18 Students were provided with cubes of slightly alkaline gelatine of different dimensions, containing an acid-alkali indicator that is red in alkali but yellow in acid. The cubes were placed in dilute acid solution, and the time taken for the colour in the gelatine to change from red to yellow was measured. Dimensions/mm Surface area/mm² Volume/mm³ Time/minutes 10 x 10 x 10 600.0 1000.0 12.0 5x 5 x5 150.0 125.0 4.5 4x 4 x4 96.0 64.0 4.2 2.5 x 2.5 x 2.5 a For each block, calculate the ratio of surface area to volume (SA:V). b Plot a graph of the time taken for the colour change (vertical or y axis) against the SA:V ratio (horizontal or x axis). c Explain why the colour changes more quickly in some blocks than others. 37.5 15.6 4.0

Q: in the data given,  using salometer, water and salt is being combined with that the results showed…

A: Introduction: Distilled water is water that has many of its impurities removed through distillation.…

Q: How would u calculate difference between and percent error?

A: percent error: Percent errors show the magnitude of our measurement errors during an analysis…

Q: What is the chemistry principle behind when (treatment: evaporated milk) is subjected at room…

A: Evaporated milk is subjected to chilling prior to whipping. Air bubbles get incorporated in the…

Q: Based on the information given, what is the single diagnosis (acute or chronic kidney disease) the…

A: Kidneys are very important body organs. They eliminate body waste products. Any malfunction of…

Q: Appropriate pippetor for measuring 10ul of liquid is:  200 1000 20

A: INTRODUCTION Pipette Pipette is a laboratory equipment used to transfer small quantities of liquid.

Q: Louie performed paper chromatography to identify which among the four available reference mixtures -…

A: The technique of separating substances based on the differential migration across sheets of paper is…

Q: 8 7- 6- 2- 1 405 180 225 270 315 [Substrate] (nM) 45 90 135 360 450 495 540 58! What are the units…

A: Solution   Michaelis menten kinetics is one of the best models of enzyme kinetics.   Value of…

Q: 80-000 A7000 MN KANAMYCIN INJECTION, USP *1 g/3 mL (333 mg/mL) For IM or IV Use 3 mL Vial Rx only 10…

A: For solving this we would use the following solution X = D x Q / A Where X = amount of drug taken…

Q: The table below summarizes the results for the solubility test. Which solvent the lipid samples are…

A: The solubility of a substance in a solvent depends on the nature of the solute and the solvent.

Q: Prepare the following solutions 1. 250.0 mL 0.0100 M working EDTA solution from 0.1000 M EDTA  2.…

A: a. Most of the reagents that are required are available in solutions that need to be purchased or…

Q: (a) In an experiment to determine the glycine concentration of test sample A, the Ninhydrin method…

A: Absorbance of a solution is directly proportional to its concentration. This is as per Lambert Beer…

Q: Calculate the mass percent of this solution

A: 16.7 grams in 645 ml solution Density of solution : 1.09 g/ml

Q: How much of 10,000x SYBR safe would you add to 50 ml to make a final concentration of 1x?

A: The stock solutions can be diluted to obtain a lower concentration. Preparing stock solution…

Q: pH 3.5 4.5 5.5 6.5 7.5 8.5 Absorbance 0.098 0.027 0.068 0.028 0.032 0.054…

A: We can do this by multiplying the concentration in the undiluted supernatant by the dilution factor…

Q: what are the principle chemical reaction involved in each test?

A: The primary, secondary and tertiary alcohols react with hydrogen halides in a different manner and…

Q: What volume of Water for Injection, BP to be added to a vial containing 1000 mg of drug A to produce…

A: The pharmaceutical sector is a very significant field nowadays since the discovery of new…

Q: 17 Your patient requires 15mg Buspirone Hydrochloride orally. The tablets available are 5mg. How…

A: The patient requires 15mg drug and the drug is available in 5mg, so if we administer the 5mg tablet…

Q: 11 of 11 What volume (in uL to 1 decimal place) of stock SybrSafe solution (3.4 mg/mL) would you add…

A: Given- 1. Concentration of stock solution =  3.4 mg/ml 2. Volume of agarose solution = 120 ml 3. The…

Q: What graph or chart would be appropriate for this table?

A: A graph is a way of pictorially representing the data in an organized manner, thereby establishing a…

Q: 4. If you are asked to prepare 15 mg?

