2: Find the capillary rise in the tube shown in Fig. 02 below for a water-air-glass interface (6-0") if the tube radius is 1 mm and the temperature is 20 °C. consider o =0.0728 N/m. 2r Fig. 02

Q: A 1 meter long steel rod AB of 15-mm diameter is held snugly (without any initial stresses) between…

A:

Q: Problem 1. In a test on an aerosol can it was loaded to a gage pressure p = 69.0 psi. While…

A: inside pressure p=69 psinormal load N=400 lb and torque  T=250 lb-indiameter d=3.0 in   and radiud…

Q: A compound shaft consists of a titanium alloy [G = 6,200 ksi] tube (1) and a solid stainless steel…

A: Free body diagram:- For tube 1 G=6200 ksiL1=44 inD1=2.15 int1=0.130 inFor tube 2G=11500 ksiL2=68…

Q: A solid copper rod is of cross-sectional area 15 mm2 and length 2m. Calculate: a)its change in…

A:

Q: Find the capillary rise ( h) in the tube shown in the figure for a water-air-glass interface with O=…

A:

Q: The thickness of the boundary layer for a fluid flowing over a flat plate at a point 20 cm from the…

A: Given: Thickness of boundary layer, δ=4 mm Distance from the leading edge, x = 20 cm = 200 mm…

Q: I need the answer as soon as possible

A: Given data:- Cross-section of plate is 0.5 m × 0.3 m  Thickness of plate is 0.01 m Young's Modulus…

Q: In a two-layer fluid with specific gravities 1.2 and 0.9, a cube of 60cm is immersed. If the upper…

A: Dimensions of the cube: 60 cmSpecific gravities of the two layers of the fluid: 1.2 and 0.9Specific…

Q: A 1-m long steel bar(E = 200 GPa) of 10x10mm dimension fixed at one end and the other end having a…

A: Given data  Length of bar (L) = 1m  = 1000 mm  E = 200 GPa = 2*105 MPa  Dimension of bar = 10 * 10…

Q: What loads are exerted on the ends of the tube, and what are the resultant stresses?

A: Length of the aluminum tubing L = 13 in Modulus of elasticity E =  Coefficient of thermal expansion…

Q: 2. A rigid bar of negligible weight is supported as shown. If W = 80 kN, compute the temperature…

A:

Q: The 80-kg lamp is supported by two rods AB and BC as shown in Fig. If AB has a diameter of 10 mm and…

A:

Q: A 0.35-m long steel rod with a round cross-section (25 mm) is resting on a frictionless surface. The…

A: The given data is: Length of steel rod (L) = 0.35 m Diameter of steel rod (d) = 25 mm Coefficient of…

Q: 2) Determine the reaction forces at both walls, if temperature is raised from 30°C to 90°C. The…

A:

Q: A compound shaft consists of a titanium alloy [G = 6,200 ksi] tube (1) and a solid stainless steel…

A:

Q: Calculate the reaction at rigid supports in kN. 2. Calculate the change in length of the aluminum…

A: From the given figure it is required to calculate The reaction at rigid supports in kN. The change…