28. The primary current of a transformer with 240 volts on the primary,10 amps on the secondary and 115 volts on the secondary is29. Which of the following wires has the smallest cross-sectional area?a. 21 AWGb. 10 AWGc. 19 AWGd. 13 AWG30. What the CM for a wire gage #17?31. If a current of 30 amps flows through a 90 feet Iron wire that has a diameter of 0.066inches. How much voltage the wire will drop?volts.32. Find the voltage in the secondary coil,Secondary CollPrimary Coil20 Amps240 Volts4:1oooooamps.

given here some fill in the blank questions and asked to fill the blanks with explanation. NOTE:…

28. The primary current of a transformer with 240 volts on the primary, 10 amps on the secondary and 115 volts on the secondary is 29. Which of the following wires has the smallest cross-sectional area? a. 21 AWG b. 10 AWG c. 19 AWG d. 13 AWG 30. What the CM for a wire gage #17? amps.

28. The primary current of a transformer with 240 volts on the primary, 10 amps on the secondary and 115 volts on the secondary is 29. Which of the following wires has the smallest cross-sectional area? a. 21 AWG b. 10 AWG c. 19 AWG d. 13 AWG 30. What the CM for a wire gage #17? amps.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A short circuit test on 10kva / 2400, 60 hz transformer yields the following result: 4.17 A, 200 V…

A: The solution is given below

Q: Figure (1) shows the block diagram of a wideband frequency modulator using the indirect method. This…

A: As per our company guidelines we are supposed to answer only first question kindly repost other…

Q: Calculate the mutual impedance, secondary current and the thermal power of the load in the…

Q: When a transformer takes a current of 0.8 A and its primary is connected to a 235 V, 50 Hz supply,…

Q: The circuit for a 20-KVA, 220/3960 V, 50-Hz transformer is shown in Figure (1). The open- circuit…

Q: An ideal transformer with a 300 turn primary connected to a 480 V, 60 Hz supply line needs to output…

A: An ideal transformer with a 300 turn primary connected to a 480 V, 60 Hz supply line needs to output…

Q: What is current transformer? 2 difference between current and potential transformers.

A: A step-up transformer that lowers the current while raising the voltage is a current transformer.…

Q: What is the efficiency of a transformer coupled class A amplifier for a supply of 12 V and output of…

A: Given- Transformer coupled class A amplifier- Supply = 12 V, Output of V (peak) = 12 V, To Find- The…

Q: Find the VL (peak) of the center-tapped transformer shown below. Assume ideal transformer and ideal…

A: A full wave rectifier with center tapped transformer is given. In positive half cycle diode D1 will…

Q: Certain transformer has full-load copper losses of 500 W. What is value of copper loss at half load:…

A: Given data: Pc1=500 W

Q: From the short circuit test and open circuit test in #19 and #20, the equivalent circuit of a…

Q: losses =los ses 1. Maximum efficiency of transformer is when 2 At maximum effciency load current l2=…

Q: Discuss the concept of fault analysis in power systems and the types of faults that can occur.

A: Fault analysis in power systems is a critical aspect of electrical engineering that focuses on the…

Q: A step-down transformer has a turn ratio of 8:1. If the primary voltage is 120 Vms, what is the seco…

Q: An 100-kVA, 2500/125-V, 50-Hz, step-down transformer has the following parameters: R₁ = 1.50, X₁ =…

A: Given information is,Rated output k VA.Induced EMF ratio Volts.Turns ratio is .Supply frequency…

Q: Solve the problem and illustrate the circuit. Answers must be in 3 decimal places A 480/220 V, 60-hz…

A: In this question we need to find the cross-sectional area in the core in cm and the primary and…

Q: Volt ac voltage is applied to the primary input of a transformer. A load of B ohms at the output it…

Q: 2. The short-circuit secondary current in a transformer is 2 A. What is the primary current if the…

A: Given, A transformer has, Short circuit secondary current I2=2 A. Transformer turns ratio a=25.

Q: What is the function of the DC motor armature Choose one answer: a. Performs the function of force-…

A: According to guidelines we need to solve only the first question. According to the question we have…

Q: Two point charges q,- ZuC and 92 - BuC are 30 cm apart from each other. Another charge q is placed…

A: The solution can be achieved as follows.

Q: Figure Q1 shows a transformer core that has the primary winding (Np) of 500 second winding (N,) of…

A: Introduction: A transformer is a device that steps up or steps down the level of voltage without…

Q: In an ideal transformer having a 1 to 2 turns ratio, the secondary: O a) current is half the primary…

A: In case of ideal transformer, transformer used for transfer the power and stepping up and stepping…

Q: In a transformer, the power will...............with increase in voltage.

A: We have been asked that what will happen to power in a transformer with increase in voltage.

Q: The main difference between transformer and dc motor is O The transformer has a core O The…

Q: S Sketch the output voltage waveform and determine the dc level of the output voltage of the network…

A: Vrms=20 Volts. NPNS=21

Q: 4. In a transformer, which options are correct: A. Works on Faraday' law and Ampere's law B. DC…

A: Transformer is a static device the transfer electrical energy from one electrical circuit to another…

Q: Q2/The primary of a certain transformer takes 1 A at a power factor of 0.4 when it is connected…

A: TRANSFORMER: The transformer transfers power from one circuit to another circuit without a change…

Q: What is the type of core material of the transformer?

