•29 In Fig. 30-52, a metal rod is forced to move with constant veloc- T ity v along two parallel metal rails, i connected with a strip of metal at one end. A magnetic field of magni- tude B = 0.350 T points out of the page. (a) If the rails are separated by L = 25.0 cm and the speed of the rod is 55.0 cm/s, what emf is gener- ated? (b) If the rod has a resistance of 18.0 N and the rails and con- nector have negligible resistance, what is the current in the rod? (c) At what rate is energy being transferred to thermal energy? Figure 30-52 Problems 29 and 35.

•29 In Fig. 30-52, a metal rod is forced to move with constant veloc- T ity v along two parallel metal rails, i connected with a strip of metal at one end. A magnetic field of magni- tude B = 0.350 T points out of the page. (a) If the rails are separated by L = 25.0 cm and the speed of the rod is 55.0 cm/s, what emf is gener- ated? (b) If the rod has a resistance of 18.0 N and the rails and con- nector have negligible resistance, what is the current in the rod? (c) At what rate is energy being transferred to thermal energy? Figure 30-52 Problems 29 and 35.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A conductor located at 0 < y < 1.6 m moves with velocity 2ax m/s in a magnetic field, B = 10 cos βyaz Wb/m2 where β is a constant. Determine the induced voltage.
Assume two parallel conducting plates perpendicular to the z axis of Cartesian system. They are separated by “d”. The coordinate center is at the center of the plate system. Each plate is large with and edge length of L. The upper plate has a surface charge density of – sigma and the lower has + sigma. Between the plates oriented along the x axis there is a constant magnetic field B0. Use Faraday’s law to confirm the motion of the plates as B0 goes to zero and show that the net momentum they receive is that of the fields’ initial momentum. Imagine that instead of B0 going to zero, this time we discharge the plate with a narrow conducting rod on the z axis between the plates. In this case, the electric field goes to zero. What happens to plates and how does the field momentum get transferred to them? Show the mathematical details of the momentum transfer.
•14 o In Fig. 30-42a, a uniform magnetic field B increases in magnitude with time t as given by Fig. 30-42b, where the vertical axis scale is set by B, = 9.0 mT and the horizontal scale is set by , = 3.0 s. A circular conducting loop of area 8.0 x 10-4 m² lies in the field, in the plane of the page. The amount of charge q passing point A on the loop is given in Fig. 30-42c as a function of t, with the vertical axis scale set by q, = 6.0 mC and the horizontal axis scale again set by t, = 3.0 s. What is the loop's resistance? B. 4. t (s) t (s) (a) (b) (c) B(mT) (ou) b
-2t The magnetic flux through the loop shown in the accompanying figure varies with time according to , = 8.00e sin(150nt), where m is in milliwebers. What are the magnitude and direction of the current (in A) through the 5.00 Q resistor at the following times? 5.0 N B (a) t = 0 s magnitude A direction ---Select--- (b) t = 2.17 × 10-2 s magnitude A direction ---Select--- (c) t = 0.5 s magnitude A direction ---Select---
A 2.80-m length of wire is held in an east-west direction and moves horizontally to the north with a speed of 0.370 m/s. The Earth's magnetic field in this region is of magnitude 50.0 µT and is directed northward and 53.0° below the horizontal. (a) Calculate the magnitude of the induced emf between the ends of the wire. (b) Determine which end is positive. O the east end O the west end O both O neither
Calculate the motional emf induced along a 20.0 km long conductor moving at an orbital speed of 7.80 km/s perpendicular to the Earth’s 5.00×10−5 T magnetic field.
- at &m = - 2 The magnetic flux through the loop shown in the accompanying figure varies with time according to Poe sin(wt), where Do = 4 × 10-³ T · m², a = 5 s-¹, and w = 120 rad/s. What are the direction and magnitude of the current through the 5-0 resistor at (a) t = 0; (b) t = 2.17 × 10¯ s, and (c) t = 3.00 s? ' 5.0 Ω Hints mA at t = 0. a. Current mA at t b. Current mA at t c. Current ●tm B Select an answer Select an answer Select an answer with with with - 2 = = 2.17 × 10- S. = 3.00 s. -
(L11) A thin 0.120 m copper rod on the x-y plane and parallel to the x axis moves with a constant velocity of 4.17 m/s in the +y direction as shown in the figure. There is a uniform magnetic field 5.84E-2 T everywhere in space pointing in the -z direction (into the page). The electric potential is measured to be Va at point a and V₁ at point b. What is the potential difference Va-V₁ (write down the sign and magnitude)? +y Va ZO Vb +x
1 33- 5 10 t (s) A square loop of wire with a side 10 cm lies in a region where a magnetic field perpendicular to its plane exists and changes as shown in the figure. What is the induced emf in the loop? O A) 3 mv O B) 30 V O ) no emf induced O D) 30 mv O E 3V (1) 8
An airplane flies level to the ground towardthe north pole. (a) Is the induced emf from wing tip to wing tipwhen the plane is at the equator greater than, less than, or equalto the wing-tip-to-wing-tip emf when it is at the latitude of NewYork? (b) Choose the best explanation from among the following:I. The induced emf is the same because the strength of theEarth’s magnetic field is the same at the equator and at NewYork.II. The induced emf is greater at New York because the verticalcomponent of the Earth’s magnetic field is greater there thanat the equator.III. The induced emf is less at New York because at the equator theplane is flying parallel to the magnetic field lines
A magnetic field of magnitude 0.310 T is oriented perpendicular to the plane of a circular loop. (a) Calculate the loop radius (in m) if the magnetic flux through the loop is 2.30 Wb. m (b) Calculate the new magnetic flux (in Wb) if the loop radius is doubled. Wb