2m Wall supported by pins at B and a roller at • Determine the reaction at B and C • use method of joints to determine the force member of Wall, state whether each. in Compression or tension. in each member is -4.6kN 1. 4m A 2.3m 4.4KN D

Q: 4.yielding of the web represents one of the a) shear limit state) .b) moment limit state)…

A: The correct answer is option a) Shear limit statea) Shear limit state:A limit state in beam design…

Q: Determine the force in Member CE of the truss shown. Determine whether the member is in tension or…

A:

Q: Three plates are welded together to form the section shown. Dimensions of the cross section are b =…

A: First we need to divide the section into 3 different parts. Then we need to calculate the neutral…

Q: 4. Determine the force carried by the members of the truss. 10, kN ANS. 10 kN AC = CE = EF = FH =…

A:

Q: Determine the forces in all bars. Indicate tension or compression

A:

Q: 8 kN/m 35° E By D 20 kN 0.4 m 0.4 m 0.4 m

A:

Q: The steel pipe AB has a 64-mm outer diameter and a 5-mm wall thickness. Knowing that arm CDE is…

A:

Q: 3m -3m- 4 kN B F

A:

Q: 17.17 Member BC of the pin-connected truss has a cross sec- oy = 42 ksi. tion as shown. E = 29 x 10³…

A: Given: E=29000 ksify=42 ksi For 2 C10×30, A=17.64 in2rx=3.43 inry=1.32 in To determine: Load P.

Q: 4. The joint is fastened together using two bolts. The diameter of each bolt is 13.5 mm. Determine…

A: Given data in question  Load 80 kN Diameter 13.5 mm Width 30 mm Number of bolts 2 To find out…

Q: Three plates are welded together to form the section shown. Dimensions of the cross section are b =…

A: Given: The value of b is 3.6 in. The value of d is 10.8 in. The value of a is 2.3 in. The value of t…

Q: -: For the truss shown in the force F and the forces in memberr BF, BG and BA, when the force in CD…

A: Force in member CD  FCD=3.75 tensionto find force F1   consider joint D

Q: ! Required information Each of the four vertical links has an 8 x 36-mm uniform rectangular cross…

A: Given data - Cross section = 8×36 mm Diameter of Pin = 16 mm P = 23 KN Find out - Average shear…

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.