2. Use the convolution integral method to derive expressions for the response of an undamped system subjected to the forcing function shown in Figure 2. F(() Fo 0 Fn(1-cos 2) Figure 2 fa

Q: Q3: Consider the force F(t) acting on the spring-mass system shown in figure (1). Using Fourier…

A:

Q: P 5.3: For the pole map shown: (a) comment on the stability of the various first-order systems, A,…

A:

Q: 4.44 Consider the 2-degree-of-freedom system defined by: [2]+[233] x=0 3¾ X= Use modal analysis to…

A: The equation of 2 degree of freedom is defined by The initial condition are

Q: Problem 1. For the OL TF design a Pl compensator to eliminate error completely for ramp input at the…

A: given,open loop transfer functionG=ks(s+3)(s+3)

Q: 5. Draw the free body diagram, write equation of motion, derive transfer function of response x to…

A:

Q: Find the Laplace transform fraction for the following function and rearrange it such that X(s)/F(s)…

A: The ggiven equation of motion is,x⃛(t)+2ζωx¨(t)+ω2x˙(t)=f(t)all zero initial condition.To…

Q: a) A control engineer has modelled the suspension system of a new model car using a 2nd order…

A: Given Data: (a) Gs=0.001s2+12s+81   To Find: (1) The natural frequency. (2) The damping ratio. (3)…

Q: Find the steady state response xss(t)

A: we have to calculate the vale of steady state response

Q: The Routh-Hurwitz criterion to be used to determine the stability of a system with a characteristic…

A: The characteristics equation is given by : Solution : The characteristics equation is given by :…

Q: Determine the sensitivity of the overall transfer function for the system shown in figure below with…

A: Step 1:Step 2::

Q: A mechanical system is shown in the figure below. This system consists of a damper (b), spring (k)…

A: Given : To find : Change in response

Q: The displacement of a mass-spring-damper system subject to an initial displacement is shown by A, B,…

A:

Q: Obtain Unit-Step Response of First-Order Systems: C (t). R(S) C(s)

A: From Block diagram: G(s)=1/sH(s)=1 The unit step input is given as: R(s)=1/s

Q: set up the integrals but do not solve them. Assume that the system is damped and you know ζ (only do…

A: (a) Draw the given diagram.

Q: 3. Given is the system in the figure below. The input is a sinusoidal vertical displacement p(t),…

A:

Q: Figure 2). 1.2 1 0.8 Peak value: 1.1878 0.6 Peak time: 2.0723 sec 0.4 splacement of mass

A:

Q: Y(s) Consider the plant P(s) = U(s) 1 with input u(t) and output y(t). s² + 2s + 10 Use Laplace…

A:

Q: Use the convolution integral method to derive expressions for the response of an undamped system…

A: For figure the force function will be so the Duhamel Integral expression can be written as