The pressure inside the droplet of water of diameter 0.16 mm is 10 N/cm² (atmospheric pressure). Calculate the pressure (absolute) within the droplet if surface tension is given as 0.0725 N/m of water.

The pressure inside the droplet of water of diameter 0.16 mm is 10 N/cm² (atmospheric pressure). Calculate the pressure (absolute) within the droplet if surface tension is given as 0.0725 N/m of water.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The surface tension of water in contact with air at 20°C is 0.0725N/m. The pressure inside a droplet…

A: Given: Surface Tension σ=0.0725 N/m, Pressure intensity, P in excess of outside pressure is…

Q: Please be clear with your soltuion. In the figure, x=25cm initially. If the pressure at m is…

Q: 4 Determine the absolute pressure at A in kPa if the atmospheric pressure is 101.325 kPa. 92.876…

A: Figure is shown in the question

Q: Analyze the figure below and determine the absolute pressure in the tank. Take the density of water…

A: Please refer the attached image for complete solution. THANK YOU.

Q: x=1, y=5

A: Given values: x=1, y= 5 (a) Fluid A is gasoline, G1 = 0.715 Gauge liquid is mercury, G2 = 13.6 z =…

Q: Taking the coefficient of compressibility of water to be 2200 MPa, determine the pressure increase…

Q: 1. The gage pressure of the air in the tank shown in the figure below is measured to be 65 kPa.…

Q: Consider the opening exposed to the atmosphere at 1 atm, find the pressure at point A. Refer to the…

Q: Calculate the laminar boundary layer thickness by using Prandtl -Blassin's relation at the middle of…

A: Given- Density of fluid ρ=1000 kg/m3 Velocity of flow v=20 m/s Length of plate=10 m, x=10 m/2=5 m,…

Q: a. Water and oil flow in horizontal pipelines. A double U-tube manometer is connected between the…

Q: Find an expression for the pressure p in cm of water when the liquid reads y cm in the tube, in…

Q: 2. Determine the height of the water from the right leg if the liquid added in the left leg has a…

Q: Ex.1 Ans. A glass tube 0.25 mm in diameter contains a mercury column with water above the mercury.…

Q: Please

Q: 6 Determine the absolute pressure at C in kPa if the atmospheric pressure is 101.325 kPa. * 105.525…

A: Figure is as shown

Q: Two spherical vessels of different sizes contain the same gas and are connected by means of a pipe…

A: NOTE - Since we only answer up to 3 sub-parts, we’ll answer the 4, 5 and 6. Please resubmit the…

Q: Based on the expression dp/dz = -pg, at what elevation is the absolute pressure 70% of the pressure…

Q: ← Fluid Properties The diameter of droplet is 0.075 mm. What is the intensity of the pressure (N/sq.…

A: Given Data Diameter of droplet (d) = 0.075 mm Surface tension = 0.000075 N/mm Find the intensity…

Q: Surface tension of water when in contact with air is 0.0737 N/m. The difference in pressure between…

A: Given: Surface tension of water = 0.0737 N/m Diameter of rain droplet = 1mm Required: Difference…

Q: A welded steel cylindrical drum made of a 10-mm plate has an internal diameter of 14 m. Compute the…

A: σy=Longitudinal Stressσy=pD4tσy=14×140004×10σy=4900 Mpaσx=Tangential…

Q: The closed cylinder shown is filled with water to a depth of 100mm and rest with air. What is the…

Q: 7. In the figure shown, determine the value of z when the pressure at A is 10 psi greater than at B.…

Q: The surlace tension of water in contact with air at 20°C is given as 0.0716 N/m. The pressure inside…

A: Given data : Pressure intensity greater than outside temperature (p)=0.0147 N/cm2Surafce tension…

Q: If the Patm = is 101.3KPa and the Pabs at the bottom of the tank is 231.3 kPa. y of H28 = 9.79kN/M^3…

Q: The ratio of pressures between two points A and B located respectively at depth 0.5 m and 2 m below…

A: Depths at points A and B are- hA=0.50 m and hB=2 m. To Find- The ratio of pressures between two…

Q: 5 Determine the absolute pressure at B in kPa if the atmospheric pressure is 101.325 kPa. * 105.543…

