18 in. 70° B 4 in.

Q: In the figure, a nonuniform bar is suspended at rest in a horizontal position by two massless cords…

A: In the figure, a nonuniform bar is suspended at rest in a horizontal position by two massless cords…

Q: How far horizontally from that cable is the center of mass of the system

A:

Q: The tension in the cable from D to A is 75 N. Determine the moment of this force about point O…

A: TAD = 75 N

Q: A weight with mass ?w=250 g is tied to a piece of thread wrapped around a spool, which is suspended…

A: Write the net force experienced by mass mw.

Q: A potter's wheel-a thick stone disk of radius 0.500 m and mass 125 kg-is freely rotating at 50.0…

A: THe moment of inertia of the disk is,I=12mR2                                       m=125…

Q: A 23.0 kg bucket of water is suspended by a very light rope wrapped around a solid uniform cylinder…

A: Draw the free-body diagram of the system.

Q: A diver of weight 570 N stands at the end of a diving board of length L = 4.5 m and negligible mass…

A:

Q: A window washer stands on a uniform plank of mass 125 kg and length 7m supported by a rope attached…

A: 4018 N

Q: Even when the head is held erect, as in the figure below, its center of mass is not directly over…

A: As there are two force acting perpendicular to a fixed point, these forces generate a torque around…

Q: 12 1b

A: Given: The length of the rod is 9 ft. The weight of the rope is 5 lb.

Q: The pendulum is connected to the vertical shaft by a clevis at A. The mass of the bob B is 1.2 kg,…

A: Given data: Mass of bob is m=1.2 kg. Length of AB is l=0.4 m. Angle with vertical is θ=85°.

Q: In the figure, a nonuniform bar is suspended at rest in a horizontal position by two massless cords…

A: From the above picture

Q: a nonuniform bar is suspended at rest in a horizontal position by two massless cords. One cord makes…

A:

Q: Figure A B 3.0 m 1 of 1 > Calculate the torque (magnitude and direction) about the front support…

A:

Q: The constant tensions of 200 N and 160 N are ap- plied to the hoisting cable as shown. If the…

A: Given: Initial velocity v1=-2 m/s taking negative sign for downward direction.  final velocity v2=v…

Q: In the figure, a nonuniform bar is suspended at rest in a horizontal position by two massless cords…

A: Given Data: The bar length, L = 6.6 m One cord angle is 44.9 degrees and another one is 45.1…

Q: A block with mass m1 = 3.00 kg sits on a horizontal table and is attached to a rope. The rope then…

A:

Q: Create a FBD for M that is attached to the lower end of the cord. Assume, for the moment, that the…

A:

Q: A woman climbs a ladder against the side of the building and wants to climb 3/4 of the way to the…

A: Friction  force between building and ladder = 0 But friction force between ladder and ground = f g =…

Q: A potter's wheel-a thick stone disk of radius 0.500 m and mass 115 kg-is freely rotating at 50.0…

A:

Q: Treat the upper limb as one segment with a centre of mass (d2) 36.0 cm from the shoulder joint. The…

A: The objective of this question is to determine the vertical component of the force created by the…

Q: A car traveling on a flat (unbanked), circular track accelerates uniformly from rest with a…

A: Recall there are two acceleration tangential and radial. So net acceleration is neither along…

Q: d Ꮎ 2. A uniform ladder of mass 25.0 kg and length 10.0 m leans against a frictionless wall at an…

A:

Q: Create a FBD for segment 1 that is attached to the lower end of the cord. Assume, for the moment,…

A:

Q: While installing new spark plugs in your car, the manual specifies they be tightened to 43 Nm. If…

A: Given data:  Torque (τ) = 43 N.m Distance (r) = 22 cm = 0.22 m Angle (θ) = 62° Required: The…

Q: Problem 3:   A rod of negligible mass is attached to a vertical beam by a hinge at point A and a…

A: Problem 3:  Part (c) Given the values are T = 257.4N, L = 2.81 m, and θ = 20.2°The magnitude of the…

Q: In the figure, a nonuniform bar is suspended at rest in a horizontal position by two massless cords…

A:

Q: A diver of weight 580 N stands at the end of a diving board of length L= 4.3 m and negligible mass…

A:

Q: There is this ladder with a length L = 3.5 m and mass M = 15 kg leans against a smooth vertical…

A: Given data: Length of ladder is, L=3.5 m. Mass of ladder is, M=15 kg. Coefficient of friction…

Q: When a gymnast weighing 740 N executes the iron cross as in figure (a), the primary muscles involved…

A: Let the total force on arm is given  by Fm. Let the half weight of the gymnast is given by whalf.…

Q: A scaffold of mass 47 kg and length 5.0 m is supported in a horizontal position by a vertical cable…

A: Given:- A  mass m1 = 47 kg   length L = 5.0 m is supported in a horizontal position by a vertical…