Answered: 16. A load of 1kW operates at 0.85…

16. A load of 1kW operates at 0.85 power factor lagging when connected to a 240Vpk, 50 Hz supply. Find the (a) current in the load, (b) pf angle, (c) impedance of the circuit, (d) reactive power.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: What are the typical power quality issues in the power system? What are the methods to mitigate…

A: The typical power quality issues in the power system are: Over voltage: Over voltage power increase…

Q: Rooftop PV PV module DC bus HZ DC/DC converter We want to build a DC-DC converter for the system…

Q: A 3 HWCR has a supply of 110V / phase. Find out the value of mean voltage for a delay angle of 150°…

Q: 5. The CT of problem 4 is utilized in conjunction with a current sensitive device that will operate…

A: 5. It is given that: CT fault current=I=1200 ASecondary leakage impedance=0.1+j0.5 ΩImpedance of the…

Q: 22. J12 J92 Q.11: For the coupled circuit shown if Vs=10020°V: 1. Compute the complex value of…

Q: 6. The input voltage to the single-phase to single-phase cycloconverter is 120V(rms), 60Hz.The load…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: TWO transformers A and B are connected in parallel to a load of (2+j1.5) ohm. Their impedances in…

Q: A 1200kVA, 6600V, 3-phase Y-connected alternator has an effective resistance of 0.40 ohm and a…

Q: A single phase full wave AC voltage controller has a resistive load of 5 ohms and an input voltage…

A: The resistive load, The supply voltage, The delay angle is 90 degrees,The output voltage,

Q: Why the frequency will double when we rectify an ac input to dc output at the ripple factor ?

A: Ripple factor measures the amount of ripple content present in the waveform rectifier is a circuit…

Q: 43. A series circuit consisting of a 50-ohm resistor, 0.5-henry inductor and a 100-microfarad…

A: In this question, RLC are connected in the series. Apperent power S= VI* We know S= P+jQ Where Q…

Q: A Cock-eroft Walton type voltage maltiplier has 7 atagea with capacitance tranaformer secondary…

A: COCKROFT-WALTON VOLTAGE MULTIPLIER: The Cockcroft–Walton (CW) generator is an electric circuit that…

Q: a) For the 2-Bus AC system given in Figure (a) find V1 (amplitude and angle). All the values are…

A: multiple questions As per our guidlines we are supposed to do the first question if a student asks…

Q: How does reactive power compensation improve the efficiency of power transmission

A: Efficiency will be depends on output power. Generally output power means useful power. So useful…

Q: A 30 alternator with grounded neutral has a reactance of 30. It is connected to bus bar through a…

A: Given- 3-phase alternator with grounded neutral- Reactance- XL=3 Ω, Capacitance =0.001 μF per phase,…

Q: Is it possible to measure the phase-shift angle in an AC single-phase circuit by an indirect method…

A: The electrical circuits have resistance, inductance and capacitance as their elements. In the…

Q: Define the concept of "harmonic distortion" in power systems. What are the sources of harmonics, and…

A: Harmonic distortion refers to the presence of additional frequency components, known as harmonics,…

Q: 150 kVA, 2800-240 V, 50 Hz transformer. Reqis = 0.0082N , Xeq.Ls = 0.02230 Step down transformer…

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.

Q: QUESTION ONE (a) A 3-phase full converter is used for charging a battery with an emf of 110 V and an…

A: Sol(a)-:

Q: Complete the blank In AC-DC power transmission system,…

Q: Explain the principle to generate the high AC voltage generation by using resonant transformer with…

A: The principle to generate the high AC voltage is as follows: - A transformer comprises of two…

Q: High-voltage transmission with lower power losses is possible with A. alternating current B. cross…

A: Given: High voltage transmission

Q: 8. A 3-phase, star connected alternator is rated 500 KVA, 1.1 KV. Its effective resistance/phase and…

Q: Design a CT-FWR to supply a load of (50N) with a waveform of the following specifications: - • Vdc =…

A: In the question, Design a CT-FWR load resistance RL =50 ohmVC = 12 V Ripple factor = 0.1% main…

Q: Q 4/ A 3000 kVA, 3-phase, star-connected, 50 Hz, 2800 V alternator has resistance 0.120. A field…

Q: A 1,5 MVA, 3.3 kV, 40 pole, three-phase sta connected asytnchronous alternator has reactance of Xd =…

A: Alternator: Electrical Generator is an energy conversion device which converts mechanical energy to…

Q: A generating station has a maximum demand of 20MW,a load factor of 60%, a plant capacity factor of…

Q: Two loads are connected to your standard AC power outlet (110v, 60H2). The first load has a 60%…

Q: Power in a three phase delta system

Q: In a semiconductor crystal, the atoms are held together by O Forces of repulsion O lonic bonds O…

A: In the semiconductor crystal, The atoms are together by sharing the electron pairs. And The bond…

Q: b) What is reactive power compensation Explain how reactive power compensation is made and its…

A: Reactive power compensation is the method which is used to improve the performance of AC circuits.…

Q: How do the capacitor and inductor support the circuit in power factor improvement?

