Please answer in typing format 2. The operational amplifier is as shown below:A=10,000 R=10MQR-100OwwwR0%Rwww.Apa(a) Calculate v.. with an operational amplifier asshown in the triangular shape.20 k≤2wwwb6 V2 V40 k≤2www(b) Calculate the Thevenin's equivalent resistanceRT of the circuit in part (a).

Sure, I can help you analyze the circuit in the image. The circuit appears to be an inverting…

Answered: 2. The operational amplifier is as…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 13PP: In an R-L parallel circuit, IT=1.25 amps, R=1.2k, and XL=1k. Find IR

See similar textbooks

Similar questions

This is about OpAmp Circuits. Please make it clear so I can understand, thanks.
R, V OUT Let currents and node voltage for the Op-Amp circuit be defined as follows: |1 equals the current flowing through Rin from left to right. Let Vb be the voltage at the inverting input (-). Write 1 in terms of the node voltages Vin, Vb (voltage at inverting input). O Vb - Vin O Vvin - Vb O (Vb - Vin)/Rin O Vin - Vb) / Rin O - Vin/Rin
Subject: Analog Electronic and Circuit Please Solve this question
For an inverting amplifier the input waveform is shown in the figure below. Assume that the voltage gain is -10 and total output offset voltage is zero. Ja +0.5V ov -0.5V- Which one of the following is the output waveform. (a) +10v in ov. -10V A +10V OV. -10V Kc) +5V OV +SV -SVF (d) OV $ -SV- W
7. Two important conclusions of an ideal operational amplifier are are ( ). A. Virtual ground and opposite phase B. Virtual short and virtual ground C. Virtual short and virtual open D. Open circuit and short circuit
(a) Design and implement the give expression from given de voltage Vdc-10v using op-amp.R2=100ohm and R1-120ohm (b) Find out the output voltage form the given expression? Vout = { [1+2*1*13.35*Vde+2.26*Vdc] } R1
V1
Determine the output voltage for the circuit and specify the linear range for Vs, given that Vcc = 15 V and V0 = 0. What if V0=0.1 V ?
- V2 15Vdo 3 U1A R1 2 1k V- LM324 1k V3 15Vde | VOFF = 0 VAMPL = 1 FREQ = 2k AC = 0 0. R2 Figure 4. Operational amplifier circuit. What frequency does the output voltage (across R3) have? What is the amplitude of the output voltage? From the output waveform and the input waveform, determine the gain of the op-amp circuit. Does this match with what you predicted? How could you change this circuit so that the output voltage would be nearly the same as the input voltage? What purpose would that serve? Can you modify the existing circuit and verify this experimentally? What is the phase difference between the output and input voltage? Derive the transfer function for the output-input relationship for the operational amplifier. How would the gain and the output change if a capacitor were in the feedback path instead of a resistor? (Examine the circuit using phasors and impedance and circuit analysis techniques). -w-
Please answer in typing format solution please only typing format solution please Please I will sure like it
Signal-conditioning analysis shows that the following equation must relate output voltage to input voltage: Vout = 3Vin – 3V Design circuits to do this using (a) a summing amplifier and (b) a differential amplifier
Please see picture

SEE MORE QUESTIONS

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

2. The operational amplifier is as shown below: A=10,000 R=10MQ R-100 O www R 0% R www. Apa (a) Calculate v.. with an operational amplifier as shown in the triangular shape. 20 k≤2 www b 6 V 2 V 40 k≤2 www (b) Calculate the Thevenin's equivalent resistance RT of the circuit in part (a).