3-28 A 1.8-m3 rigid tank contains steam at 220°C. One-third of the volume is in the liquid phase and the rest is in the vapor form. Determine (a) the pressure of the steam, (b) the quality of the saturated mixture, and (c) the density of the mixture. Value (5/30) Steam 1.8 m' 220°C

Q: Consider propylene at boiling conditions (a) What is its boiling temperature at 101.3 kPa? 200 kPa?…

A: The objective of this question is to give the boiling temperature and boiling pressure of propylene…

Q: 5.53 The vapor pressure of and its molar enthalpy of vap 10.5 kcal/mol. Assume the effect of a…

A:

Q: 3. A 1.8-m³ rigid tank contains saturated mixture at 220°C. One-third of the volume is in the liquid…

A:

Q: please give clear handwritten answer- Mg + 2HCl(aq) ------> MgCl(ag) + H2(g) Calculate the volume of…

A: In the above given reaction one mole of magnesium produces one mole of hydrogen gas.

Q: When ethanol is added to water at 25 °C and 1 bar, the total volume of the solution changes…

A: A mole is defined as some of the chemical units it may be atoms, molecules, ions.…

Q: 5. Nitrosyl bromide (NOBR) can be produced according to the following equation: / 2NO(g) + Br2(g) =…

A: Mass of NOBr  = 3.22 g Mass of NO = 3.08 g Mass of Br2 = 4.19 g Volume of conatiner = 4.90 L…

Q: Calculate AS° for C(g) + 2 H₂(g) → CH₂(g). Substance C (g) C (g) H₂ (g) CH4 (g) Substance 2 5 8…

A:

Q: In the subsurface, the water interacts with limestone and the only type of carbonate is calcite…

A: Given: The rate of stream flow is 0.5 L/min. Let's assume that the concentration after per minute is…

Q: Q\3: Oxygen gas produced from the reaction below was collected above the water at 30 Cº and in a…

A: Here we have to determine the mass of oxygen gas produced and mass of KClO3 decomposed in the…

Q: 6a

A: The given graph is :

Q: -1 Henry's -law constants km of the relation m= km"P for nitrogen and oxygen in water at 0 °C are…

A:

Q: ] Assuming 4Hfurion is constant, find the pressure necessary to lower the freezing temperature of…

A: Given data: ρice=0.917 g/cm3ρwater=1.000 g/cm3 Tf(1 atm)=273.15 KTf(P2)=263.15 K           (∵…

Q: 4. Calculate the percent deviation from ideality of a gas at its critical point. The critical point…

A: To calculate the percent deviation from ideality of a gas at its critical point, you can use the…

Q: 20. A mixture consisting of 6 kg of O, and 9 kg of N, has a pressure of 3 bar and temperature of…

A: Since we only answer up to three sub parts, we'll answer the first three. Please resubmit the…

Q: a) Calculate the volume (in L) occupied by 16 g of Carbon dioxide gas at a pressure of 99.7 x 103 Pa…

A:

Q: 71/2 0.032 kg mol1 (0.032 kg mol¯)(300 m s-1)2 ] exp -1 [27(8.3145 J K-1 mol)(300 K) 2(8.3145 J K-l…

A:

Q: Question 26 Ksp for Pbl2 is 8.43E-6. What is the solubility of Pbl2 in g L-1? (molar mass: 461.01 g…

A: Given:: Ksp of PbI2=8.4×10-6  molar mass= 461.01 g mol-1 Solubility (in g L-1) = ?

Q: C6H5Cl e C6H5Br form nearly ideal mixtures. At 136.7◦ C the vapor pressure of C6H5Cl is 1.137 bar,…

A: Given data vapor pressure of C6H5Cl is 1.137 bar,  C6H5Br is 0.604 bar total vapor pressure is 1 bar…

Q: 4. (a) Determine the reduced pressure (P,), volume (V,), and temperature (T, ) for a 50 L sample of…

A: According to Law of corresponding states if two or more substances have the same reduced temperature…

Q: A mix gas contain (molar fraction) 6% SO2, 12% O2 and other inert gas at 100 kPa. Calculate K, at…

A: The unit for energy of 1kJ is equal to 1000 J. The value for ΔGθ for SO3 (g) is calculated as shown…

Q: Consider a liquid mixture of CHCl3 (component A) and CH₂Cl₂ (component B) with XB = 0.750. For each…

A: Given , A liquid mixture of CHCI3 (component A) and CH2CI2 (component B)