A: Capacitors and inductors are commonly used in electrical circuits to improve the power factor, which…

Q: A 1500KVA, 8KV, three-phase wye-connected alternator has an effective resistance of 0.502 and a…

Q: 400 A. d.) The impedance of the terminating device is 14.9 + j 1.5 ohms and the primary CT fault…

A: Given

Q: According to NEC , what is the definition of a trained electrician?

A: The NEC stands for National Electrical Code and it provides some basic standards that must be…

Q: Low lagging power factor results in large voltage drop which results in poor.......... .…

A: we need to find the fill in the blank stated that ,Low lagging power factor results in large voltage…

Q: Explain the concept of FACTS (Flexible Alternating Current Transmission Systems) devices. How do…

A: Flexible Alternating Current Transmission Systems (FACTS) devices are a family of advanced power…

Q: A synchronous generator has been synchronized to an infinite grid of 13.8 kV and 60 Hz. The…

Q: An ac controller has a resistive load of R 10 2 and the input is 220 V, 50 Hz. The thyristors switch…

A: There are several types of power electronics converter we use in electrical engineering, such as:…

Question

16. A load of 1kW operates at 0.85 power
factor lagging when connected to a 240Vpk,
50 Hz supply. Find the (a) current in the load,
(b) pf angle, (c) impedance of the circuit, (d)
reactive power.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Problem 2 The circuit diagram of a certain load is presented below. Determine the following: a. The power factor of the load. b. If the load is connected across a 400 Vrms source, determine the real and reactive power consumed by the load. c. From (b), determine the value of the capacitor to be placed in parallel with the load in order to improve the power factor of the load to 95% lagging. From (b), A synchronous motor is installed in parallel with the load to correct the pf. The motor is rated 5 hp operating at 60% efficiency. Assuming that the motor is running at rated power. Determine the apparent power and power factor of the motor in order to improve the load's pf to 95% lagging. 202 500 µF HI + VL -20 mH 5Ω >0.5VL m 15 mH
Design a CT-FWR to supply a load of (502) with a waveform of the following specifications: - • Vdc = 12 V • Ripple factor = 0.1 % • the main power supply is (220 Vrms, 50 Hz). Determine the following values: - 1- The value of capacitor filter. 2- The maximum load voltage (VmR) 3- The transformer turns ratio (a). 4- The RMS value of the load voltage. 5- Draw the output waveform. (assume ideal diodes)
design 800v to 14.5v isolated bi-directional dcdc conveter a. choose the converter type with reason b. design each components with safety margin 30% (equations) c. calculate the efficiency (equations)
I have answer 1,2 and 3 Need 4 and 5
The three-phase full-wave converter shown below is used to rectify the three phase (Y-connection) source signals. The six Thyristor are triggered in the sequence shown. Sketch for firing angle (a=90°) the output voltage (Vo), the phase current, the current for any two Thyristor in any one leg, and the load current (Ia). Then calculate (a) Thyristor average and r.m.s current. (b) Supply average and r.m.s current. (c) The normalized average output voltage. (d) The maximum output voltage. [Vdc = [1 - cos(60+ a)] Vml T If the line-to-neutral voltages are defined as 11 T, T T STA T. Load I sin od sin() ex-> Solve the question sin(with your own hands the corresponding line-to-line voltages are √31% sin (out + ) ---√(4)
What is the average power in ghe single phase ac circuit with the purely resistive load? It is sinusoidal steady state excitation.
A 3Ø, Y-connected alternator is rated at 1,600KVA, 13.5KV. The armature effective AC resistance per phase is 1.5Ω. The percentage regulation for a load of 1,280kW at unity power factor is 3.5%. Determine:(a) synchronous reactance of the alternator(b) %VR at full-load 0.8pf leading(c) What is the effect on %VR value if taken at half-load lagging pf? Justify andexplain briefly your answer on one(1) sentence.
I need the answer quickly
Describe real and reactive power regulation
which Q5: Estimate the synchronous impedance for an 11 kV, three-phase, 50 Hz, 20 MVA alternator develops rated emf on no-load with a field current of 20 A. A field current of 12 A produces a short circuit current equal to rated current.
Explain the concept of power quality and the various disturbances that can affect it, such as harmonics and transients.
4) A single-phase full-wave AC voltage controller consists of two SCRs connected in invers-parallel. The supply voltage is 220V at 50Hz. The controller is used to control heater element of 2500W in an electric oven. The trigger angle is 30o. i) Draw the circuit diagram ii) sketch compatible waveforms for the supply, load and SCR voltages. iii) calculate the rms value of the load voltage and current. iv) Determine the input power factor of the circuit. v) Calculate the average value of the SCR current.