Choose. ac excitation ac and dc excitation 1 kHz…

A: Potentiometre which is used to measure the potential difference between the two points this is also…

Q: Problem 15. A source of e.m.f. of 15 V supplies a current of 2A for six minutes. How much energy is…

A: In this question we will find energy provided by source ...

Q: In the given figure, the potential difference between points P and Q is – -

A: The solution can be achieved as follows.

Q: a. Determine the time constant. b. Write the mathematical expression for the current i̟ after the…

A: According to guidelines we are allowed to do only first 3 subparts. post again for remaining as…

Q: Based on Figure Q1(a), identify the equivalent inductance seen at the terminal of a and b. [4 marks]…

A:

Q: AC circuit that has a resister Current of 0.75A, and 125V. An inductor with 208 valts. What is the…

A: The voltage across resistance VR = 125 volts,Current through resistor is I = 0.75 A,Voltage across…

Q: 4. Explain the three-level PWM by drawing waveforms.

A: Pulse width modulation(PWM): PWM is a powerful technique for controlling Analog circuits with a…

Q: Capacitor has the ability to store a quantity of O a. Dynamic Electricity O b. Dielectric O c.…

A: capacitor have ability to store statics electricity.

Q: 7. A resistance of 10 ohms and inductance of 4 henry is connected in series with a 12 volts battery.…

A:

Q: Which change to the circuit will not extend the charging time of one time constant. a. Increasing…

A:

Q: Find the electric potential energy of the system of charges shown in the figure. NOTE:…

A: Given Data:-Charge K =       where Distance (r) = 2mFind out :-Total potential energy of the system

Q: 7. In a pure inductive circuit, the phase angle between the voltage waveform and current waveform…

A: In an inductor voltage leads the current  And in capacitor current leads voltage. The pahsor diagram…

Q: What are the things common in direct current and alternating current. And also its Difference

A: The explanation is as follows.

Q: Determine the values of resistance R and inductance L

A: We need to determine the values of R and L.

Q: In the figure below, q1 = +2.00 nC and q2 = -8.00 nC. At what postion can an electron be placed and…

A: To find the position of electron such that electron experiences zero net force from q1 and q2 .

Q: 180 V Ф - 50 ms

A:

Q: 1. The capacitance of a parallel-plate capacitor does not depend on the a. area of the plates. b.…

A: In this question we will write about capacitance , electric supply etc...

Q: Alternating Current System A series connection of a 30-ohm resistor and a 100-mH inductor is…

A:

Q: Discussion Question 1: A rectangular block of iron is 2cm x 2cm x 30cm. How would you connect this…

A: A rectangular block of iron which has the dimensions of 2 cm× 2 cm × 30 cm. So now if we connect it…

Q: Which of the following would have a greater amount of inductance if connected to an AC power source?…

A: The explanation is as follows.

Q: A flux of 19 mWb links with a 1340 turns coil and the inductance of 12 H. The value of energy stored…

A: Given that  Flux = 19 m Wb No. of turns = 1340 turns ] Inductance = 12 H  Energy stored in inductor…

Q: Figure 2a. Total Current Figure 2b. Bulb Current A 220V 100W 220V 100W A L L 2.5372H 2.5372H 220V…

A:

Q: Ferromagnetic materials have this characteristic.    A. A relative permeability slightly less than…

A: We are asked to identify characteristics of ferromagnetic materials from the given options.

Q: What is the value of the R to get the full deflection??

A: Using the virtual ground concept, the voltage at the non-inverting terminal will be equal to the the…

Q: An inductor is connected in parallel with a 6540 resistor and a function generator. The applied…

A: Let current through the resistor be IR and current through the inductor is IL and I be total source…

Q: The coil winding in PMMC meter is -1 small heavy large fine

A: Given  The coil winding in PMMC meter is

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,677 ohms R2 =…

A: Given the following resistances and inductors are in series with a voltage source, R1=1677 ΩR2=1966…

Q: 3.) Find the percent overshoot, settling time and peak time for T(s) == 0.04 $240.002s +0.04

A: We need to find out  peak time and peak overshoot and settling time .

Q: An inductance of L henrys and a resistance of 10 ohms are connected in series with voltage of 100…

A:

Q: Estimate thermal voltage for 30o C.

A: The thermal voltage (VT) is a very important quantity in semiconductor physics. It is dependent on…

Q: The symbol of iron core inductor is

A:

Q: In the circuit in Figure 2, the capacitor and The circuit of resistance is defined as a load…

A: Explanation: “Since you have asked multiple questions, we will solve the first question for you. If…

Q: Q2/ For the figure shown below if qo = 15. 10 - 6C.q1 = 45. 10 - 6C.q2 = - 36 • 10 - 6C.q3 = 20 - 10…

A: Any charged particle produces an electric field. This electric field is directed from the positive…

Q: Part a of the drawing shows a resistor and a charged capacitor wired in series. When the switch is…

A:

Q: A RL circuit has a battery emf E=-22V and a switch closes at 0.0s. At t=1.25s, the ammeter=0.2A. If…

A: Considering the current equation in RL circuit. It=I∞1-e-RtLI∞=steady state currentI∞=ERI∞=2240…

Q: Determine the magnitude of the current through the capacitor in the circuit below. VT = 97V RMS, ZT…

A:

Q: Calculate the total inductance at the terminals a-b, for the circuit shown in FigureQ2(b). 10mH 5mH…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: 50V 50V 32 20V 452 I3 B In

A:

Q: The maximum efficiency for pure inductance load and iron-losses = cupper losses is zero. O True O…

A: Given data,  For Pure inductive load , Resistance = 0. Given, iron losses = copper losses. For pure…

Q: The resistance R and a 2 μF capacitor are connected in series          across 200-V dc supply.…

A: From the given information a series RC circuit can be drawn as, we need to calculate the value of R…