2. A pump draws 20 lit/sec of water from reservoir A to reservoir B as shown, assuming f=0.02 for all pipes compute for the horsepower delivered by the pump and the pressures at points 1 and 2. B EL 60 EL 10 PUMP 150mm - 1200m 200mm - 500m 2.

Q: Pump inflow 2. Draw the HGL for the system shown below. The pump flow at A is 100 L/s with a 550 kPa…

A: Solution for this question is provided below ⬇️...Explanation:

Q: The 50 cm diameter pipe shown below transfers water from reservoir A to a pressure turbine and…

A: Given Data Determine the power (in HP) from the turbine (P).

Q: Situation # 4: The pump shown draws water from the reservoir A at elevation 10m and lifts it to…

A:

Q: (c) Figure Q4(c)(i) shows the system consists of 1200 m of 5 cm cast-iron pipe, two 45° and four 90°…

A: L = 1200 mD = 5 cm or 0.05 m Q = 0.005 m3/s = 0.001 kg/m s

Q: water pump at elevation 46 m. is used to bring up 250 gpm of water from a river (elev. 45 m.) to…

A: Discharge is 250 gpm Elevation of reservoir is 100 m

Q: Q2)For the system shown in the figure, the water flow rate is (40)L/s. Find the 30m power…

A: Given  Discharge, Q = 40 l/s = 0.04 m3/sec Kinematic viscosity = 1 x 10-6 m2/s  Total head = 30 m To…

Q: What is the head that must be supplied by the pump to the water to pump 0.4 m³/s from the lower to…

A: step 1-

Q: A 20-lb tank that has a volume of 15 ft3 is filled with liquid water at 20C. Determine the weight…

A:

Q: A pump draws water from reservoir A and lifts to reservoir B. Points 1 and 2 are points just before…

A: Given, Discharge, say Q = 15 L/s = 0.015 m3/s [1 m3 = 1000 L] Diameter of pipe at 1, D1 = 150 mm =…

Q: 7- a) b) c) d) For the transmission line shown below, what is the power of the pump with efficiency…

A: Efficiency, η=70% Flow rate, Q=200 lit./s The density of water, ρ=9806 N/m3 The slope of the…

Q: Determine the flowrate Q for this system.

A: ###Determination of Flow Rate and  ##Calculation of EGL and HGL###

Q: A pump is used to lift 120 L/s of water at 10°C from a river to a storage tank that has a free…

A: Given, Q = 120 L/s or 0.12 m3/s D = 350 mm or 0.35 m  L = 1200 m  e = 0.02 mm

Q: Fig. 2. Assume constar factors, with f = 0.018. The head-discharge relation for the pump is Hp =…

A:

Q: If water is pumped from reservoir 1 to reservoir 2 through a 20 cm pipe with a length L1=70 m, and…

A: The expression for velocity in pipe is given as V=QA Substitute the value in above expression V=0.15…

Q: For the branching pipe system shown, determine the flow in each branch. The fluid in each reservoir…

A: Given:For branch-A:L1=5000 mD1=1.5 mz1=135 mFor branch-B:L2=800 mD2=50 cm=0.5 mz2=120 mFor…

Q: Consider the section of water distribution piping shown below. Ignoring minor losses, find the total…

A:

Q: (67) The water tank shown is filled by pumping water from the well where the water level is located…

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?