2. Find Vo and the input power factor. 6/0° Arms ANSWER: 7.098/32.29° 20 kW 0.8 pf lagging + Vo 0.8454 (lagging) 16 kW 0.9 pf lagging

Q: This question is from the subject Digital Logic Design. Assume your register number SF20-BEC-xxx…

A:

Q: Find the amount of work the 3-phase motor can do in 3hrs

A:

Q: j4 2 -30 82 j52 30/0° V 52 10 2 -120 -1

A:

Q: eln (V -9 ЛИЛ -0.3 -0.2 -0.1 О 0.1 0.2 0.3 0.4 0.5 r(s)

A:

Q: Information: (2 Vp-p 50 Hz + 2 Vp-p 100 Hz) sine wave Carrier: 4 Vp-p 1000 Hz sine wave Calculate…

A:

Q: Determine the average power supplied by each source in the circuit jin jin 1020° V(:) (1) 2230° A

A:

Q: What is the value of the equivelent impedance? 250 j150 30 2 202 j102 0.46+0.21j None of the answers…

A:

Q: c. Calculate the ripple of a capacitor filter for a peak rectified voltage of 30 V, capacitor C = 50…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: SINE(0 6Vp-p 1.5K) R₁ LL 2.5 mH 100 PL On the load, find the Power (P) in Watts (W) R A 180//180 Ω…

A: Given Data: A series RL circuit with, Peak-to-peak voltage Vpp=6 V Frequency f=1.5 kHz To Find:…

Q: نقطتان (2) * the value of the frequency of the sinusoidal waveform in the figure is equal to

A:

Q: find average power of the voltage source 10Ω j10 2 -j5 -j2.4 2 j102

A: In this question , we will find average power from voltage source..

Q: A 60 Hz AC voltage source is used to supply power to the following cirouit. The source voltage rms…

A: We need to calculate current for given circuit .

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is plied to the circuit shown.…

A: A Non- Sinusoidal Voltage; e=20+15sin1000t+10sin3000t+5sin4000tTo find the total power=?Power=V2Z

Q: 30 412 V2 + Va2 i3 + R3 Va3 Va4 is 60 20V R, V4=3V1 R5 16 Rg 40 30 20 10A 2+ i7 ğımsız akım…

A: The current source given in the figure is the independent, & it is DC source The instantaneous…

Q: What will be the magnitude and phase angle of impedance when a 50 ohm resistor and 500 mH inductor…

A: Given; Resistor and inductor are connected in series R=50 ΩL=500 mHω=100 rad/s

Q: 6. What frequency will be developed if the speed is: а. 900 грm b. 1650 rpm

A:

Q: fa 5ettZ/u_4404/ nine slot Pek Phase Yoo tubastehase -300 KVA Cait Pitch 2slot Toad frind Als Luheh…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: determine the current in each branch using Nodal Analysis

A: It is given that: Zx=100∠0°

Q: QLAsingle phase half Wawe cautroted recaibrer shownca. Alew valtag lead s sufPlied bg a 2ev ae Sulny…

A:

Q: synchronous generator generates 345 V at 55 Hz when the field current is 3.5A. The e.m.f generated…

A:

Q: The open circuit characteristics (O.C.C) of an alternator is drawn between O Eo V/S If O Eo V/S Isc…

A: The open circuit test on the generator is performed by opening the armature terminals of the…

Q: AAZ 246 8 o 12

A:

Q: For the circuit below, find Vo (separate magnitude and angle by a comma, e.g. Vo = 10 V, -25.8…

A:

Q: Signai Amp. 1.5 1.0- 0.5- 0.0- 5 -0.5 -1.0- -1.5- ww 0 1 2 Time (sec.) 3 input output 4 Q1: Why…

A: There are so many  disadvantages of the two points marked by green square in frequency response…

Q: -lem 1: In the cirenit shown below, find Vs 0.2 2 jo.04 2 0.3 2 j0.15 2 ww ell 10 W 0.9 pf lagging…

A:

Q: Take look correct answer and show all work

A:

Q: What is the value of Z, in the following figure? a 4/0° A (O j102

A: To calculate the value of Thevenin impedance Zth

Q: The figure shows v(t) and i(t) across a load. Then, the impedance of the load in ko v(t) Volt, i(t)…

A: Peak value of current is 200mA Peak value of voltage is 250V  Voltage leading the current by 45°  Or…

Q: if the inductor is 1mH and the rms voltage of the generator/source is 10V in the above circuit,…

A:

Q: alculate the output impedance for the circuit shown in figure. Assume VA = ∞.

A:

Q: A synchronous generator generates 345 V at 50 Hz when the field current is 4.4A. The e.m.f generated…

A: Given Data: E1 = 345 V I1 = 4.4 A f 1= 50 Hz E2 = ? f2 = 40 Hz I2 = 2.9 A

Q: D₂ D₁ D3 DA RL

A: 4) In the given problem we have to find  Average Dc voltage

Q: 2. Three series loads are drawing 20A ms current through a 60Hz source. Load 1 is an 400W, 0.8…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: 2-We apply a Sinusoidal inPut Voltate with 2V P-r and Vav the frequency according to the table…

A:

Q: An impedance draws a current i 18cos (wt-35°) from a voltage %3D 230sin(wt+25°)|- e What is the…

A: In this question Voltage and current in the impedance is given.  Find the Maximum power  We know…

Q: The sinusoidal voltage, v(t) = 2 cos(2250t - 1.2) is applied to a 100 2 resistor. Find the…

A: In the given questions we need to calculate the instantaneous power.

Q: R = 115 ohms XL = 26 ohms Xc = 51 ohms f = 268 Hz E sine Y m C m

A:

Q: 8A voltage of 25020 is ad pplied to Inquctive cirwit of mpedance q Sompedance (5+40) caleulate…

A: Impedance is represented as Z=R+jX where R represent resistance , and X represent reactance…

Q: Three series loads are drawing 20A ms current through a 60HZ source. Load 1 is an 400W, 0.8 lagging…

A: As per guidelines we can only solve 3 subparts of seperate question, so kindly repost remaining in…

Q: Voltage Peak value RMS value Average value Peak-to- peak value O V Time VT = Vmsinwt

A: Given, The wave form is sinusoidal. Please find the below attachment for the clear explanation.

Q: A load is connected to a 210 V, 50 Hz supply. If it has resistance of 30 02 and a capacitor of 0.25…

A: Supply voltage V = 210 V.Frequency f = 50 Hz.Resistance Capacitance

Q: Find Zog: Zeg= ...2 40 2 30 2 a- 9.028/80.21° b- 8.208/80.21° c- 2.098/-80.21° 9.028/21.08°…

A: If elements Z1 and Z2 are connected in series than equivalent impedance of the series combination is…

Q: Determine the output waveform for the network of figure below and calculate the output dc level.

A: It is given that:

Q: Select the best answer for the question. R1 100 £2 ww 100 Hz LI EFA 0.2 H 14. What is the…

A: Introduction: A phase angle is an angular difference between two periodic functions, such as the…

Multistage Amplifier

The multistage amplifier is generally a voltage or power amplifier. The multistage amplifier has a number of single stage amplifier that are cascaded together. Since a single stage amplifier output is not useful, they are being replaced with multistage amplifiers or multistage transistor amplifiers. The multistage amplifier are used where the gain required is high or the input signal is very small such that only a single stage amplifier cannot amplify it.