A: Given data in question Atmospheric pressure 101.325 kPa Depths Specific gravity 0.86 To find out…

Q: A solvent used for plastic manufacturing consists of cyclohexanol in tank A and ethyl lactate in…

A: Specicific gravity of cyclohexanol, Sc=0.953Specific gravity of mercury, SHg=13.55Specific gravity…

Q: Q- A mercury water manometer has a gauge difference of 0.8 m. Th difference in pressure measured in…

A: Given data: Gauge difference, h = 0.8 m. Density of mercury, ρm=13.59 grams per cubic centimeter.…

Q: When the pressure inside a vessel is 22.75 psig. then the absolute pressure equal to:

A: given - pressure inside a vessel Pgage = 22.75 Psi to find - absolute pressure (Pabs)

Q: Q.11 A liquid compressed in a cylinder has a volume of 0.0113 m³ at 6.87 x 106 N/ 3 m² pressure.…

A: Initial volume =0.0113 m3, Initial pressure = 6.87×106 N/m2, Final volume=0.0112 m3, Final pressure…

Q: : liquid level in

A: To find : Ratio of rise in liquid. Given : The ratio of the surface tension S and density ρ of…

Q: In the Figure below, a pool of liquid sodium is sitting in open atmosphere (and somehow not…

A: (a) Pressure Gradient: Pressure at surface of the liquid sodium, p1=0 Pressure at the depth L from…

Q: 1. If in figure , the pressure at m is 20 Ib per sq.in., what is the corresponding pressure at n…

A: Pressure is defined as the force exerted by the unit area. The pressure of the fluid is calculated…

Q: 4 in. Oil 3 in. 12 in. Water Mercury The pressure in pipe A is greater than in pipe B. The pressure…

Question

The pressure inside the droplet of water
of diameter 0.16 mm is 10 N/cm²
(atmospheric pressure). Calculate the
pressure (absolute) within the droplet if
surface tension is given as 0.0725 N/m of
water.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data-

VIEW

Step 2: To Find-

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The surface tension of water in contact with air at 20°C is 0.0725N/m. The pressure inside a droplet of water is to be 0.02N/cm² greater than the outside pressure. Calculate the diameter of the droplet of water.
The system in the figure is at 20°C. If the pressure at point A is 1900 lb/ft², determine the following: (a) gage pressure at B (b) gage pressure at C, and (c) gage pressure at D. Express all answers in lb/ft². Air Water 3 ft 5 ft AO B 2 ft D 2 ft
An open tube is attached to a tank as shown. A). If Liquid X (Oil SG=0.55) rises to a height of 800 mm in the tube, what is the pressure Pa (in kPa) of the air above water? Neglect capillary effects in the tube. B). If Liquid X (Alcohol SG=0.79) rises to a height of 800 mm in the tube, what is the pressure Pb (in kPa) of the air above water? Neglect capillary effects in the tube.
Be quick to answer this,.
*2-16. Due to its slight compressibility, the density of water varies with depth, although its bulk modulus Eş = 2.20 GPa (absolute) can be considered constant. Accounting for this compressibility, determine the pressure in the water at a depth of 300 m, if the density at the surface of the water is Po = 1000 kg/m. Compare this result with water that is assumed to be incompressible. www.jar
3Q. At normal atmospheric conditions, approximately what pressure in MPa must be applied to water to reduce its volume by 3%? (Take Ey= 320,000 psi at normal atmospheric conditions)
2
Asap please.
1.) A pressure in a given tank reads 398 mm of Hg. Determine the equivalent height of a certain fluid in m with sp.gr= 4.33.
Please Help me solve Problem 1,2 and 3 ? Thank you.
Given the bulk modulus of water B-2.1x1o° Pa= 2.1 GPa, What increase in pressure needs to be applied to the surfaces of a cube of water 1 m on a side to reduce its volume by 4%? O a 0.0600 GPa Ob. None. O c.0840 GPa O d. 0.0700 GPa O e 0.1050 GPa
A reservoir contains two different fluids is shown in the figure. The height of the water is 8 m, and the height of the oil (SG = 0.86) is 4 m. a. Determine the density of the oil. b. Determine the pressure between the oil and water in kPa. C. Determine the pressure at the bottom of the reservoir in kPa. OIL WATER