Q: Calculate the AHO for the reaction Cbte + 2H, → CHAG) (graphite) '2(g) from the following enthalpy…

A: Given,

Q: You measure the total pressure of a system is 228.2kPa (P total). You also find there are 49.9kPa…

A:

Q: Given the following vapor composition plot for a mixture of cyclohexane and toluene, determine (a)…

A: Cyclohexane and Toluene are miscible. The vapor-composition plot of the mixture shows the variation…

Q: C(diamond) + 2H2(g)= CH4  At 298 Kelvin and pressure of 1000 atm Kp=p(CH4)/p^2H2 In the above…

A: The reaction is given below.

Q: mixture of ideal gases possesses the proper Examined at 2 bar and 22°C giving the following : 20%;…

A: The objective of this question is to calculate a gas mixture's volumetric analysis, gas constant,…

Q: the determination of molar mass of an unknown substance by ebullioscopic constant, 30 mL of acetone…

A: the elvation in boiling point is calculated by using formula,⊿Tb=Kb×m×iwhere,⊿Tb=change in boiling…

Q: Chemistry (1) A gas has an equation of state: (P + aP2)(V - b) = RT where a and b are…

A:

Q: In the determination of molar mass of an unknown substance by ebullioscopic constant, 30 mL of…

A: Elevation in boiling point is a colligative property which only depends on the amount of the solute…

Q: Eleanoron gas is a newly discovered toxic gas with a very noxious odour. A sample of Eleanoron is…

A: Pressure of a gas is a physical property that is defined as force exerted by gas molecules per unit…

Q: In the determination of molar mass of an unknown substance by ebullioscopic constant, 30 mL of…

A: Given data Boiling point of pure Acetone  (solvent)  = 56 oC Boiling point of solution  (solvent +…

Q: Sulfur dioxide emissions from coal-based power plants areremoved by flue-gas desulfurization.The…

A: The effect of pressure and temperature is measured by Boyle’s law and Charles's law respectively.…

Q: Calculate the actual pressure for a non-ideal system for 1.00 mole of carbon dioxide gas in 3.00 L…

A:

Q: ) If the mixture in problem 5 consists of 50.0 mol% A and 50.0 mol% B, and substance A is…

A: The question is based on the concept of solutions. we have been given mole percent of both the…

Q: (a) Use the following data for NH3 (g) at T = 273 K to evaluate B2P (T). (Here Z is the…

A:

Q: 12 (a) (b) Describe how you can obtain the integrated form of the Clapeyron equation as below. State…

A: The objective of the question is to derive the integrated form of the Clapeyron equation and use it…

Q: Q\3: Oxygen gas produced from the reaction below was collected above the water at 30 Cº and in a…

A: Given :  Temperature = 30°C = 303 K  Volume of O2 = 150 cm3  Since 1 cm3 = 10-6 m3  => Volume of…

Q: System Change AS O AS 0 and 22° C. pressure kept constant at 1 atm. not enough information AS 0…

A: For the first change entropy will increase (∆S > 0). [Reason: Entropy increases in this case as…

Q: Write the remarks about the KP of ideal-gas mixtures ?

A: For an equilibrium reaction involving ideal gases, the equilibrium constant of the reaction at the…

Q: Calculate the partial pressure (Pa) of CO2 in a mixture that contains 45% wt CO2, 35% wt CO and 20%…

A: Given -> wt% of CO2 = 45%  wt% of CO = 35%  wt% of O2 = 20%  T = 100°C  P = 1.5 atm

Q: The volume of HCI is 100 mL , mass of solid added is 1.008g, moles of solid 0.0276 Mol, mass of HCI…

A: Given: Volume of HCl = 100 mL Mass of solid Added = 1.008 g moles of solid  = 0.0276 Mol mass of HCI…

Q: A mixture combining 60 mL ethanol (C₂H6O) with 75 mL water (H₂O) is prepared at 280 K. The partial…

A: Volume of ethanol = 60 ml Volume of water =75 ml

Q: 19. What is the molarity of a HCI solution if 2.50 L is needed to react with 12.7 g of Al according…

A:

Solutions

Solutions can be considered as homogeneous mixtures which contain two or more than two chemical substances. The chemical substance which is the greater part is defined as solvent. And the chemical substance that is dissolved in a solvent is referred to as solute. Solution chemistry plays an important role in chemistry since it supports many commercial applications of solutions.