201 / 7 1025// In a reinforced concrete beam, b= 250mm, d = 450mm and n = 1o. The actual mavimine Stresses developed are fc= 6mpa • and fs = 120 MPa. Determine the applied. • bending moment and the steel avea • required. التاريخ الموضوع :

Q: Q6. A simply-supported beam spans 10 m and is made from a 700WB150 steel section. A static vertical…

A:

Q: 3

A: Given:- factor of safety =1.6 force=100kips To find:- most economical option

Q: Problem 2.8 - The 400-kg precast concrete section is hoisted by a vertical force 'T' from a crane.…

A: Given: Weight of concrete section = 400kg Required : Tension in cable

Q: (3) for Normal weight Concrete, using ACI Code and recommendation for high strength concrete, to…

A: Solving first questionGiven datacompressive strength of concrete given in table findmodulus of…

Q: Draw the V&M diagrams and calculate the largest permissible value of P for the beam and loading…

A: Allowable normal stress in tension=-80MPa Allowable normal stress in Compression=-140MPa To find…

Q: A steel beam is reinforced by three steel rods. The modulous of elasticity for concrete is 20Gpa and…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: Q-5) A composite beam is subjected to a couple moment M-5kN m. Knowing that the modulus of…

A: Given:Required:Maximum bending stress at point A and B

Q: (5) This simply-supported beam has been subjected to an applied moment at midspan. The M(x)…

A:

Q: Question 2 300 mm 20 mm -200 mm- ta 200 mm Section a-a 20 mm The maximum allowable tensile strength…

A:

Q: The maximum permissible load on a steel bar of 20 mm dia when the factor of safety is 1.8 and the…

A: Diameter of steel bar = 20 mm FOS = 1.8 Ultimate stress = 495 MPATO Find :The max. permissible load…

Q: 10

A: Given:- F.S.=1.6 To find:- most economical section

Q: : Determine the appropriate weigh

A:

Q: The steel channel is used to reinforce the wood beam. Determine the maximum stress in the steel and…

A:

Pressure and Stress