3: The Figure shows a horizontal pipe used to provide a fluid from a container. The pipe inlet diameter is 1 cm and the outlet diameter is 2.5 mm. This pipe maintained at 150 kPa. What is the force exerted by the fluid on the end of the pipe? Neglect losses.

Q: 2. Oil with a S.G. pf 0.82 is flowing in a pipe under the condition below (see figure). If the total…

A: Given data as per the question The specific gravity of oil =0.82 Total head loss =3 ft Q =2.08 cfs…

Q: Q2/ Three pipes are connected in parallel as shown in Fig. No. (2). Pressure head at junction A is…

A:

Q: The flow of water in a horizontal pipe of constant cross section has a pressure gauge at location 1…

A:

Q: Water enters a fountain through a pipe with a cross-sectional area A₁ at a flowrate Q. The pressure…

A: Given:

Q: could you please help me calculate the maximum height of the jet , Hj in metres please

A:

Q: 2. The figure shows a pipe reducing section that is bolted on to the end of a pipe. Water flows…

A:

Q: A certain SSSF control volume with a single inflow and outflow and has an inflow speed V₁ = 200…

A:

Q: As seen in the figure, the vacuum pump provides air flow in an insulated pipe with a cross section…

A: Given data, Calculating Mach Number at section using the given relationship: - Hence, the Mach…

Q: Consider 2 which shows a pipe system connecting two reservoirs. The pipe diameter changes at point B…

A: Given : The pipe friction coefficient is f=0.005 The coefficient of contraction is kL=0.6 Length of…