13) Consider the system H(z) = Ha(2)Hm(2) Determine: a) Ha(z) b) Hm(2) = (1-2-1)(1–32-1)(1-2:-1) (1–1/22-)(1-1/5z-)

Q: A system has two poles located at (-2+ j3) and (-2 - j3) and a third pole located on the real axis…

A:

Q: [7] AC potential e = Esinot was applied to a capacitor (capacitance: C), and the output AC current…

A: It is given that: e=EsinωtE˙=-Ee-jπ2=-E-j=jE

Q: Perporm the in dicated apera tions. 3) BB14 + 613.812= 12

A: To add two number of different bases first convert them into common base most preferably decimal…

Q: So when expanding brackets j6 * (-j6) is 36

A: j6 * (-j6) is 36?That particular step we will see again,

Q: Discussion 2. Chapter 4 Second Order Systems, the Underdamped case. Study the following pole plot…

A: Pole location of the second-order underdamped system   To determine: The imaginary part of pole…

Q: Simplify the expression ln(e6+3) + 4 ln(e5x+6). Expand brackets and gather like terms in your…

A: To simplify the expression: ln(e6x+3)+4ln(e5x+3).

Q: QUESTION 2 a) Figure 3 shows some parts of a power supply circuit. Assume that the diodes D1- D4 are…

A: The solution is given below

Q: 5. How many poles are in the right half-plane for the open-loop system of Figure P6.1? [Section:…

A: The open loop system is,

Q: to find using the patie Xcn) for l fraction me the d for 1z1> + 2 2? (Z-0-5)?(Z+

A:

Q: In the transverse electromagnetic TEM mode....... ********** Ez = 0, Hz #0 Ez #0, Hz = 0 Ez = 0,…

A: We need to select correct option for TEM mode .

Q: ToR ths Given CircuiT Finro 2,(t

A:

Q: If the measurement deviations D are calculated for all measurements then the curve of deviation…

A: The curve of deviation frequency F (D) plotted against deviation magnitude D is a Gaussian curve…

Q: A) Fill all the blanks : 1-If I= -5 sin (ot+20") in time domain then current equal ----- in phasor…

A: Given,

Q: Question 2: The temperature of an object changes with time and this change is in simple harmonic…

A:

Q: Please solve question

A: In this question , we will write about resistor ,inductor and capacitor phase difference..

Q: (iv) When doping a semiconductor n type, the bandgap of the material will: Increase Decrease /…

A: Due to the doping , Fermi level will shift towards the conduction band .

Q: What is the general form of the response of H(z) = excited by a step sequence? z² + 2z+1 (z −…

A: The above question is based on the response of a system in the z-domain.

Q: Q1 Minimize the following minterms using K-MAP Y= m (0, 2, 5, 6, 7, 8, 10, 13, 15 )

A:

Q: 1. – 4.) Sketch the positive root locus of the system shown below with the following choices of…

A: As per our guidelines, we are supposed to answer only one question. Kindly repost the other…

Q: Suppose we are building a radio receiver with an R-L-C circuit. We would like to receive radio…

A: The receiver should accept the signal of frequency 1 MHz without any attenuation or disturbance but…

Q: Using the partial fraction method to find x(n) for

A: The z-transform of a signal is given in the question. The inverse z-transform has to be calculated.…

Q: Ex; Find ecaT) if ECz) is giveri by 10 Z (Z-1) ( Z -2) E(Z) =

A: Here i have applied the properties of z transform.

Q: Find thevenin impedance across XY.

A: Given circuit is - Given values are - Z1=10∠-60oZ2=10∠60oZ3=50∠53.13o

Q: C1 L1 R1 V1 Vout V1 contains the fundamental and its harmonics (fo, 2fo, 3fo, ...). The amplitude of…

A: The circuit diagram is: V1 contains harmonics and the amplitude of the harmonics is inversely…

Q: In a DC motor with separately excited configuration, EMF voltage=10xrotational speed of the rotor…

A: Given DC motor withEMF,E=10ωArmature resistance Ra=5 ΩInductance La=200 mHIa-armature…

Q: QUESTION 4 Consider the complex numberd defined below Z₁ = 1-j Convert Z₁ to polar form and specify…

A: The given complex number is Z1=1-j. We need to convert Z1 to polar form and need to find its…

Q: If Re = 2 and Im = -5, What is the complex number in: rectangular, trigonometric, polar and…

A: In this we will find complex number different forms...

Q: Determine howmany closed-looppoles lie in the right half-plane, in the left half-plane, and on the…

A:

Q: 9) Sketch the |H (w)| corresponding the pole -zero pattern in given figure below. Im(z) 0.4 3 Re(2)…

A: Given: A pole-zero pattern on Z-plane.

Q: Write the mathematical equation for the given mechanical rotational system and determine the…

A: Given:

Q: 1. Consider reading the voltage across the capacitor in the drawn circuit'. Here the voltage vc…

A: To solve above problem, one should have basic idea about working of AC circuits. Above given circuit…

Q: Q5: Find the Z of the following 8z - 19 a) F(z) = (z- 2)(z- 3) -2r + 5z b) F(2) = - (z - 3)(z – 1)2…

A: As per our policy, i am attempting first three parts, a) Given signal,…

Rectangular Coordinate System

In a rectangular coordinate system, each point based on the pair of coordinates is specified uniquely in the plane. From two fixed perpendicular lines, these coordinates are at a distance in the rectangular coordinate system. Each line is known as the reference axis and axes as plural. The point where they meet is called the origin (0,0).