2. A 36, 60 Hz, 6 pole, wye-connected induction motor is rated at 600 hp (1 hp = 746 W) and 800 V. The parameters of the equivalent circuit are R1 = 0.08 N X1 = 0.15 N Xm = 16 N R2 = 0.04 N X2 = 0.08 N The friction and windage losses are 0.6 kW. You may ignore the core losses for this problem. For a slip of 3%, determine the following, assuming the line-neutral terminal voltage angle ZVi is zero: (a) Line current and power factor (b) Air-gap power

2. A 36, 60 Hz, 6 pole, wye-connected induction motor is rated at 600 hp (1 hp = 746 W) and 800 V. The parameters of the equivalent circuit are R1 = 0.08 N X1 = 0.15 N Xm = 16 N R2 = 0.04 N X2 = 0.08 N The friction and windage losses are 0.6 kW. You may ignore the core losses for this problem. For a slip of 3%, determine the following, assuming the line-neutral terminal voltage angle ZVi is zero: (a) Line current and power factor (b) Air-gap power

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A four pole machines generates 250V when operated at 1500 rpm. If the flux per pole is 1.85 x 106 maxwell, the number of armature slots is 45 and the armature winding has two parallel paths. If the speed of the generator is reduced to 1350 rpm, what would be the generated voltage. To what value of flux per pole should the excitation be adjusted if the generated voltage is to remain the same at 250V
q. 7
Q3 A three-phase induction motor has the following data: 50 hp and V440 and 50HZ operating at full load with an efficiency of 89% and a power factor of0.85 lagging. Calculate the total apparent power of the capacitors to raise the power factor at full load to 0.95 lagging. What is the value of the capacitors' capacitance for each phase if we connect the capacitors (a) in the form of delta (b) in the form of a star.
A three phase 4 pole star connected alternator has 120 slots on the armature. Each slot contains 8 conductors. It is driven at 350 rpm. The line value of emf available across the terminals is 2.6kV. Find the frequency of induced emf and flux per pole. Frequency of Induced EMF = Number of turns = Flux per pole
A short shunt compound generator supplies a load of 20 kW at 500 V. The armature, series and shunt field resistance are 0.10 ohm, 0.05 ohm, and 100 ohms respectively. Find the power developed in the armature. Choices: 24600 W 20500 W 22800 W 25400 W
Question: A 4 Pole DC Generator Is Wounded Lap. It Rotates At 500rpm To Be Able... A 4 pole DC generator is wounded lap. it rotates at 500rpm to be able to generate 150 V of open circuit voltage. What is the percentage decrease in the exixting flux per pole if a frequency of 10 rps can produce 120 V? %.
For an ideal Diesel cycle with the overall value of k = 1.33, rk = 15, r2 = 2.1, p1 = 97.9 kPa and find p2 and pm
D6.
At rest condition, the slip of induction motor i 1. Select one: True False
A 25cps single-phase, 8-pole, alternator with 725 mWb flux per pole has 288 slots. The machine coil has 2 turns per coil. In the winding of the armature, the ratio between the chording angle to the fractional pitch is 1/8. Find the voltage between two terminals.
A 6 pole DC lap wound generator has 41 armature conductors with flux per pole is 23 mWb and the e.m.f generated is 80 V, then the speed of the machine is O 0.74 rps O 84.84 rps O 7.43 rps 84.84 rps
i need the answer quickly