2. A 30-m steel tape weighing 1.45 kg is of standard length under a pull length. The tape was used in measuring a line 938.55m long on a smooth level ground under a steady pull of 10 kg. Assuming E = 2x10° kg/cm² and the unit weight of steel to be 7.9x10° kg/cm?. a. Determine the cross-sectional area of the tape in cm?. 5 kg. supported b. Determine the correction for increase in tension. c. Determine the correct length of the line measured.

Q: Figure 2a shows a uniform beam subject to a linearly distributed load. The equation for the…

A:

Q: From the figure below determine A = 1500mm^2, E = 200,000MPA a. Determine the Horizontal Deflection…

A:

Q: W = 30 K/m L= 3m E- 18GPA;b=200 mm %3D d: 400 mm

A:

Q: What must be the pull in a (7)(10) meters tape in order to eliminate the sag and temperature…

A:

Q: Q5. Determine the maximum normal stress in the rectangular bar with a shoulder of circular fillet…

A:

State Plane Coordinate Systems

The state plane coordinate system (SPCS or SPS) is a collection of 124 coordinate systems or geographic zones prepared for particular regions of the U.S. Every state consists of one or more than one state plane zone, the boundaries of which generally follow the county lines. Inside the U.S., there are 110 zones in total, 10 more zones in Alaska, 5 in Hawaii, and 1 for Puerto Rico and US Virgin islands. The system is extensively used for geospatial and geographic data assembling by the state and local governments.