14 11. In the drawing to the right, fill in gas particles to represent Henry's Law. P.-P212. Write the equation for Henry's Law.13. If the pressure in a closed system increases, the solubility of a gas14. The solubility of methane in water at 20°C and 1.00 atm pressure is0.026 g/L. If the temperature remains constant, what will be the solubility of this gas at the following3₁pressures5₂=2J,P₂byP₁A³₂0.60 atmB) ₁₂1.80 atm

Answered: Image /qna-images/answer/0d7b41be-6db3-4607-bf8c-81ae6c78b562.jpg

14. The solubility of methane in water at 20°C and 1.00 atm pressure is 0.026 g/L. If the temperature remains constant, what will be the solubility of this gas at the following O pressures P. A) ³₂ 5₂=2 B) ₁ J,P₂ by P₁ 0.60 atm 1.80 atm

14. The solubility of methane in water at 20°C and 1.00 atm pressure is 0.026 g/L. If the temperature remains constant, what will be the solubility of this gas at the following O pressures P. A) ³₂ 5₂=2 B) ₁ J,P₂ by P₁ 0.60 atm 1.80 atm

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter13: The Chemistry Of Solutes And Solutions

Section: Chapter Questions

Problem 27QRT: Refer to Figure 13.10 ( Sec. 13-4b) to answer these questions. (a) Does a saturated solution occur...

See similar textbooks

Similar questions

A sample of water contains 0.010 ppm lead ions, Pb2+. (a) Calculate the mass of lead ions per liter in this solution.(Assume the density of the water solution is 1.0 g/mL.) (b) Calculate the mass fraction of lead in ppb.
Some lithium chloride, LiCl, is dissolved in 100 mL of water in one beaker, and some Li2SO4 is dissolved in 100 mL of water in another beaker. Both are at 10 C, and both are saturated solutions; some solid remains undissolved in each beaker. Describe what you would observe as the temperature is raised. The following data are available to you from a handbook of chemistry:
Simple acids such as formic acid, HCOOH, and acetic acid, CH3COOH, are very soluble in water; however, fatty acids such as stearic acid, CH3(CH2)16COOH, and palmitic acid, CH3(CH2)14COOH, are water-insoluble. Based on what you know about the solubility of alcohols, explain the solubility of these organic acids.
For each of the following pairs of solutions, select the solution for which solute solubility is greatest. a. Ammonia gas in water with P = 1 atm and T = 50C Ammonia gas in water with P = 1 atm and T = 90C b. Carbon dioxide gas in water with P = 2 atm and T = 50C Carbon dioxide gas in water with P = 1 atm and T = 50C c. Table salt in water with P = 1 atm and T = 60C Table salt in water with P = 1 atm and T = 50C d. Table sugar in water with P = 2 atm and T = 40C Table sugar in water with P = 1 atm and T = 70C
The solubility of ammonium formate, NH4CHO2, in 100. g of water is 102 g at 0 C and 546 g at 80 C. A solution is prepared by dissolving NH4CHO2 in 200. g of water until no more will dissolve at 80 C. The solution is then cooled to 0 C. What mass of NH4CHO2 precipitates? (Assume that no water evaporates and that the solution is not supersaturated.)
Refer to Figure 13.10 ( Sec. 13-4b) to answer these questions. (a) Does a saturated solution occur when 65.0 g LiCl is present in 100 g H2O at 40 C? Explain your answer. (b) Consider a solution that contains 95.0 g LiCl in 100 g H2O at 40 C. Is the solution unsaturated, saturated, or supersaturated? Explain your answer. (c) Consider a solution that contains 50. g Li2SO4 in 200. g H2O at 50 C. Is this solution unsaturated, saturated, or supersaturated? Explain your answer. Figure 13.10 Solubility of ionic compounds versus temperature.
Maple syrup sap is 3% sugar (sucrose) and 97% water bymass. Maple syrup is produced by heating the sap toevaporate a certain amount of the water. (a) Describe what happens to the composition and boilingpoint of the solution as evaporation takes place. (b) A rule of thumb among maple syrup producers is thatthe finished syrup should boil about 4 C higher than theoriginal sap being boiled. Explain the chemistry behindthis guideline. (c) If the finished product boils 4 C higher than the originalsap, calculate the concentration of sugar in the finalproduct. Assume that sugar is the only solute and theoperation is done at 1 atm pressure.
Fluoridation of city water supplies has been practiced in the United States for several decades. It is done by continuously adding sodium fluoride to water as it comes from a reservoir. Assume you live in a medium-sized city of 150,000 people and that 660 L (170 gal) of water is used per person per day. What mass of sodium fluoride (in kilograms) must be added to the water supply each year (365 days) to have the required fluoride concentration of 1 ppm (part per million)that is, 1 kilogram of fluoride per 1 million kilograms of water? (Sodium fluoride is 45.0% fluoride, and water has a density of 1.00 g/cm3.)
For each of the following pairs of solutions, select the solution for which solute solubility is greatest. a. Oxygen gas in water with P = 1 atm and T = 10C Oxygen gas in water with P = 1 atm and T = 20C b. Nitrogen gas in water with P = 2 atm and T = 50C Nitrogen gas in water with P = 1 atm and T = 70C c. Table salt in water with P = 1 atm and T = 40C Table salt in water with P = 1 atm and T = 70C d. Table sugar in water with P = 3 atm and T = 30C Table sugar in water with P = 1 atm and T = 80C
A sample of potassium aluminum sulfate 12-hydrate. KAl(SO4)212H2O, containing 101.5 mg is dissolved in 1.000 L of solution Calculate the following for the solution: a The molarity of KAl(SO4)2. b The molarity of SO42. c The molality of KAl(SO4)2, assuming that the density of the solution is 1.00 g/mL
. Why does the amount of excess solid solute present in a solution not affect the amount of solute that ultimately dissolves in a given amount of solvent?
The freezing point of a 0.21 m aqueous solution of H2SO4 is -0.796C. (a) What is i? (b) Is the solution made up primarily of (i) H2SO4 molecules only? (ii) H+ and HSO4- ions? (iii) 2H+ and 1SO42- ions?