20 mm. 20 mm 4. The simply supported beam on the right is built up from three boards by nailing them together as shown. If P = 12 kN, determine the maximum allowable spacing s of the nails to support the load, if each nail can resist a shear force of 1.5 kN. 1 m- 1 m- S B 100 mm 25 mm- 25 mm 200 mm 25 mm

Q: The way to the column where the loading status is seen determine the P load required for the 5 mm…

A: Given that,

Q: 2-The crimping tool is used to crimp the end of the wire E. If a force of 20 lb is applied to the…

A:

Q: me average

A: The tensile force for the mechanishm is .The diameters of the rod are  and .The diameter of the pin…

Q: 2-1. The steel framework is used to support the reinforced stone concrete slab that is used for an…

A:

Q: Strength of materials Qz The steel shaft has a diameter of 50 mm and is fixed at end A and turn free…

A:

Q: - The nails are on both sides of the beam and each can resist a shear of 2 kN. In ddition to the…

A:

Q: Q4/ The aluminum bracket A is used to support the centrally applied load of 8 kip. If it has a…

A: Now draw the free body diagram of bracket,

Q: The bracket is held to the wall using three A-36 steel bolts at B, C, and D Each bolt has a diameter…

A: To findif a force P = 450 lb is placed on the bracket as shown, determine how far s, the top bracket…

Q: DRAW THE DIAGRAM OF EVERY ANALYZED PART AND LABEL THE VALUE OF SHEAR AND MOMENT. B 10 KN 3m C 3m D…

A: For AC,For BD,For DE,

Q: If A and B are both made of wood and are 3 8 in. thick, determine to the nearest 14 in. the smallest…

A: Provided that both the elements A and B are 3/8 inch thick. The applied force of 800 lb will have…

Q: Determine the shear stress at point B on the web of the cantilevered strut at section a–a.

A: Given Applied loads 2 kN and 4 kN To find Shear stress at point B

Q: The bar is connected to the support using a pin having a diameter of d =lin. If the allowable…

A:

Q: 1-103. The bar is supported by the pin. If the allowable tensile stress for the bar is (o)allow =…

A:

Q: The beam is made from two plastic pieces glued together at the seam A.  If it is subjected to the…

A: Answer: The vertical shear force resisted by the flange of the beam at the critical section is…

Q: F=(X+4) kN |B L=Y+1 m L=Y+1 m S=1YX mm 30 mm 1 H=2X0 mm -H- 300mm - - 30 mm 30 mm 30 mm The…

A: The maximum load P that can be applied to the load end of the beam is 8.6 kN.