19–18. The 4-kg slender rod rests on a smooth floor. If it iskicked so as to receive a horizontal impulse I = 8 N•s atpoint A as shown, determine its angular velocity and thespeed of its mass center..75 m60I = 8 N:s

Answered: 19–18. The 4-kg slender rod rests on a…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The 10-kg uniform cylinder is pin supported at its center O. The square isacted upon by a constant force F = 10N and a constant couple moment M = 10 Nm.If the disk starts from rest, determine1) The reactions at the pin O and the angular acceleration of the disk2) The number of revolutions it must take to attain an angular velocity of 10 rad/s
19–43. The mass center of the 3-lb ball has a velocity of (vG)ı = 6 ft/s when it strikes the end of the smooth 5-lb slender bar which is at rest. Determine the angular velocity of the bar about the z axis just after impact if e = 0.8. 2 ft 2 ft (vG)1 = 6 ft/s 0.5 ft r = 0.5 ft
SOLVE USING PRINCIPLE OF WORK AND ENERGY
The 45-kg reel has a radius of gyration about its center O of ko = 220 mm. If it is released from rest, determine the total external work done to it when its center O has traveled 6.6 m down the smooth inclined plane (with angle = 35°). Please pay attention: the numbers may change since they are randomized. Your answer must include 1 place after the decimal point, and proper SI unit. Take g = 9.81 m/s². 0.4 m 0.2 m²
The uniform 50-kg sphere has radius r = 0.2 m and is welded to the center of the uniform 30-kg shaft as shown. When a constant couple moment M is applied to the shaft, its angular velocity reaches 74 rad/s after 4 s. Determine the magnitude of the moment M. Write your answer in N.m but do not write the units. M R= 0.1 m Taylor e m Te am Answer: Answer
19–33. The 80-kg man is holding two dumbbells while standing on a turntable of negligible mass, which turns freely about a vertical axis. When his arms are fully extended, the turntable is rotating with an angular velocity of 0.5 rev/s. Determine the angular velocity of the man when he retracts his arms to the position shown. When his arms are fully extended, approximate each arm as a uniform 6-kg rod having a length of 650 mm, and his body as a 68-kg solid cylinder of 400-mm diameter. With his arms in the retracted position, assume the man is an 80-kg solid cylinder of 450-mm diameter. Each dumbbell consists of two 5-kg spheres of negligible size. -0.20 m 0.65 m 0.3 m H0.3 m Prob. 19–33
The shown spool has a mass of 450 kg and aradius of gyration Gk=1.2 m. It rests on thesurface of conveyer belt for which the coefficient offriction m= 0.5. If the conveyer acceleratesat2 1.2m / S and the spools rolls without slipping,determine the tension in the wire and the angularacceleration of the spool
At the instant shown, the spring is un-deformed. Determine the change in potential energy if the 20 kg disk (with radius of gyration kG = 0.5 m) rolls 2 revolutions without slipping. k= 200 N/m 3 m/s datum 0.3 m M = 2 Nm 30° O 1791 J O -1791 J O 1051 J O 1421 J O E) None of the above
The 3.8 kg block is descending at a rate of 1.2 m/s when the hydraulic cylinder BC exerts a force F=500 N on the brake arm. Determine the number of radians the wheel will rotate before the system comes to rest. The wheel has a mass of 25 kg and a radius of gyration about its center kO=300 mm. The coefficient of kinetic friction between the brake arm and the wheel is 0.25.
The pavement compactor is traveling down the incline at VG = 5 ft/s when the motor is disengaged. The body of the compactor, excluding the rollers, has a weight of 8000 lb and a center of gravity at G. Each of the two rear rollers weighs 400 lb and has a radius of gyration of KA = 3.3 ft. The front roller has a weight of 800 lb and a radius of gyration of kg = 1.8 ft. The rollers do not slip as they rotate. (Figure 1) Figure 3.8 ft 5 ft A GT 10 ft 1 of 1 30 730 ▼ Part A Determine the angular velocity of the roller B when the compactor has traveled 16 ft down the plane. Express your answer in radians per second to three significant figures. WB = Submit IVE ΑΣΦ | Η Provide Feedback Request Answer P Pearson vec ? rad/s Next >
18–37. The spool has a mass of 20 kg and a radius of gyration of 200 mm ko = 160 mm. If the 15-kg block A is released from rest, determine the velocity of the block when it descends 600 mm. A
The 15 kg pendulum shown has its mass center at G and a radius of gyration about its mass center of kG = 200 mm and was released from rest when 0 = 0°. Spring AB has a stiffness of k = 200 N/m and is un-stretched when 0 = 90°. The angular velocity of the pendulum in rad/s at the instant 0 = 90° is: -0.6 m- а, 3.2 · b. 4.3 m . с. 3.6 0.1 m · d. 4.4 О е. 3.4 O f. 3.8 O g. 4.6

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS

19–18. The 4-kg slender rod rests on a smooth floor. If it is kicked so as to receive a horizontal impulse I = 8 N•s at point A as shown, determine its angular velocity and the speed of its mass center. .75 m 60 I = 8 N:s