A: Lidocaine is also called as lignocaine. It is a local anesthetic agent. Uses : It is used to treat…

Q: The calibration curve shown below was used to analyze an unknown protein solution. What is the…

A: The unknown concentration of a substance in the given sample can be estimated by comparing the…

Q: D-4: Zinc + Water/Zinc + HCI 55. Observation on combining Zn metal, 2 mL of water, and 2 drops of…

A: Observation and combination of reaction has been done of the following chemical: Zn metal 2ml of…

Q: Questions 6, 7, 8, and 9 pertain to the following TPN order for a 154 lb patient. TPN Order 540 kcal…

A: TPN stands for Total Parenteral Nutrition and is composed of various nutrients that supplies…

Q: What is the volume of liquid for a P-10 with the current setting? 8.

A: A micropipette is a common yet necessary laboratory device for accurately and precisely transferring…

Q: After three minutes, the concentration of drug Zip in the red blood cells is 10 mmoles l-1. What is…

A: The rate of reaction is the rate of change of concentration of a reactant or product with time, then…

Q: - Cryoscopic method - White-Vincent Method - E method - Sprowl's method   It is the most widely used…

A: Asked : To match description with tonicity method

Q: 3. A 30.0-ml. sample of 0.20 M HA was titrated with 0.20 M NAOH. The following data were collected…

A: Given Values: Concentration of HA = 0.2 M Volume of HA = 30 ml = 0.03 L Concentration of NaOH = 0.2…

Q: What is the molecular weight of the molecule that gets eluted from the column at 10 ml?

A: The given graph shows a linear relationship between the elution volume (ml) on x axis and IgM…

Q: You performed a two-fold serial dilution, assuming that the starting concentration is 128 µg/ml…

A: Antibiotic is a chemical substance, as penicillin, derived from a microorganism and capable of…

Q: For his experiment, Brian needs to prepare 30 plates (use maximum volume), 15 slants (small test…

A: In order for the microorganisms to survive and grow under laboratory conditions we need to provide…

Q: pH 3.5 4.5 5.5 6.5 7.5 8.5 Absorbance 0.098 0.027 0.068 0.028 0.032 0.054…

A: To calculate the amount of soluble protein (in grams) in the soy flour extract, we need to use the…

Q: explain what the results of this experiment are and the purpose Table 2   Absorbance vs CoCl2…

A: The Beer-Lambert Rule:  The concentration of the absorbing species and the route length of light…

Q: A patient is prescribed 15mmol of potassium chloride injection. The ampoule contains 20mmol in 10ml.…

A: Given data    A 10 ml ampule contains = 20 mmol

Q: Table 2   Absorbance vs CoCl2 concentration   Test Tube Number Cobalt Chloride Concentration…

A: Spectrophotometry or colorimetry is an analytical technique that is used for the quantification of…

Q: Ephedrine sulfate (fz. pt = -0.13°C). 2% Sodium chloride MW 58.5 Purified water qs ad. 30 mL…

A: INTRODUCTION- Lachrymal fluid is isotonic in nature of a 0.9% Nacl solution. Eye solution or…

Q: Calculez: 0.02cm+3.72mm+0.024m+230µm. Give the answer in mm (do not round off your answer, write…

A: A micrometer, often called a micron, is a unit of length in the metric system, symbolized as µm. It…

Q: Osmosis Red Blood cells are isotonic with a Nacl solution that is 0.90% (m/V) Nad also known as…

A: Hi! Thanks for your question. As you have posted multiple questions we are answering only the first…

Q: This is a question regarding spectrophotometry. Scenario: 0.1 mL of the unknown and 0.9 mL of…

A: When 0.1 ml of the unknown and 0.9 ml of the distill water are mixed. The dilution of the unknown =…

Q: separating gel. The separating gel is 12% acrylamide, 0.1% SDS, 0.375 M Tris-Cl, pH

A: Introduction SDS ( sodium dodcyl sulfate) is an anionic detergent which is negatively charged. And…

Osmosis

In simple words, osmosis is the slow, gradual movement of a liquid through a membrane. But there are nuances to this process. For instance, there has to be an imbalance in the distribution of solute in the liquid on either side of the membrane, which has to be semipermeable. The liquid in the region with a lower solute concentration moves to the region with a higher concentration, thereby displacing the solution in the process. The objective is to equalize the concentration of molecules on both sides of the membrane; the displacement of liquid can be viewed as a byproduct of this equalization. Since there is no energy required to carry osmosis, it is considered a passive process.