3 ft 2 ft - B.

Q: 3 ft 2 ft The C86100-bronze rod AB and 6061-T6- aluminum rod BC are joined at the collar B and fixed…

A:

Q: zirconium alloy. If an axial load of 4 kip is to be supported by the member, determine its required…

A:

Q: The C83400-red-brass 2014-T6-aluminum rod BC are joined at the collar B and fixed connected at their…

A:

Q: The two bars are made of a material that has the stress-strain diagram shown. If the cross-sectional…

A: Given data as per question  Cross-sectional area of AB =1.5 in2  Cross-sectional area of Bc=4 in2

Q: A stainless steel tube with an outside diameter of 50 mm and a wall thickness of 5 mm is used as a…

A:

Q: The rigid block has a weight of 400 kN and is to be supported by posts A and B, which are made of…

A:

Q: The pin-connected assembly consists of aluminum rods (1) and (2) and steel rod (3). The aluminum…

A: For aluminum rod,For steel rod,The displacement towards A  to left is,

Q: Provide final answer and equations used.

A:

Q: Axial loads are applied to the compound rod that is composed of an Aluminum segment rigidly…

A: Given:As=400 mm2Aa=500 mm2Ab=300 mm2P=12 kN

Q: The 2014 T6 aluminum strut is foced between the two walls at A andB. It has a 2 in. by 2 in. square…

A: Given data T1 = 22 lb-ft T2 = 42 lb-ft Area of cross section = 2 in X 2 in

Q: Determine the maximum axial force P that can be applied to the bar. The bar is made from steel and…

A: The given bar is critical to two positions:1) At the fillet section2) At the hole sectionAt fillet…

Q: The C83400-red-brass rod AB and 2014-T6- aluminum rod BC are joined at the collar B and fixed…

A: Given T(1)=50 degree F T(2)=120 degree F Area cross-section =1.75 in(2)

Q: A column is constructed from high strength concrete reinforced with 8 A992 steel rods. The column…

A:

Q: A 2024-T4 aluminum tube with an outside diameter of 3.8 in. will be used to support a 36-kip load.…

A:

Q: The rigid beam is supported by a pin at C and an A-36 steel guy wire AB. Part A If the wire has a…

A:

Q: The pin-connected assembly consists of aluminum rods (1) and (2) and steel rod (3). The aluminum…

A: For aluminum rod,For steel rod,The displacement towards A  to left is,

Q: The d = 14-mm-diameter solid rod passes through a D = 19-mm-diameter hole in the support plate. When…

A:

Q: A 100-mmmm long rod has a diameter of 15 mmmm. If an axial tensile load of 145 kNkN is applied,…

A:

Q: At a temperature of 20 °C there is a gap ∆ = 0.2 mm between the lower end of the brass bar and the…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.