20 kg A TW S B 10 kg PROBLEM 13.19 The system shown, consisting of a 20-kg collar A and a 10-kg counterweight B, is at rest when a constant 500-N force is applied to collar A. (a) Determine the velocity of A just before it hits the support at C. (b) Solve part a assuming that the counterweight B is replaced by a 98.1-N downward force. Ignore friction and the mass of the pulleys. VA = 3.16 m/s VA = 5.48 m/s

20 kg A TW S B 10 kg PROBLEM 13.19 The system shown, consisting of a 20-kg collar A and a 10-kg counterweight B, is at rest when a constant 500-N force is applied to collar A. (a) Determine the velocity of A just before it hits the support at C. (b) Solve part a assuming that the counterweight B is replaced by a 98.1-N downward force. Ignore friction and the mass of the pulleys. VA = 3.16 m/s VA = 5.48 m/s

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

applied mechanics 2
Pravinbhai
(a) A car of weight 600 N is at rest. Another car of weight 420 N body moving to the left with a velocity of 12 m/s collides with the car which is at rest . After impact the car which is moving before impact comes to rest. Find the final velocity of body after impact and the coefficient of restitution. (b)A vehicle of mass 13 tonnes runs into a buffer stop having three buffer springs connected in parallel each of 1150 kN/cm, 2850 kN/cm and 1350 kN/cm stiffness respectively. Find the maximum compression of the springs, if the truck is travelling at 65 km/hr. Also calculate the load acting on the spring.
Problem 81. The two mine cars of equal mass are connected by a rope which is initially slack. Car A is given a shove which imparts to it a velocity of 4 ft/sec with car B initially at rest. When the slack is taken up, the rope suffers a tension impact which imparts a velocity to car B and reduces the velocity of car A. 4 ft/sec (a) If 40 percent of the kinetic energy of car A is lost during the rope impact, calculate the velocity v imparted to car B. (b) Following the initial impact, car B overtakes car A and the two are coupled together. Calculate their final common velocity vc. ~ B S A S
I need the answer as soon as possible
A 4-kg collar A is at rest on a spring with stiffness k1 = 310 N/m, but the spring is not connected to the collar, when a force F of 220 N is applied to the cable. Knowing that A has a speed of 0.5 m/s when the upper spring is compressed 75 mm, determine the stiffness k2, in N/m ignore friction and pulley mass 450 mm peper 75 mm - 400 mm- F
5. If a ball of weight W is dropped from a height h above the ground (datum), show that the total mechanical energy of the ball in its initial position equals the total mechanical energy of the ball just before it strikes the ground AND also equals the total mechanical energy of the ball when it has fallen h/2. h Datum h 2 Potential Energy (max) Kinetic Energy (zero) Potential Energy and Kinetic Energy Potential Energy (zero) Kinetic Energy (max)
A 74 g ball B dropped from a height ho=1.9 m reaches a height h₂= 0.25 m after bouncing twice from identical 250-g plates. Plate A rests directly on hard ground, while plate Crests on a foam-rubber mat. ho B hy Determine the height h1 of the ball's first bounce. The height h1 of the ball's first bounce is m.
Solve the following problem (NOTE: Use any reasonable DATA not given in the problem.)
1. Which of the following has impulse/s that is/are NOT considered negligible during the impact of the sphere to member AB? I. Weight of Member ABC II. Weight of Sphere D III. Impact force between Sphere D and Member ABC IV. The reactions at pin B
A uniform crate C with mass m is being transported to the left by a forklift with a constant speed v1 . What is the magnitude of the angular momentum of the crate about point A , that is, the upper left corner of the crate?a. 0b. mv 1dc. 3mv1d. mv 1
(2) A 5 lb ball is attached to a 3 ft long rope and it rotates in a vertical circular path at a constant tangent velocity of 30 ft/s. (a) Determine the tension in the rope when the ball is at point A. (b) Determine the tension in the rope when the ball is at point B. B 3 ft A