Q: E ↑ I₁ R₁ L₁ R₂ L₂ 1₂ R₂ The transformer is supplied with 230 volts at 50 Hz. The primary's…

A: Given Circuit: Given data: L1=50mH L2=100mH, R2=4 Ohms R1=4 Ohms, Coupling Factor K=0.88 RL=150…

Q: a) As depicted in the figure, input voltage is 120 Volts (RMS) and diode drops are 0.7 Volts. Design…

A: According to the question, (a) As depicted in the figure, input voltage is 120 Volts (RMS) and…

Q: 20.a. If the unloaded secondary voltage of a transformer is 210 V and the full-load secondary…

A: Given transformer no load voltage VNL=210 V Transformer full load voltage =VFL =200 V

Q: AC power of 100 volts and 1 ampere enters a transformer with 2 coils and exits the transformer with…

Q: If the turn ratio of a step-down transformer is 30:1 and the no-load primary current is 1.25 A, the…

A: Given: Transformer primary turns, n1= 30 Transformer secondary turns, n2= 1 No load primary current…

Q: 5) A flyback converter has an input of 45 V, an output of 15 V, a duty ratio of 0.4, and a switching…

A: Given: A flyback converter has: Input voltage, Vs=45 V Output voltage, Vo=15 V Duty ratio, D=0.4…

Q: A transformer having a nominal voltage = 399V and a no load voltage = 420V at its secondary, the…

Q: A transformer contains equal number of turns in the primary and secondary side. Which of the…

A: The turns ratio 'a' is given by : a = N1/N2 Where N2 = no.of secondary turns. N1 = no of…

Q: The winding of a potential transformer is connected in with the power line. ...........** Select…

A: C. Primary , parellel

Q: Find the primary current and voltage.

Q: Figura 3-Transformador V. Ned Ns Vs Input Output

Q: If I build a transformer and I have the following data: Primary voltage = 127V Number of turns in…

Q: 2. When the turns ratio of a transformer is 20 and the primary ac voltage is 12 V, the secondary…

Q: 1. Convert the following decimal numerals to their binary, octal and hexadecimal equivalents (in…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Concept explainers

Three-Phase Transformers

Three-segment transformers are a type of transformer used to transform voltages of electrical systems into three ranges. Two type transformers are shell-type transformer and core type transformer. In brief, it could be described because of the exquisite kinds of configurations.

Transformer

Ever since electricity has been created, people have started using it in its entirety. We see many types of Transformers in the neighborhoods. Some are smaller in size and some are very large. They are used according to their requirements. Many of us have seen the electrical transformer but they do not know what work they are engaged in.

Question

28. The primary current of a transformer with 240 volts on the primary,
10 amps on the secondary and 115 volts on the secondary is
29. Which of the following wires has the smallest cross-sectional area?
a. 21 AWG
b. 10 AWG
c. 19 AWG
d. 13 AWG
30. What the CM for a wire gage #17?
31. If a current of 30 amps flows through a 90 feet Iron wire that has a diameter of 0.066
inches. How much voltage the wire will drop?
volts.
32. Find the voltage in the secondary coil,
Secondary Coll
Primary Coil
20 Amps
240 Volts
4:1
ooooo
amps.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

3. An ideal transformer with a 500 turns primary and 125 turns secondary windings delivers 400W to a 40 load. The resistance of the primary windings is 16O. Find the primary current and voltage
Draw a transformer with a turns ratio of 4:1. The primary source voltage is 480 volts. What size load resistor would be needed to develop a secondary current of 12 amps. What is the primary current and the power used in this transformer?
A transformer has "N1" primary turns, primary winding is connected with 'V1' Volts. if N2 = N1/2, what is the secondary voltage? O a. V2 = V1/2 O b. V2=2V1 c. V2=0 O d. V2=V1
VOLTAGE STEP UP THE VOLTAGE TRANSFORMER Done Choose... STEP UP THE CURRENT STEP UP THE VOLTAGE FREQUENCY PHASE DIFFERENCE
4. The power measured in an open circuit test on a transformer corresponds to: A) Losses in copper. B) The total losses of the transformer. C) Losses in iron. D) NO SOLUTION
- A Transformer has primary windings as Np = 750 and secondary windings as Ns = 125. Its secondary voltage is Vs = 36V and output power of the transformer is PN= 3200W. The value of loses powers are Pcu = 43W and Pfe = 29 W. The resistance of loads are RLI = 1,250 and R12 = 0,88Q. (Pcu and PFE will be considered to be approximately the same in different load values.) Determine the following values in the circuit: Primary winding N, turns Secondary winding Ng turns Primary current Magnetic Flux, Secondary IsL s current ISL1 'Isl2 Primary voltage Secondary voltage RL1 R12 Transformer Core (a) the primary voltage Vr, (b) the secondary load currents ISLı and Isl2 if the transformer is rated at RLI and R12, (c) the resulting secondary power PSL, (d) the resulting primary power PPl, (e) the primary load current IPL, (f) efficiency nL
b) A lkQ resistance is connected across the secondary winding of a 200V/400V transformer with the following equivalent circuit parameters, Kleq=502, Rc = 10k2, XM =1 k2 , ^leq = 100 2. Determine the following: R i. The Open Circuit Output Voltage (Vsoc) ii. The Output Voltage under load (Vs) i1i. The Output Current (Is) iv. The Transformer Efficiency (%)
Which of the following is the range of excitating current (in percent) of its rated current for a small distribution transformer? 25 Equal to rated current 6 None of option OO0O
A one-phase transformer has 400 and 1000 turns in primary and secondary, respectively. The cross-sectional area of the core is 60 cm?. The primary of the transformer is connected to a supply of one-phase, 50 Hz, 500 V. Determine the secondary voltage of the transformer.
Give advantages and limitations of solar PV systems
Current transformer has Select one: O a. No relation between primary windings and its secondary windings O b. More secondary windings than its primary windings O C. Primary windings equal to secondary windings O d. More primary windings than its secondary windings
Which of the following does not change in a transformer Select one: O a. voltage and frequency changes O b. Frequency O c. Voltage O d. None of these