211 Q2/ The one line digram 3-Phae poser System.Draw the Per- unit impedaunce digram G: 50 MVA, 13.2 KU, Xg = 0.2 Pu Tis 30MVA, 13.2/220KU, XT,=0-15 Pu TE:30 씨VA, 22./11 KU , X-01 S Pu 13:30 MVA i 13.2/132 kv , XT,=0.15PM Tu:30MUA,132/11 kV, XTuzo.15 Pu M: 70 MUA , lo.45 kv, Xm z0.2 p4 Load, 53 MVA, lo.4skv, 0.7 P.R (Lag) line1: 22okv, Xline 1 =4or %3D line2: 132 kv, Xlineq = 6or 오20 132 38 To 38 Ty load Select a Common base of 9O MUA ,13.2kv on the generator Side

Q: Calculate the actual current 1₂ for this following line diagram: SB 100 MVA. 30 60 Hz 13.8 kV T1 30…

A: Given line diagram is,Asked to find the current I2=?

Q: The maximum size overcurrent device for primary only protection of a three-phase, 37.50 kVA,…

A:

Q: For the system of Problem 9.11, compute the fault current and voltages at the fault for the…

A: Types of faults at 'F' are a) Single line to ground b) Line to line through fault impedance c)…

Q: 3. In the following power system, the base voltage in region 2 is 13.8 kV. The transformer reactance…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: The maximum size overcurrent device for primary only protection of a three-phase 112.50 kVA…

A:

Q: what would be the minimum size feeder conductor THHW 75 degrees for four 30- amp motor generator arc…

A: To find minimum size feeder conductor THHW 75 degrees motor generator arc welders = 4 numbers  , 30…

Q: (b) A 50 Hz synchronous generator with inertia constant H = 6.2 MJ/MVA is connected to an infinite…

A:

Q: A single-line diagram of a planned network is shown in Figure B1, and component parameters given in…

A:

Q: three-phase AY transformer bank shown in E TOOFYA to a balanced delta conr foll

A: Three phase transformers are used in transmission and distribution system. There are two ways to…

Q: The maximum size overcurrent device for primary only protection of a three-phase 75 kVA transformer…

A:

Fault Analysis

In an electrical engineering system, a fault is an abnormal electric current flowing through the system, and fault analysis is the study of these faults. For instance, a short-circuit is a fault where the live wire touches the ground or neutral wire. If a circuit is interrupted by a failure of a current-carrying wire then an open circuit fault occurs. The open-circuit faults are also called series faults. One or more phases or ground may be involved in a three-phase fault or may occur only between two phases. Current flows into the earth in case of a ground fault or earth fault. For most situations, the prospective short circuit current of a fault that is predictable can be calculated. To limit the loss of service because of a failure, the protective devices can detect fault conditions and operate circuit breakers and also other devices. All phases equally can be affected in a poly-phase system which is known as symmetric electrical fault. The asymmetric fault becomes more complicated to analyze if only some phases are affected. By using methods such as symmetrical components, the power system analysis of these types of faults is often simplified. The main objective of power system protection is to design, detect, and interrupt power system faults.