*2-16. Due to its slight compressibility, the density of water varies with depth, although its bulk modulus Eş = 2.20 GPa (absolute) can be considered constant. Accounting for this compressibility, determine the pressure in the water at a depth of 300 m, if the density at the surface of the water is Po = 1000 kg/m. Compare this result with water that is assumed to be incompressible. www.jar

*2-16. Due to its slight compressibility, the density of water varies with depth, although its bulk modulus Eş = 2.20 GPa (absolute) can be considered constant. Accounting for this compressibility, determine the pressure in the water at a depth of 300 m, if the density at the surface of the water is Po = 1000 kg/m. Compare this result with water that is assumed to be incompressible. www.jar

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

For the thin walled pressure vessel subjected to an internal pressure of 150 psi and as shown below, calculate the longitudinal and transverse stresses. Assume length as L ft and wall 1 thickness as - in. 8 2 ft E 2.5 ft
The pressure in a gas tank is 2.75 atm. Compute the pressure head in meters of water. The unit weight of a liquid is variable and is given by the relation y = 10 + 0.5h. Determine the gauge pressure in kPa at a depth of 5m. %3D
A circular disc of diameter 40 cm is submerged vertically in water. The top most point of the disc just touches the water surface. A. What is the hydrostatic force acting on disc B. Detrmine location of center of pressure below water surface Complete solution needed
The surface tension of mercury at 60°C is 0.47N/m. What capillary height in mm will occur in this fluid whe in contact with a glass tube of radius 0.3mm? Use 130° for mercury. O 11.5mm fall O 11.5mm rise O 15.1mm fall O 15.1mm rise
There is a capillary action that takes place above the groundwater table up to 1.3 m in height. Assume the unit weight of water is ten kPa. Calculate the pore water pressure at the surface of groundwater table
A thin cylinder of external diameter 820 mm, length 3 m and wall thickness of 10 mm is subjected to an internal pressure of 2.5 N/mm2 . Determine the change in diameter and length. Take Young’s modulus = 2×105 N/mm2 and Poisson’s ratio = 0.25.
Problem- Find the surface tension in a soap bubble of 50 mm diameter with its inside pressure being 2.5 N/m² above the atmospheric pressure.
In a two-layer fluid with specific gravities 1.2 and 0.9, a cube of 60 cm is immersed. If the upper and lower halves of the cube are composed of materials having specific gravity 0.6 and 1.4, respectively, then the height of cube above the interface of fluid is cm. [Assume, weight density of water as 9.81 kN/m³] (round off to the nearest integer). Liquid 1: S.G=0.9 S.G=0.6 S.G 1.4 60 cm Liquid 2: S.G=12 30 cm 30 cm
. The ratio of pressures between two points A and Blocated respectively at depths 0.5 m and 2 m below a constant level of water in a tank is:
A vertical clean glass piezometer tube has an inside diameter of 1 mm. When pressure is applied, water at 20°C rises into the tube to a height of 25 cm. After correcting for surface tension, estimate the applied pressure in Pa.