A 22 mm-diameter bolt having a diameter at the root of the threads of 18.6 mm is used to fasten two timbers as shown in the figure below. The nut is tightened to cause a tensile load in the bolt of 34 kN. 28 mm 12 mm Determine the following: a. Shearing Stress in the head bolt. b. Shearing in the thread c. The outside diameter of the washers 16 mim if their inside diameter is 28 mm and the mm bearing stress is limited to 6 MPa. mm

The lap joint is fastened with four ¾-inch diameter rivets.  a. If the allowable shearing stress of the rivets is 14 ksi (kips per square inch), find the value of P (kips) that maybe applied to the joint. Assume that the load is equally distributed among the rivets. b. if the allowable bearing stress for the plates is 18 ksi, find the value of the load P (kips) that maybe applied to the joint. Assume that the load is equally distributed among the rivets. c. what is the maximum value of the load P (kips) that can be applied to the joint?

with an illustration all required section.

A 7/8-in diameter bolt, having a diameter at the root of the threads of 0.731 in., is used to fasten two timbers together. The nut is tightened to cause a tensile stress of 18 ksi in the bolt. Compute the shearing stress (ksi) in the head of the bolt and in the threads. Also, determine the outside diameter of the washers (inches) if their inside diameter is 9/8 in. and the bearing stress is limited to 800 psi. 1/2 in 5/8 in

i need the answer quickly

Compute the tensile stress for the rod shown in Fig. 1 at section A-A, the shearing stress across section B, the compressive stress between the pin and the rod, and the compressive stress between the pin and the yoke. Given n = 1 (3 / 4) in., a = (15 / 32) in., e = (27 / 32) in., b = (15 / 16) in., d = (19 / 32) in., f = 1".

Given Value:D1 = 250 mmD2 = 160 mmP = 3.5

Required information Link AB, of width b = 2 in. and thickness t= in., is used to support the end of a horizontal beam. The average normal stress in the link is -21 ksi and the average shearing stress in each of the two pins is 12 ksi. 4 NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Determine the diameter d of the pins. The diameter d of the pins is in.

SEE ATTACHED PHOTO, SHOW YOUR SOLUTION. THANK YOU!

The axial stresses are 12 MPa C in the wood post B and 150 MPa T in the steel bar A as shown below. Pins at A, C, and D are smooth. Determine (a)The load P.(b)The minimum diameter for pin C if it is in single shear and the cross-shearing stress is limited to 70 MPa.(c)The minimum diameter for pin D if it is in double shear and the cross-shearing stress is limited to 70 MPa.